深层地震勘探激发井深探讨

深层地震勘探野外资料采集的关键是在保证原始资料一定信噪比的基础上,同时兼顾分辨率,激发井深是决定资料品质的重要因素之一。通过对虚反射滤波作用分析,提出了充分利用虚反射能量设计最佳激发井深,增强下传地震波能量的采集方法。理论分析和试验资料表明,在高速层下4～7m的最佳激发岩性深度是深层勘探的理想井深。     

直升机载频率域电磁系统在我国环境和工程勘查中的应用前景

本文根据国际上采用直升机载频率域电磁系统进行环境和工程勘查的应用效果,结合我国引进的航空电磁系统的性能和特点,探讨了采用直升机载频率域电磁系统在我国进行环境和工程勘查的应用前景。     

低频泥石流特征及防治 --以四川汶川县茶园沟为例

低频泥石流指30a以上发生1次的泥石流。尽管发生频率很低，但由于自身的特征及人们认识上的原因，其造l戒的人员伤亡和财产损失却居各类泥石流之首。对低频泥石流的研究在预防和减轻泥石流灾害方面有着重要意义。文章以2003年8月9日发生在四川汶川县茶园沟的泥石流为蒯，采用形态调查法和称重法等方法确定了流量、流速及重度。分析了其物质来源及形成的自然和人为原因，探讨了低频泥石流的特征。针对低频泥石流的低频性、破坏性和隐蔽性特点，同时考虑到低频泥石流沟的防治受保护对象的重要程度及资金投入等因素的限制，提出了进行泥石流危险性分区、搞好小流域水土深持、普及泥石流防灾减灾知识及加强监测和预警预报等措施，这对减轻低频泥石流区的灾害有一定的借鉴意义。     

长江下游一次大暴雨的中尺度模拟分析

运用中尺度数值模式（MM5V3.6）对2004年6月25日长江下游地区一次大暴雨天气过程进行了数值模拟,结合天气形势和卫星云图对此次过程进行了分析.结果表明：在东北冷涡和西太平洋副热带高压两大天气尺度系统的作用下,西南低空急流的再次加强和中低层切变线共同作用是此次大暴雨过程的主要原因.螺旋度分析表明,在不均匀的强上升气流的作用下,涡旋的水平分量向垂直分量转化是此次强降水的可能机制之一.     

非地转强迫对Fitow(0114)暴雨的影响

利用非静力中尺度模式MM5对 0 114号台风Fitow从 2 0 0 1年 8月 31日 0 0时～ 9月 2日 0 0时 (UTC ,下同 )的降水过程进行了模拟研究。结果表明 ,MM5对Fitow登陆过程中暴雨落区和强度的模拟与实况比较一致。模拟结果较好地再现了暴雨的中尺度特征。正是维持少动的台风倒槽和嵌入其中的中小尺度系统相互作用造成了暴雨的发生、发展 ,而高、低空中尺度散度场的配置对暴雨有很好的指示意义。在华南台风暴雨区无论是高层还是低层 ,都存在很强的非地转作用 ,非地转涡度项对散度倾向项是重要的强迫因素 ;但非地转作用的实现与中高纬度地区有本质的区别 ,在低层非地转作用是由于强的位势场气旋涡度 (- 2  <0 )与弱的流场气旋涡度 (fζ >0 )不平衡产生的 ;而高层非地转作用是由于强的位势场反气旋涡度 (- 2  >0 )与弱的流场反气旋涡度 (fζ <0 )不平衡产生的。非地转作用是暴雨中尺度系统上升运动发展的触发机制。从动力学角度解释了用非地转 Q矢量散度场来判断暴雨落区要比用准地转 Q矢量散度场好的原因。     

上海“8.5”特大暴雨的成因和特点

利用WSR－88D多普勒雷达资料，通过分析2001年8月5日到8月6日产生于上海地区的特大暴雨过程的雷达回波特征，研究探讨这次过程的降水成因和降水特点。发现副热带高压边缘偏南气流的风速辐合、螺旋雨带中强回波短带的合并加强、风的垂直切变产生的辐合以及热带系统的高效率降水作用是这次暴雨过程的降水成因和降水特点。并提出了预报这类暴雨系统需要注意的要点：强降水回波的发生和发展加强往往和风场中的局地强辐合区相联系，利用多普勒雷达连续演变的风场资料，可及时了解辐合区的形成和演变过程，提前作出强降水可能性的预测。     

初夏一次特大暴雨的诊断分析

对新疆1996年5月28－30日一次特大暴雨过程的诊断分析，给出了暴雨产生的原因。     

Evolution of the fogwater composition in Strasbourg (France) from 1990 to 1999

The chemical composition of fogwater has been studied in the city of Strasbourg (France) from 1990 to 1999. During these years, fogwater samples have been collected and analysed for major ions and trace metals. This paper reports on the analysis of the collected dataset. The analysis revealed a significant decrease in acidity of approximately one pH unit over the course of the study. This decrease in acidity appears to be linked to a decrease in SO_2(g) and the resulting SO₄²⁻. Trace metal concentrations have also strongly decreased over the 10-year period. Pb concentrations, following the elimination of leaded gasoline, decreased by more than one order of magnitude.     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

Numerical evaluation of the damping‐solvent extraction method in the frequency domain

The damping‐solvent extraction method for the analysis of unbounded visco‐elastic media is evaluated numerically in the frequency domain in order to investigate the influence of the computational parameters—domain size, amount of artificial damping, and mesh density—on the accuracy of results. An analytical estimate of this influence is presented, and specific questions regarding the influence of the parameters on the results are answered using the analytical estimate and numerical results for two classical problems: the rigid strip and rigid disc footings on a visco‐elastic half‐space with constant hysteretic material damping. As the domain size is increased, the results become more accurate only at lower frequencies, but are essentially unaffected at higher frequencies. Choosing the domain size to ensure that the static stiffness is computed accurately leads to an unnecessarily large domain for analysis at higher frequencies. The results improve by increasing artificial damping but at a slower rate as the total (material plus artificial) damping ratio ζ_t gets closer to 0.866. However, the results do not deteriorate significantly for the larger amounts of artificial damping, suggesting that ζ_t≈0.6 is appropriate; a larger value is not likely to influence the accuracy of results. Presented results do not support the earlier suggestion that similar accuracy can be achieved by a large bounded domain with small damping or by a small domain with larger damping. Copyright © 2002 John Wiley & Sons, Ltd.