Shear strength characterization of municipal solid waste at the Suzhou landfill, China

The current practice of slope stability analysis for a municipal solid waste (MSW) landfill usually overlooks the dependence of waste properties on the fill age or embedment depth. Changes in shear strength of MSW as a function of fill age were investigated by performing field and laboratory studies on the Suzhou landfill in China. The field study included sampling from five boreholes advanced to the bottom of the landfill, cone penetration tests and monitoring of pore fluid pressures. Twenty-six borehole samples representative of different fill ages (0 to 13 years) were used to perform drained triaxial compression tests. The field and laboratory study showed that the waste body in the landfill can be sub-divided into several strata corresponding to different ranges of fill age. Each of the waste strata has individual composition and shear strength characteristics. The triaxial test results showed that the MSW samples exhibited a strain-hardening and contractive behavior. As the fill age of the waste increased from 1.7 years to 11 years, the cohesion mobilized at a strain level of 10% was found to decrease from 23.3 kPa to 0 kPa, and the mobilized friction angle at the same strain level increasing from 9.9° to 26°. For a confinement stress level greater than 50 kPa, the shear strength of the recently-placed MSW seemed to be lower than that of the older MSW. This behavior was consistent with the cone penetration test results. The field measurement of pore pressures revealed a perched leachate mound above an intermediate cover of soils and a substantial leachate mound near the bottom of the landfill. The measurements of shear strength properties and pore pressures were utilized to assess the slope stability of the Suzhou landfill.     

Interference of Multiple Strip Footings on Sand Using Small Scale Model Tests

By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to (i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data, however, indicates much greater effect of interference especially for larger spacing among footings.     

饱和软黏土动力学特性循环扭剪试验研究

以饱和软黏土的循环扭剪试验研究为基础,阐明不固结不排水条件下饱和软黏土的动力学特性。在循环扭剪和循环三轴两种不同试验应力状态下,通过研究不同围压和不同静、动应力组合下饱和软黏土的应力等效破坏关系和应变等效破坏关系,提出在循环荷载作用下饱和软黏土的循环破坏同样遵循Mises屈服准则,且在Mises屈服准则下,饱和软黏土的循环强度趋于不变量。循环破坏的过程可以等效为一种拟静力弹塑性循环蠕变,建立了饱和软黏土循环累积变形随静荷载、循环荷载以及循环破坏振次之间的关系式。上述结论分别从应力和变形两个方面阐述饱和软黏土的动力学特性,与试验应力状态和围压无关,可以推广到一般应力状态下。     

筒型基础沉贯阻力估算方法

系统地总结国外有代表性工程实践对筒型基础沉贯阻力的研究 ,并将各种方法综合起来 ,提出了加权综合估算法 ,供今后的研究和工程实践参考     

Low-frequency damping of a moored semisubmersible obtained from simulated extinction tests and mean wave drift forces

Low-frequency damping of a moored semisubmersible drilling platform was obtained from numerical extinction tests simulated in still water and in regular waves and from mean wave drift forces calculated at zero forward speed. The influence of drag forces was represented by the modified Morison equation. The platform as used for the 18th ITTC Comparative Mooring Study was analyzed in irregular beam waves. The computed time series of sway as well as the corresponding sway response spectrum compared favourably with model test measurements, demonstrating that this procedure to determine low-frequency damping can be effective.     

海上平台桶形基础模型压力压贯与负压沉贯试验研究

介绍了海上平台桶形基础模型（模型桶）压力压贯和负压沉贯的试验概况,对比分析了两者贯入力的巨大差异和产生的原因,给出了模型桶压力压贯中贯入深度与压力的关系,负压没贯负压与贯入深度,抽吸泵流量,基土渗流量,桶内土塞隆起之间的关系,试验结果表明,负压沉贯可以大大降低以砂质粉土为基土的土抗力,为在胜利油田类似基土海域海上平台应用桶形基础提供了试验依据,为海上现场导管架桶形基础平台的安装就位施工和控制提供了     

声波在水-多孔介质海底界面上的反射与透射

声波在海底界面的反射和透射是海底散射、海底混响、海底目标探测的重要问题。利用Biot多孔介质声传播理论对声波在水-多孔海底界面上的反射和透射进行了分析,具体给出反射声波的反射系数,3种透射声波的透射系数以及声能透射系数随入射波入射角和频率(10~40 kHz)的变化关系,分析了各种透射波对透射声能的贡献。多孔海底介质参数分别采用Stoll和Chotiros给出的2组参数进行理论计算。     

Model Test of Sand Restraining Force on Pipeline

This paper describes the model tests for determining the axial friction and the lateral resistance of sand to pipeline by using fine sand and prototype pipeline, and the calculation method based on limit analysis theory is verified. The effect of cyclic loading is considered in the test.     

An Experimental Study of Several Special Issues Regarding the Ice Force on Conical Structures

The effect of the cone spacing of a conieal structure on the ice force is studied by model experiments. The ice force reduction coefficient presented in this paper expresses the relationship between the ice force and the arrangement of cones. The experiments prove that the mode of the ice failure before the boundary of upward-downward bending cone (UDBC) is crushing. A conclusion can also be drawn from the experiments that the ice force on the boundary of UDBC is by far less than that on a vertical pile with the same diameter. Moreover, the ice force frequencies on upright and inve-rted cones are obtained under the field condition of the platform JZ20-2, respectively. The results show that the alterna-tion of the ice force on UDBC can hardly induce resonance of platform JZ20-2.     

Model Test Study of Dynamic Ice Force on Compliant Conical Structures

To study ice-induced vibration of a compliant conical structure,a series of model tests were performed from 2004 to 2005.In the tests,the ice sheet before the compliant conical structure was found to fail in two-time breaking.From 2005 to 2006,this type of ice failure was studied through more groups of tests.The tests show that two-time breaking is the typical failure of ice before steep conical structures,and is controlled by other factors at the same time,such as ice speed and the angle of the cone.