Modelling the effect of changing precipitation inputs on deep soil water utilization

Forests in the Southeastern United States are predicted to experience future changes in seasonal patterns of precipitation inputs as well as more variable precipitation events. These climate change‐induced alterations could increase drought and lower soil water availability. Drought could alter rooting patterns and increase the importance of deep roots that access subsurface water resources. To address plant response to drought in both deep rooting and soil water utilization as well as soil drainage, we utilize a throughfall reduction experiment in a loblolly pine plantation of the Southeastern United States to calibrate and validate a hydrological model. The model was accurately calibrated against field measured soil moisture data under ambient rainfall and validated using 30% throughfall reduction data. Using this model, we then tested these scenarios: (a) evenly reduced precipitation; (b) less precipitation in summer, more in winter; (c) same total amount of precipitation with less frequent but heavier storms; and (d) shallower rooting depth under the above 3 scenarios. When less precipitation was received, drainage decreased proportionally much faster than evapotranspiration implying plants will acquire water first to the detriment of drainage. When precipitation was reduced by more than 30%, plants relied on stored soil water to satisfy evapotranspiration suggesting 30% may be a threshold that if sustained over the long term would deplete plant available soil water. Under the third scenario, evapotranspiration and drainage decreased, whereas surface run‐off increased. Changes in root biomass measured before and 4 years after the throughfall reduction experiment were not detected among treatments. Model simulations, however, indicated gains in evapotranspiration with deeper roots under evenly reduced precipitation and seasonal precipitation redistribution scenarios but not when precipitation frequency was adjusted. Deep soil and deep rooting can provide an important buffer capacity when precipitation alone cannot satisfy the evapotranspirational demand of forests. How this buffering capacity will persist in the face of changing precipitation inputs, however, will depend less on seasonal redistribution than on the magnitude of reductions and changes in rainfall frequency.     

Explicit stress–strain equations for modeling frictional materials

In this paper, a comprehensive study on simulating the shearing behavior of frictional materials is performed. A set of two explicit equations, describing the relationship among the shear stress ratio and the distortional strain and the volumetric strain, are formulated independently. The equations contain three stress parameters and three strain parameters and another parameter representing the nonuniformity of stress and strain during softening. All the parameters have clear physical significance and can be determined experimentally. It is demonstrated that the proposed equations have the capacity of simulating the complicated shearing behavior of many types of frictional materials including geomaterials. The proposed equations are used to simulate the stress–strain behavior for 27 frictional materials with 98 tests. These materials include soft and stiff clays in both reconstituted and structured states, silicon sands and calcareous sands, silts, compacted fill materials, volcanic soils, decomposed granite soils, cemented soils (both artificially and naturally cemented), partially saturated soils, ballast, rocks, reinforced soils, tire chips, sugar, wheat, and rapeseed. It has been demonstrated that the proposed explicit constitutive equations have the capacity to capture accurately the shearing behavior of frictional materials both qualitatively and quantitatively. A study on model parameters has been performed.     

深水铺管船托管架疲劳分析及动态监测点选取研究

作为S型铺管作业的关键性装备,托管架长期承受着交变载荷的作用,随着海洋开发向超深水发展,结构疲劳破坏问题不容忽视。采用疲劳谱分析的方法并结合线性累积损伤理论,对托管架结构频域下的变形进行了分析,计算了正常海况下和极端海况下托管架疲劳损伤度并对疲劳寿命进行了评估。研究发现托管架在正常海况下作业符合安全要求,在极端海况下局部结构会受到破坏。并从托管架结构安全监测角度,筛选了结构疲劳分析关键点位,为监测点位的选取提供了依据。     

敦煌-格尔木铁路沿线风动力环境特征

敦煌-格尔木铁路沿线地形复杂、起沙因素多变、沙源丰富，沙害问题日益严重。目前对其风沙活动规律还未有研究，不利于防沙工作的开展。为此，通过对自北向南的5个观测点（S1、S2、S3、S4、S5）风速和风向的观测、计算和分析，利用平均风速、起沙风况及输沙势对敦格铁路沿线的风动力环境特征进行研究。结果表明：S5、S4和S3的风况对铁路风沙灾害防治意义较大。S5年平均风速、起沙风频率和输沙势最大，春季风沙活动最为强烈，且风向单一、风力强劲，风沙运动方向基本与铁路垂直，沙粒易在铁路附近堆积。S4夏季风沙活动最为强烈；S3春季风沙活动最为强烈，且风向单一，S4和S3的风沙运动方向与铁路夹角小于90°，附近沙源广阔，铁路易受风沙侵蚀，阻碍交通运营。     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Strain localization in sand: an overview of the experimental results obtained in Grenoble using stereophotogrammetry

Experimental results are presented from the extensive program of drained plane strain compression tests on sand carried out in Grenoble over the last two decades. Systematic analysis of photographs of the deforming specimen allowed for measuring deformations and determining strain fields throughout the test, that is: prior to, at, and after the onset of strain localization. The principles, details and accuracy of the procedure are described, as well as its suitability to properly depict the patterns of deformation. Findings concerning the occurrence and progression of strain localization are discussed. The issues of shear band orientation and thickness are addressed, as well as temporary and persistent complex localization patterns, and the volumetric behaviour inside a band after its formation. The influence of such variables as initial state of the sand (effective stress and relative density), specimen size and slenderness, as well as grain size, is discussed. Copyright © 2004 John Wiley & Sons, Ltd     

The characteristics of Asian dust events in Northeast Asia during the springtime from 1993 to 2004

The characteristics of Asian dust events that occurred in Northeast Asia during the springtime from 1993 to 2004 are investigated using 3-hourly SYNOP reports (World Meteorological Organization). Occurrences of blowing sand and dust storm are low in 1997 and 1999, but have increased rapidly since 2000. The maximum occurrence was recorded in 2002. Wind velocity of 6.5 m s^− 1 as a threshold wind velocity is not so exactly consistent with the occurrence of blowing sand. However, wind velocity of 14 m s^− 1 as a strong wind causing dust storm had similar tendency to those of dust storm and Dust Storm Index.Source regions of Asian dust are divided into three regions (A: dry arid, B: semi-arid, and C: cultivated), based upon the occurrence of blowing sand and dust storm. Eight meteorological stations are selected in three regions, which have frequent occurrences of blowing sand. Source regions of Asian dust that affect the Korean peninsula are gradually extending eastward. Positive anomalies of NDVI occurred in 1994, 1995, and 1998 when temperature was high and precipitation was heavy. However, the frequent occurrence of the dust phenomena is not always consistent with lots of vegetation, high temperature, and much precipitation in this study.     

超基性岩中含铜、钴块状硫化物矿床——德尔尼铜矿成因新认识

长期以来对德尔尼铜矿的成因存在着不同认识。从矿石组成和结构、构造来看,应属典型的块状硫化物矿石,矿床亦应属于含铜黄铁矿型矿床。但从其地质产状来看又与一般的黄铁矿型矿床大不相同,与一般的岩浆熔离铜镍硫化物矿床也有较多差异。这就是本矿床类型独特之处。近年来通过工作又取得一些新资料,特别是超基性岩和矿石的同位素年龄数据。本文在综合新老资料基础上,提出新看法,认为该矿床形成于上地幔,再就位于地壳浅部。其成因类型暂定为:“深部熔离—构造侵位矿床”。鉴于本矿床与一般块状硫化物矿床相比有其独特性,建议命名为“德尔尼型”。     

ELECTROCHEMICAL CORROSION BEHAVIOR OF STEEL IN THE JUNCTURE AREA OF SEA CLAY AND SAND

Corrosion behavior of steel in the juncture area of sea clay and sand was studied. The results show that galvanic corrosion occurred between steel samples buried in sea clay and sand, and that the polarity of the galvanic cell reversed after some testing later. The cause of reversing of polarity is discussed.     

石英砂扫描电镜在漓江“泥砾”成因中的应用

本文根据扫描电镜对从漓江河谷钻孔中的泥砾层取得的481粒石英砂表面形态特证研究结果:石英砂多数颗粒保持棱角状外形并遭受不同程度的磨蚀,具阶状贝壳断口,平直或弧形刮削面和多向擦痕,沿解理面破碎呈“V”字形沟和撞击碟形坑,以及微溶蚀孔、隙、蜂窝状溶孔群和SiO_2再沉积等表面形态结构特征。认为它是在第四纪古地理湿热气候条件下泥石流沉积的产物,物源可能来自境内或周边的泥盆系砂岩和境外的花岗岩。