Gravitational collapse and equilibrium conditions of a toroidal vortex with thermal pressure

We found the equilibrium conditions for a self-gravitating toroidal vortex by taking thermal pressure into account. These conditions are shown to significantly differ from those for a disk or a sphere. The evolution of a thin vortex turns it into a compact vortex that loses mechanical stability for low masses at a polytropic index γ<4/3 but retains stability for sufficiently high masses and densities determined by the velocity circulation in the vortex.     

澳门附近海域沉积物污染状况及特征分析

掌握澳门附近海域沉积物的污染状况及特征,对于合理安排澳门海洋海岸工程疏浚泥的海洋倾倒,防止造成海洋污染有十分重要的意义。根据1997—1999年连续三年对澳门附近主要区域的海洋沉积物采样测定结果,通过分析认为澳门附近海域沉积物污染具有下列特征:1)沉积物中重金属和油类含量普遍较高,除了总Hg外均高于珠江口海区的其他港口;2)沉积物中污染物的分布受人类活动的影响明显,澳门内港受船只排污、码头作业、陆地工业和生活污水排放的影响,是澳门附近海域沉积物污染最为严重区域;3)受水质交换的影响明显,澳门外港、路环岛东北等区域受珠江径流影响水质交换较快,沉积物中污染物的含量较低,而内港由于水质交换较差,沉积物中污染物的含量相对较高;4)与沉积物的成分组成(吸附)有关,大部分污染物与沉积物中粉砂有较好的相关性,表明粉砂对污染物质有较广泛性的吸附能力,尤其是Cu、Zn、Cd、油类、有机质。     

实验条件对X射线衍射物相定量分析结果的影响

通过实验验证了多物相试样X射线衍射定量分析的基体效应,着重研究了参比强度K值、衍射强度、混合物各物相粒度、X射线管功率等实验条件对物相定量分析结果的影响。结果表明,物相定性分析是定量分析的前提,采用积分强度、使各物相颗粒尽可能细而且均匀、采用较高的X射线管功率以及适合的扫描速率均有利于提高物相X射线衍射定量分析的准确度。     

Experimental solidification of anhydrous latitic and trachytic melts at different cooling rates: The role of nucleation kinetics

Two sets of cooling experiments were run at atmospheric conditions for two anhydrous starting latitic and trachytic melts: 1) five cooling rates (25, 12.5, 3, 0.5, and 0.125 °C/min) between 1300° and 800 °C, and 2) a 0.5 °C/min cooling rate from 1300 °C with quench temperatures at 1200°, 1100°, 1000° and 900 °C. Trachytic run-products are invariably glassy. Nucleation is also suppressed in the latitic run-products at the three highest cooling rates. Conversely, in the 0.5 and 0.125 °C/min runs, latites have a crystal content of  90 vol.%. The phases are: plagioclase, clinopyroxene, glass and iron-bearing oxide (in order of abundance). The variable quench temperatures, investigated by coupling experiments with Pt wire and Pt capsule sample containers in set 2, again did not produce crystallization of trachyte, whereas latitic samples are characterized by  10 vol.% of oxides, pyroxenes and plagioclase (in order of appearance), at temperature < 1000 °C. Effects of (preferential) heterogeneous nucleation on sample holders, of superheating degree, and chemical species loss during cooling are absent for both melt compositions. The difference of solidification paths between these two silicate melts can be ascribed only to their small chemical differences. In comparison with calculated equilibrium conditions all the experimental latitic and trachytic run-products revealed strong kinetic effects, interpretable in the light of the nucleation theory. The glass-forming ability (GFA) of trachyte is higher, whereas their critical cooling rate (Rc) is lower (< 0.125 °C/min), in comparison to latitic melts (Rc > 0.5 °C/min). The experimental results carried out in this study can be applied to lava flows and domes; trachytic lavas are able to flow for longer period with respect to latitic ones in a metastable condition. Glass-rich terrestrial lavas, i.e. obsidians, can be the result of sluggish nucleation kinetics due to the relative high polymerisation of evolved silicate melts.     

Dynamic analysis of a vertical plate exposed to breaking wave impact

From the experimental studies in recent years, it has become known that when a wave breaks directly on a vertical faced coastal structure, high magnitude impact pressures are produced. The theoretical and experimental studies show that the dynamic response of such structures under wave impact loading is closely dependent on the magnitude and duration of the load history. The dynamic analysis and design of a coastal structure can be succeeded provided the design load history for the wave impact is available. Since these types of data are very scarce, it is much more convenient to follow a method which is based on static analysis for the dynamic design procedure. Therefore, to facilitate the dynamic design of a vertical plate that is exposed to breaking wave impact, a multiplication factor called “dynamic magnification factor” is herein presented which is defined as the ratio of the maximum value of the dynamic response to that found by static analysis. The computational results of the present study show that the dynamic magnification factor is a useful ratio to transfer the results of static analysis to the dynamic design of a coastal plate for the maximum impact pressure conditions of p_max/γH₀≤18.     

水动力条件差异导致潮坪分形特征变化实例研究

研究区位于1964～1976年黄河由刁口流路入海时形成的三角洲潮坪.为进行石油开采在潮坪上构筑的交通设施对波浪形成了良好的屏障,水动力条件具有显著差异的屏障两侧潮坪是研究潮坪特征对水动力条件响应的天然实验场所.在屏障两侧各选择一典型区,实测地貌形态,取样品进行粒度成分分析,根据实测资料分析确定潮坪分形特征.发现水动力环境的强弱决定着潮坪的形貌、沉积物粒度分维值的变化规律.水动力环境强的一侧潮坪滩面分维值高,且随着初始计算网格宽度增大迅速降维;表层沉积物粒度分维值小,且离散性大.相反,在另一侧潮坪滩面分维值低,且随着初始计算网格宽度增大分维值无显著变化;表层沉积物粒度分维值高,且具有较好的一致性.当初始计算网格宽度增大到某个值时,两侧潮坪形貌分维值渐趋一致.在屏障两侧各沿一条与屏障大角度相交的测线取样,并各选择一点采取不同深度的样品做分析计算,发现在水动力条件弱的一侧,样品的粒度分维值表现为远离屏障逐步降维、随深度增加分维值增大的规律;相反一侧粒度分维值变化的规律性很不明显.讨论了水动力环境对潮坪分形特征影响机理.     

波浪作用下岸坡和海底平衡条件的研究

提出波浪作用下岸坡和海底动态和静态平衡条件的数学模型。在已建立的推移质泥沙体积输沙率基本关系式的基础上,根据连续方程,计算出底坡、泥沙、波浪三要素在动态和静态平衡情况下的关系式,得出反映这种关系的底坡平衡函数曲线图。用实际资料对这一函数曲线进行了验证,并对实际资料相对模型的某些差异作出解释。     

Bacterial sulphate reduction in sediments of a european salt marsh: Acid-volatile and tin-reducible products

The products of ³⁵S-sulphate reduction by sedimentary bacteria were measured at two sites in a salt marsh on the east coast of England. Non-acid-volatile products were measured, after acid-volatile sulphide was removed, by their reduction to sulphide by digestion with tin. The proportion of the sulphate reduced to tin-reducible products varied between 25% in a salt marsh pan and 61% in creek sediment, over a 0–25 cm depth profile. There were also variations with depth at each site in the proportions of sulphate reduced to tin-reducible products. Further examination revealed differences in the proportions of sulphate which were reduced to free sulphide, acid-volatile sulphide, sulphur or pyrite at the two sites. The data suggest that previous work which did not measure non-acid-volatile products underestimated sulphate reduction rates by three-fold in the creek site, but by only one third in the pan.     

东营凹陷王家岗地区王古1潜山构造特征及油气成藏条件

进一步了解王古1潜山的构造特征及成藏条件,利用渤海湾盆地济阳坳陷东营凹陷王家岗地区的大量三维地震剖面和一些钻井资料,并结合东营凹陷南坡缓坡带区域构造背景及成藏条件分析认为,王古1潜山初始发育于印支期,后经燕山期拉张断陷,切割为断块并抬升,最后于燕山期定型,为典型的缓坡盆倾残丘潜山。该潜山被NW向和NE向断裂切割,潜山高部位侵蚀风化严重,上覆孔店组盖层及沙河街组烃源岩,油气通过断层和不整合面运移至潜山顶部形成侵蚀残丘型油气藏。