Finite element formulation and algorithms for unsaturated soils. Part II: Verification and application

The finite‐element formulation and integration algorithms developed in Part I are used to analyse a number of practical problems involving unsaturated and saturated soils. The formulation and algorithms perform well for all the cases analysed, with the robustness of the latter being largely insensitive to user‐defined parameters such as the number of coarse time steps and error control tolerances. The efficiency of the algorithms, as measured by the CPU time consumed, does not depend on the number of coarse time steps, but may be influenced by the error control tolerances. Based on the analyses presented here, typical values for the error control tolerances are suggested. It is also shown that the constitutive modelling framework presented in Part I can, by adjusting one constitutive equation and one or two material parameters, be used to simulate soils that expand or collapse upon wetting. Treating the suction as a strain variable instead of a stress variable proves to be an efficient and robust way of solving suction‐dependent plastic yielding. Moreover, the concept of the constitutive stress is a particularly convenient way of handling the transition between saturation and unsaturation. Copyright © 2003 John Wiley & Sons, Ltd.     

An observational study of coronal hole rotation over the sunspot cycle

An analysis of the rotation of coronal holes (CHs) spanning 18 years was done based on data from theCatalogue of Coronal Holes (Sanchez-Ibarra and Barraza-Paredes, 1992). A differential rotation of CHs is confirmed for the totality of CHs, but a different behavior was found when those were separated as equatorial or isolated, and polar hole extensions, such as in theCatalogue. Isolated CHs show a typical differential rotation, but polar hole extensions display two different types of behavior: a rotation rate below 40° ± 5° of heliographic latitude, increasing to the equator, and a rotation rate above the same heliographic latitude but increasing to the poles. Also discussed here is how this last result agrees with other studies that indicate the mostly rigid rotation of the corona at higher latitudes.     

Dynamical evolution of NEAs: Close encounters, secular perturbations and resonances

We discuss the main mechanisms affecting the dynamical evolution of Near-Earth Asteroids (NEAs) by analyzing the results of three numerical integrations over 1 Myr of the NEA (4179) Toutatis. In the first integration the only perturbing planet is the Earth. So the evolution is dominated by close encounters and looks like a random walk in semimajor axis and a correlated random walk in eccentricity, keeping almost constant the perihelion distance and the Tisserand invariant. In the second integration Jupiter and Saturn are present instead of the Earth, and the 3/1 (mean motion) and v ₆ (secular) resonances substantially change the eccentricity but not the semimajor axis. The third, most realistic, integration including all the three planets together shows a complex interplay of effects, with close encounters switching the orbit between different resonant states and no approximate conservation of the Tisserand invariant. This shows that simplified 3-body or 4-body models cannot be used to predict the typical evolution patterns and time scales of NEAs, and in particular that resonances provide some fast-track dynamical routes from low-eccentricity to very eccentric, planet-crossing orbits.On leave from the Department of Mathematics, University of Pisa, Via Buonarroti 2, 56127 Pisa, Italy, thanks to the G. Colombo fellowships of the European Space Agency.     

A real-time spectrum analyser with on-line definition of the confidence levels

This paper describes a real-time spectrum analyser with on-line definition of the confidence levels built at Trieste Observatory for a research program on periodical components of unknown period in optical sources. The system is realized by a photon counting photometer on-line to a computer that elaborates in real-time the data from the photometer and displays the spectrum of the source measured. The spectrum is normalized to unity mean value and the display is calibrated by the confidence levels relative to the distribution of the spectrum displayed. Some experimental data show the performance of the machine that operates in real-time at full efficiency up to 160 Hz. Work supported by Consiglio Nazionale delle Ricerche, Gruppo Nazionale di Astronomia, Settore Tecnologie Astronomiche. Trieste Observatory — Instruments and Data Processing Group (1/76).     

Permanent Scatterers for landslide investigations: outcomes from the ESA-SLAM project

Within the SLAM project (Service for Landslide Monitoring), launched in 2003 by the European Space Agency (ESA) the Permanent Scatterers (PS) technique, a multi-image interferometric approach, coupled with the interpretation of aerial-photos and optical satellite images, was carried out for landslide investigations. The PS analysis was applied at a regional scale as support for landslide inventory mapping and at local scale for the monitoring of single well-known slope movements. For the integration of the PS measurements within a landslide inventory the Arno river basin (Italy) was chosen as test site for the presence of a high number of mass movements (to date about 300 areas at high landslide risk and more than 27,000 individual landslides mapped by the institutional authorities). About 350 SAR images have been interferometrically processed by means of the PS technique, with the detection of about 600,000 PS. The use of optical images contributed spatial meaning to the point-wise information provided by the PS, making it easier to identify terrain features related to slope instability and the landslide boundaries. Here we describe the employed methodology and its impact in the updating of a preexisting landslide inventory. 6.8% of the total number of landslides were characterized by ground displacement measurements from the PS: 6.1% of already mapped landslides and 0.8% of new unstable areas detected through the PS analysis. Moreover, most of the PS are located in urban areas, showing that the proposed methodology is suitable for landslide mapping in areas with a quite high density of urbanization, but that over vegetated areas it still suffers from the limitations induced by the current space-borne SAR missions (e.g. temporal de-correlation). On the other hand, the use of InSAR for the monitoring of single slow landslides threatening built-up areas has provided satisfactory results, allowing the measurement of superficial deformations with high accuracy on the landslide sectors characterized by a good radar reflectivity and coherence.     

Sub-wavebase cross-bedded grainstones on a distally steepened carbonate ramp, Upper Miocene, Menorca, Spain

Cross‐bedded grainstones on carbonate ramps and shelves are commonly related to the locus of major wave energy absorption such as shorelines, shoals or shelf breaks. In contrast, on the Early Tortonian carbonate platform of Menorca (Balearic Islands), coarse‐grained, cross‐bedded grainstones are found at a distance from the palaeoshoreline where they were deposited below the wavebase. Excellent exposures along continuous outcrops on the sea cliffs of Menorca reveal the depositional profile and three‐dimensional distribution of the different facies belts of the Tortonian ramp depositional system. Basinward from the palaeoshoreline, fan deltas and beach deposits pass into 5‐km‐wide gently dipping bioturbated dolopackstone (inner and middle ramp), then into 12–20°‐dipping dolograinstone/rudstone clinobeds (ramp slope) and, finally, into subhorizontal fine‐grained basinal dolowackestone to dolopackstone (outer ramp). In this Miocene example, coarse‐grained grainstones exist in five different settings other than beach deposits: (1) on the middle ramp, where cross‐bedded grainstones were deposited by currents roughly parallel to the shoreline at 40–70 m estimated water depth and are interbedded with gently dipping bioturbated dolomitized packstones; (2) on the upper slope, where clinobeds are composed mostly of in situ rhodoliths and red‐algae fragments; (3) on the lower slope, as small‐scale bedforms (small three‐dimensional subaqueous dunes) migrating parallel to the slope; (4) at the transition between the lower slope and the outer ramp, where mollusc‐rich and rhodolithic rudstones and grainstones, interbedded in dolomitized laminated wackestones containing abundant planktonic foraminifera, infill slide/slump scars as upslope‐backstepping bodies (backsets); (5) at the toe of the slope, where coarse skeletal grainstones indicate bedform migration parallel to the platform margin, induced by currents at more than 150 m estimated water depth. This Late Miocene example also illustrates how changes in intrabasinal environmental conditions (nutrients and/or temperature) may produce changes in stratal patterns and facies architecture if they affect the biological system. Two depositional sequences compose the Miocene platform on Menorca, where a reef‐rimmed platform prograded onto an earlier distally steepened ramp. The transition from the ramp to the reef‐rimmed platform was effected by an increase in accommodation space caused by ecological changes, promoting a shift from a grain‐ to a framework‐producing biota.     

Ray tracing in elliptical anisotropic media using the linear traveltime interpolation (LTI) method applied to traveltime seismic tomography

The linear traveltime interpolation (LTI) method is a suitable ray‐tracing technique for modelling first‐arrival times in isotropic media. LTI is extended to elliptical anisotropic media and applied to a tomographic inversion procedure. A theoretical formulation is first derived and then LTI implementation is discussed in terms of source–receiver arrays and cell size. The method is then combined with the tomographic inversion procedure adopted. The matching of the ray tracing with inversion in elliptical anisotropic media posed a double non‐linear problem. Thus two assumptions were made: the velocity in each cell is uniform and the main directions of anisotropy are known. To take into account the geometrical characteristics of the area under investigation (depth and velocity of the weathering, and thickness of the inner media), cells of varying size were considered. No hypothesis was made on anisotropy weakness.
The algorithm was first tested on synthetic models and then applied to a field survey. On comparing the results of the synthetic models and the field survey with those obtained with a linear raypath approximation, it was found that there were fewer data misfits.     

δO of carbonate, quartz and phosphate from belemnite guards: implications for the isotopic record of old fossils and the isotopic composition of ancient seawater

Belemnite guards of Cretaceous and Jurassic age were found to contain varying amounts of quartz deposited both on the external surface and inside the rostrum. The oxygen isotopic composition of coexisting carbonate, quartz and phosphate from the same rostrum was measured according to well-established techniques. None of these compounds showed isotopic values in equilibrium with one another. Assuming δ¹⁸O values of the diagenetic water within the range of meteoric waters, the δ¹⁸O(SiO₂) yield temperatures in agreement with the apparent secondary origin of this phase. The δ¹⁸O(CO₃²⁻) range, with a certain continuity, between −10.8 and +0.97 PDB-1 with most of the intermediate values being within the range of the carbonate isotopic values of Mesozoic fossils. The most positive isotopic results obtained from phosphate are close to +23/+24‰ (V-SMOW). They can hardly be related to a secondary origin of the phosphate, or to the presence of diagenetic effects, since these results are among the most positive ever measured on phosphate. As far as we know there is no widespread diagenetic process determining an ¹⁸O enrichment of phosphate. The very low concentration of phosphate did not allow the determination of its mineralogical composition. All the available δ¹⁸O(PO₄³⁻) values from belemnite and non-belemnite fossils of marine origin of Tertiary and Mesozoic age are reported along with the newly measured belemnites. The following conclusions may be drawn from the data reported: (1) the pristine oxygen isotope composition of fossil marine organisms (either carbonate or phosphate) may easily undergo fairly large changes because of oxygen isotope exchange processes with diagenetic water; this process is apparent even in the case of geologically recent fossils; (2) the δ¹⁸O(PO₄³⁻) of belemnite rostra seems to be, at least in the case of the most positive results, in isotopic equilibrium with environmental water because of the similarity between the results from Cretaceous belemnites and the results from Cretaceous and Lower Tertiary pelecypods and fish teeth; 3) if so, the only feasible interpretation that can be suggested for the ¹⁸O enriched data is the possibility of a relatively large variation of the oxygen isotopic composition of ocean paleowater from Jurassic to recent time.