Is Ziarat a Potential Site for Conventional or Unconventional Energy Resources?

A structural interpretation of the Ziarat block in the Balochistan region (a part of the Suleiman Fold and Thrust Belt) has been carried out using seismic and seismological data. Seismic data consists of nine 2.5D pre‐stack migrated seismic lines, whereas the seismological data covers the Fault Plane Solution and source parameters. Structural interpretation describes two broad fault sets of fore and back thrusts in the study area that have resulted in the development of pop‐up structures, accountable for the structural traps and seismicity pattern in terms of seismic hazard. Seismic interpretation includes time and depth contour maps of the Dungan Formation and Ranikot group, while seismological interpretation includes Fault Plane Solution, that is correlated with a geological and structural map of the area for the interpretation of the nature of the subsurface faults. Principal stresses are also estimated for the Ranikot group and Dungan Formation. In order to calculate anisotropic elastic properties, the parameters of the rock strength of the formations are first determined from seismic data, along with the dominant stresses (vertical, minimum horizontal, and maximum horizontal). The differential ratio of the maximum and minimum horizontal stresses is obtained to indicate optimal zones for hydraulic fracturing, and to assess the potential for geothermal energy reservoir prospect generation. The stress maps indicate high values towards the deeper part of the horizon, and low towards the shallower part, attributed to the lithological and structural variation in the area. Outcomes of structural interpretation indicate a good correlation of structure and tectonics from both seismological and seismic methods.     

Effect of heat treatment on dynamic properties of selected rock types taken from the Salt Range in Pakistan

Temperature is one of the variables that influence the elasto-plastic behavior and integrity of rock outcrops. Fluctuations in temperature can trigger alteration of some of the mineral properties and impact the brittle-plastic transition. Initiation and propagation of thermally induced tension cracks tend to weaken most rock types. The principal goal of this study was to anticipate impacts of thermal stress-strain cycles on the dynamic response of representative rock units exposed in the Khewra Gorge of the Salt Range Punjab of Pakistan. Ten types of sedimentary rock units were sampled, including marl, dolomite, three types of limestone, and five different sandstones exhibiting varying characteristics in outcrop. Boulder specimens were collected from the field and transported to the laboratory to prepare 50 drill cores that could be subjected to thermal cycling between 50 and 200 °C in increments of 50 °C. Room temperature core samples were tested using an Erudite resonance frequency meter to measure their Q-factors and the resonance frequency (F_r) at an applied loading frequency of 7 KHz with 0.01 V output voltage. Results suggest that thermal cycling tends to reduce the dynamic Young’s modulus (E_d) and Q-factor. Other parameters, such as damping ratio (ξ), specific damping capacity (Ψ), and loss factor (?) appeared to increase with increasing temperature cycles, likely as a result of developing thermally induced tensile fractures. The resultant values of the null hypothesis (t-critical and t-stats) suggests that the null hypothesis can be discarded because there was no observable difference between the measured and expected values for the cores tested. The observations and data emanating from this study might be useful in designing low-level radioactive waste landfills, nuclear waste repositories, and deep underground excavations where the increased temperature could alter the mechanical behavior of the parent rock mass.     

对重力势二阶垂直偏导数的一种新的取样方法

从目前的研究来看，二阶垂直导数（X和Y两个方向）的求解方法较简单，它采用的五个因子的数字滤波的最小二乘法来优化数据。但是在较小区域面积时（对工程和环境应用中的重力数据），重力异常很容易放大和被区域重力场掩盖，我们认为产生的缘由是表示重力场的x和y方向上的二次多项式引起的。因此，为了逼近重力水平方向的偏导可以设计一个好的滤波器来拟合在xy平面的重力场值，再得出想要的重力垂直方向偏导，文中最后对提出的方法在前人经典模型上和野外实践进行了验证。     

Updated earthquake catalogue for seismic hazard analysis in Pakistan

A reliable and homogenized earthquake catalogue is essential for seismic hazard assessment in any area. This article describes the compilation and processing of an updated earthquake catalogue for Pakistan. The earthquake catalogue compiled in this study for the region (quadrangle bounded by the geographical limits 40–83° N and 20–40° E) includes 36,563 earthquake events, which are reported as 4.0–8.3 moment magnitude (M_W) and span from 25 AD to 2016. Relationships are developed between the moment magnitude and body, and surface wave magnitude scales to unify the catalogue in terms of magnitude M_W. The catalogue includes earthquakes from Pakistan and neighbouring countries to minimize the effects of geopolitical boundaries in seismic hazard assessment studies. Earthquakes reported by local and international agencies as well as individual catalogues are included. The proposed catalogue is further used to obtain magnitude of completeness after removal of dependent events by using four different algorithms. Finally, seismicity parameters of the seismic sources are reported, and recommendations are made for seismic hazard assessment studies in Pakistan.     

Lunar concrete: Prospects and challenges

The possibility of using concrete as a construction material at the Moon surface is considered. Dissimilarities between the Earth and the Moon and their possible effects on concrete are also emphasized. Availability of constituent materials for concrete at lunar surface is addressed. An emphasis is given to two types of materials, namely, hydraulic concrete and sulfur concrete. Hydraulic concrete necessitates the use of water and sulfur concrete makes use of molten sulfur in lieu of cement and water.     

Pre-monsoon rainfall and its variability in Bangladesh: a trend surface analysis / Chute des pluis de la pré-mousson et sa variabilité au Bangladesh: Tendance d'analyse en superficie

Abstract

Bangladesh, with its small but rich agricultural land (total area 9 million ha) and large population (80 million) is faced with an acute food crisis. The economy of Bangladesh is dependent mainly upon agriculture which, in turn, is dependent upon rainfall. An increase in crop acreage and productivity during the pre-monsoon season, March to May, offers a partial solution to the problem. The water available from the rainfall of this season could be utilized through proper planning for better agricultural uses. The present study is an attempt at an inventory of such pre-monsoon rainfall, both monthly and seasonally, and its variability over time and space. The technique employed is that of trend surface mapping.     

Facies Analysis, Sequence Stratigraphy and Diagenetic Studies of the Jurassic Carbonates of the Kohat Basin, Northwest Pakistan: Reservoir Implications

The present study deals with the depositional facies, diagenetic processes and sequence stratigraphy of the shallow marine carbonates of the Samana Suk Formation, Kohat Basin, in order to elucidate its reservoir quality. The Samana Suk Formation consists of thin to thick-bedded, oolitic, bioclastic, dolomitic and fractured limestone. Based on the integration of outcrop, petrographic and biofacies analyses, the unit is thought to have been deposited on a gentle homoclinal ramp in peritidal, lagoonal and carbonate shoal settings. Frequent variations in microfacies based sea-level curve have revealed seven Transgressive Systems Tracts (TSTs) and six Regressive Systems Tracts (RSTs). The unit has undergone various stages of diagenetic processes, including mechanical and chemical compaction, cementation, micritization, dissolution and dolomitization. The petrographic analyses show the evolution of porosity in various depositional and diagenetic phases. The fenestral porosity was mainly developed in peritidal carbonates during deposition, while the burial dissolution and diagenetic dolomitization have greatly enhanced the reservoir potential of the rock unit, as is further confirmed by the plug porosity and permeability analyses. The porosities and permeabilities were higher in shoal facies deposited in TSTs, as compared to lagoonal and peritidal facies, except for the dolomite in mudstone, deposited during RSTs. Hence good, moderate and poor reservoir potential is suggested for shoal, lagoonal and peritidal facies, respectively.     

Corundum-bearing residues produced through the evaporation of natural and synthetic hibonite

Abstract— We have produced corundum-bearing residues through the evaporation of natural and synthetic hibonite samples. The sequence of major element losses as well as volatility related trace element fractionations in these residues are similar to those previously observed in residues from the evaporation of chondritic starting material, which suggests that the processes by which these fractionations occur may be largely independent of the starting material used. However, the mineralogy of the residues does depend on the composition of the starting material and, to some extent, on the conditions under which evaporation took place. Similarly, the degree of isotopic mass fractionation observed in the residues is composition-dependent. This observation means that it may be possible to use isotopic data for several elements to constrain the compositions of precursor materials of Ca-Al-rich inclusions, which have an evaporation origin. Although corundum-bearing inclusions are known, their origins are complex and variable, and the scarcity of such inclusions indicates that melting of hibonite, with or without concomitant evaporation, must have been a rare process in the solar nebula. By evaporating mixtures of synthetic oxides of the rare earth elements, we have reproduced the patterns of Group III inclusions and some of the characteristics of ultrarefractory patterns. However, the extreme conditions required to do so indicate that refractory inclusions with these patterns probably have a condensation rather than evaporation origin.     

MIGRATION OF MIXED-MODE VSP WAVEFIELDS1

Two-dimensional VSP surveys are often conducted to provide structural illumination of the subsurface away from the borehole. The illumination is achieved through offsetting the source with respect to the downhole geophone. This inevitably gives rise to mode-conversions in both downgoing and upgoing wavefields. Migration of mixed-mode wavefields is complex because the velocity profile used for wavefield extrapolation is valid only for a particular propagation mode; the other mode always propagates at a different velocity. It is therefore advisable to separate the wave-types (P-wave and SV-wave) prior to migration. This may be achieved through wavemode filtering, a multichannel process which exploits the relation between propagation velocity, slowness of events at the recording array and particle motion. The necessary information about particle motion is available only if the VSP data are acquired with a three-component downhole geophone assembly. The wavemode filter partitions wave-types at the recording array; it provides no information about the various changes of propagation mode experienced by the energy as it travels from source to geophone. For the purpose of migration, the intermediate modes of propagation must be deduced. Much of the energy arriving at the receivers is P-wave which has followed the P-wave velocity profile from the source. It can therefore be imaged by conventional (Kirchhoff) migration. As an example of SV-wave imaging, a common mode-code is P-wave from source to reflector and SV-wave from reflector to geophone. Migration of such data calls for back-propagation of the geophone array wavefield, at SV-wave velocity, to the point in the subsurface where it is time-coincident with the forward propagated downwave, at P-wave velocity.