雾化进样石墨炉原子吸收光谱法的研究 Ⅰ.直接雾化进样装置及其性能

介绍一种自行设计和加工的直接雾化石墨炉进样装置的结构、工作原理和操作方法。该装置由微机控制与石墨炉加热程序同步工作,可以实现自动控制和自动测量。对雾化进样石墨炉分析的仪器参数和实验条件进行了研究和选择。结果表明,该装置与石墨炉结合具有自动化程度高、重现性好、样品利用率高和分析速度快等特点。     

Magnitude-frequency relationship of coastal sand delivery by a southern California stream

Coastal sand delivery by a stream in southern California is estimated based on a numerical model which stimulates unsteady flow, sediment transport, and the associated channel adjustments for a stream-delta system. An average annual sediment yield of 51,400 m³/yr is estimated for the San Dieguito River, which drains a semiarid watershed controlled by dams. Of the total sand delivery by the stream, 20.5 percent is contributed from floods greater than the 100-year flood; 17.6 percent from those between the 50- and 100-year events; 28.4 percent from those between the 25- and 50 year floods; and 33.5 percent from those smaller than the 25-year flood.     

Sedimentology of a subtidal,tide-dominated sand body in the Yellow Sea,southwest Korea

Odanam Satoe, a subtidal, tide-dominated sand body in the Yellow Sea, Korea, is linear in plan and asymmetrical in cross-section. It consists of fine- to medium-grained, well-sorted subangular sand. Bedforms consist of high-amplitude (1–2 m) sandwaves on the lower flanks of the gentler-sloping bar surface, and medium-amplitude (0.5-1 m) sandwaves on the sand body trough adjoining the steeper face, the bar crest and shallower parts of the gently sloping bar surface. Bedforms are absent on the relatively steeper bar surface, which is characterized by 2° slopes. Bedform orientation on the gentler slope is oblique by 30° to the bar crest, parallel to the sand-body crest on the crest itself, and opposite to the steeper sand-body face in the trough below the steeper slope of the bar.Bottom current velocity data show that tidal currents are semi-rotary with a flood time—velocity asymmetry over the gentler slope, and ebb time—velocity asymmetry over the steeper slope during most of the tidal cycle. Tidal-current flow parallels bar elongation over the steeper slope, whereas over the gentler slope, tidal-current flow is directed at 30° to the bar crest and changes to normal to the crest one hour prior to low tide. Bedform orientation mapped with side-scan sonar shows agreement with these flow directions.Sand dispersal around the sand body is controlled by time—velocity asymmetry and partial rotary flow directions of tidal currents. This circulation causes not only a trapezoidal mode of grain dispersal, but also westerly migration of the sand body documented from comparative bathymetric surveys in 1964 and 1980.     

A general method for calculating three-dimensional laminar and turbulent boundary layers on ship hulls

A general method for representing the flow properties in the three-dimensional boundary layers around ship hulls of arbitrary shape is described. It makes use of an efficient two-point finite-diffirence schem to solve the boundary-layer equations and includes an algebraic eddy-viscosity representaion of the Reynolds-stress ternsor. The numericzal method contains novel and desirable features and allows the calculation of flows in which the circumferential velocity component contains regions of flow reversal across the boundary layer. The inviscid pressure distribution is determined with the Douglas-Neumann method which, if necessary, can conveniently allow for the boundary-layer displacement surface. To allow its application to ships, and particularly to those with double-elliptic and flat-bottomed hulls, a non-orthogonal coordinate system has been developed and is shown to be economical, precise and comparatively easy to use. Present calculations relate to zero Froude number but they can be extended to include the effects of a water wave and local regions of flow separation which may stem from bulbous-bow geometries.     

Boundary-layer parameterizations for applied dispersion modeling over urban areas

Many applied dispersion models require the knowledge of boundary-layer parameters such as sensible heat flux,Q _H , friction velocity,u _*, and turbulent energy components, _w and _v . Formulas are suggested for calculating these parameters over a wide variety of types of ground surfaces, based on simple observations of wind speed near the ground and fractional cloud cover, and specification of constants such as roughness length, albedo, and soil moisture availability. Observations ofu _*,Q _H , _w , and _v during field experiments in St. Louis and Indianapolis are used to test the formulas for urban sites. Relative errors of about ±20% in the predictions are seen to occur whenu _*,Q _H , _w , and _v are large. However, when these quantities are small (e.g.,u _* < 0.2 m/s), the errors in the predictions are as large as the mean value of the quantity itself.In addition, it is concluded from studies of available field data and theories that the magnitude of _w is not well-known at elevations above about 100m during the late afternoon and night. Some simple parameterizations for _w . are suggested that are consistent with the observed steady decrease in ground-level concentration in the afternoon and the sudden increase in concentration that can occur a few hours after sunset due to wind shears associated with a low-level jet, for continuous plumes emitted from moderate to tall stacks.     

Application of back-propagation networks in debris flow prediction

Debris flows have caused serious loss of human lives and a lot of damage to properties in Taiwan over the past decades. Moreover, debris flows have brought massive mud causing water pollution in reservoirs and resulted in water shortage for daily life locally and affected agricultural irrigation and industrial usages seriously. A number of methods for prediction of debris flows have been studied. However, the successful prediction ratio of debris flows cannot always maintain a stable and reliable level. The objective of this study is to present a stable and reliable analytical model for occurrence predictions of debris flows. This study proposes an Artificial Neural Networks (ANN) model that was constructed by seven significant factors using back-propagation (BP) algorithm. These seven factors include (1) length of creek, (2) average slope, (3) effective watershed area, (4) shape coefficient, (5) median size of soil grain, (6) effective cumulative rainfall, and (7) effective rainfall intensity. A total of 178 potential cases of debris flows collected in eastern Taiwan were fed into the ANN model for training and testing. The average ratio of successful prediction reaching 93.82% demonstrates that the presented ANN model with seven significant factors can provide a stable and reliable result for the prediction of debris flows in hazard mitigation and guarding systems.     

Damage Survey of Water Supply Systems and Fragility Curve of PVC Water Pipelines in the Chi–Chi Taiwan Earthquake

Substantial damage to water supply systems, including water delivery pipelines, water treatment plants, reservoirs, and water storage tanks, was reported after the 1999 Chi–Chi Taiwan Earthquake. This paper first summarizes the damage survey and then presents the results of seismic fragility analysis for underground pipelines. Construction blueprints of the water delivery pipelines and repair work orders of 11 townships and cities in the disastrous area were digitized into a Geographical Information System (GIS) for analysis and assessment. With the aid of the GIS system, we found that PVC pipes made up 86% of water delivery pipelines while steel, cast iron, ductile iron, PE and others took the rest. Therefore, this paper focuses on the fragility analysis of PVC pipes. Three different methods were applied to derive the fragility relations between the PVC water pipes having nominal diameters (approximately inner diameters) greater than or equal to 65 mm and earthquake intensity parameters such as peak ground acceleration and peak ground velocity. The results were then examined with those of other countries. The discrepancy between our results and the empirical equation used by HAZUS, an earthquake loss estimation software developed by the Federal Emergency Management Agency was not significant.     

水库地震主震发生时间的预测

水利工程对水库地震的抗震设防要求事先对水为地震进行预测。预测内容包括蓄水后诱发地震的危险性（可能性、）最大震级、最大震的地占紧及不库地震对场址地震动参数的影响。除主震时间的预测外，本文第一作者都曾提出过初步的预测方法。本文认为，水库地震前震波速比异常、非线性灰色模型以及前震系列回归等方法，是预测主震时间的有前途的方法。     

Interparticle forces and displacements in granular materials

In a micromechanics framework, the main issue is the relationship between the microscale variables and the macroscale variables. These variables are used to describe either the statics or kinematics of the system. The relationships can be classified in two ways, namely, the “averaging” relationships and the “tracking” relationships. The averaging relationships express the macroscale variable as an averaging of the microscale variables; for example, the stress as a function of contact forces. The “tracking” relationships express the microscale variable as a function of the macroscale variables; for example, the contact force at a given orientation as a function of the stress. Based on fundamental premises, a unique averaging relationship exists for either the statics or the kinematics case. However, it is generally impossible to have a unique expression of the “tracking” relationship because they are generally derived with certain assumptions. In this paper, we will present expressions of the “tracking” based on three different approaches, namely, (1) energy conservation principle, (2) representation theory, and (3) indirect scheme. The assumptions used in each approach are discussed. The results are compared among the three approaches as well as that obtained from the Discrete Element Method (DEM).