青海省新一代BDS高精度基准服务平台的构建

介绍了青海省新一代北斗卫星导航系统(BDS)高精度基准服务平台.该平台具备用户管理、数据处理、空间环境监控、高精度定位等功能,可以满足系统管理员、行政领导、单位用户和实时动态(RTK)测量用户在内的各种用户的多样化需求,并且遵循了管理标准化、可扩展性强、现势性好、实用性好、安全性强、具有前瞻性等建设原则.     

张力腿平台筋腱支撑浮筒结构设计研究

在张力腿平台筋腱与海底桩基连接后,需要筋腱支撑浮筒为筋腱提供足够的浮力,保证筋腱在平台运抵工作海域之前不会发生倾覆。针对南海油田自主研发的张力腿平台筋腱实际尺寸及设计要求,设计了适用于1 061 mm(40英寸)筋腱、500米水深的张力腿平台筋腱支撑浮筒,并对筋腱支撑浮筒主要受力进行了分析计算,根据所计算的载荷情况对关键部件进行了有限元仿真分析,验证了结构强度的可靠性,并得到了结构的应力集中点与最大变形点,为筋腱支撑浮筒的结构设计提供了参考。     

光照强度和光色对番红砗磲(Tridacna crocea)氨氮、活性磷酸盐及氧代谢的影响

采用室内实验生态学方法,以水体中氨氮、活性磷酸盐和溶氧变化为指标研究了光照强度和光色对番红砗磲代谢的影响。结果表明:(1)在0—10000lx光照时,番红砗磲排氨量逐渐减少,在光照12000lx时转为吸收海水中氨氮,并在16000lx时达到最高[1.89μg/(ind·h)];在2000lx光照条件下,番红砗磲可吸收海水中活性磷酸盐并释放氧气。其活性磷酸盐吸收量随光照强度增强而增加,在16000lx时达到最高峰。在实验光照范围内,番红砗磲产氧率随光照强度的增强逐渐增加。上述结果显示番红砗磲最佳光照强度约为16000lx。(2)当番红砗磲自黑暗转移至各光照组后,其氨氮、活性磷酸盐吸收率均随时间逐渐降低,而产氧率则逐渐升高。(3)光色显著影响番红砗磲合成代谢,蓝光最佳,红光次之,白光最差。     

基于噪声谱比法的内蒙古西部地区台站场地响应研究

利用内蒙古西部12个台站的地脉动噪声数据，采用噪声谱比法研究台站的场地响应情况。分析表明，台站场地响应按曲线形态可分为3类，且可能受地形地貌、局部构造和台基状况等条件影响。对比分析噪声谱比法与Moya方法的场地响应结果发现，场地响应曲线形态基本一致，只有极少数台站存在明显差异。结果表明，内蒙古西部区域大部分台站的台基状况总体较好，场地响应曲线较为平坦，无明显频率放大点。     

利用自回归模型检测地球极移重力效应

同时采用4个台站的国际超导重力仪长期连续重力观测资料和国际地球自转服务中心提供的同步地球自转参数，研究了极移引起的地球重力场变化特征。利用自回归模型估计了各序列的功率谱密度和积谱密度，结果表明极移导致的重力效应的主要能量集中在Chandler摆动和周年项附近，叠积后实际重力观测与极移重力信号理论值之间的差异分别为0．4％和3．9％，说明超导重力仪可有效监测极移导致的重力变化。     

Near-Infrared Imaging Spectrophotometry Of Comet C/1995 O1 (Hale-Bopp) Near Perihelion

We present 1- to 5-μm broadband and CVF images of comet Hale-Bopp taken 1997 February 10.5 UT, 50 days before perihelion. All the images exhibit a nonspherical coma with a bright “ridge” in the direction of the dust tail approximately 10″ from the coma. Synthetic aperture spectrophotometry implies that the optically important grains are of a radius ≤0.4 μm; smallest radius for any comet seen to date. The variation of the integrated surface brightness with radial distance from the coma (ρ) in all the images closely follows the “steady state” ρ⁻¹ model for comet dust ablation (Gehrz and Ney, 1992). The near-infrared colors taken along the dust tail are not constant implying the dust grain properties vary with coma distance. This revised version was published online in July 2006 with corrections to the Cover Date.     

The response of an elastic half‐space under a momentary shear line impulse

The response of an ideal elastic half‐space to a line‐concentrated impulsive vector shear force applied momentarily is obtained by an analytical–numerical computational method based on the theory of characteristics in conjunction with kinematical relations derived across surfaces of strong discontinuities. The shear force is concentrated along an infinite line, drawn on the surface of the half‐space, while being normal to that line as well as to the axis of symmetry of the half‐space. An exact loading model is introduced and built into the computational method for this shear force. With this model, a compatibility exists among the prescribed applied force, the geometric decay of the shear stress component at the precursor shear wave, and the boundary conditions of the half‐space; in this sense, the source configuration is exact. For the transient boundary‐value problem described above, a wave characteristics formulation is presented, where its differential equations are extended to allow for strong discontinuities which occur in the material motion of the half‐space. A numerical integration of these extended differential equations is then carried out in a three‐dimensional spatiotemporal wavegrid formed by the Cartesian bicharacteristic curves of the wave characteristics formulation. This work is devoted to the construction of the computational method and to the concepts involved therein, whereas the interpretation of the resultant transient deformation of the half‐space is presented in a subsequent paper. Copyright © 2003 John Wiley & Sons, Ltd.     

Virtual Huanghe River System： Framework and Technology

1 Introduction Huanghe (Yellow) River basin is located in 32°–42°N, 96°–119°E. The area of the catchment is more than 752,000km2. The river is 5464km long with a drop in elevation of 4830m. Among the whole area, the moun- tainous and stone area accounts for 29%, loess and hills area 46%, sandy area 11% and plain area 14%, respec- tively. Different natural landscapes exist in this area. The Huanghe River flows through the Loess Plateau, where the soil is eroded seriously (Wang, 2002;…     

板翅式换热器综合性能优化的设计方法

应用给定换热器结构材料而使换热量最大的两侧换热表面的最佳匹配准则和使可用能损失率最小的最佳运行参数准则。利用两个准则间的关系 ,采用迭代的方式完成换热器的优化设计 ,使换热器的设计达到材料省、换热效果好及运行费用低的目的 ,且能在设计阶段实现。     

Effect of spatial variation characteristics on contouring of design storm depth

The ordinary kriging method, a geostatistical interpolation technique, was applied for developing contour maps of design storm depth in northern Taiwan using intensity–duration–frequency (IDF) data. Results of variogram modelling on design storm depths indicate that the design storms can be categorized into two distinct storm types: (i) storms of short duration and high spatial variation and (ii) storms of long duration and less spatial variation. For storms of the first category, the influence range of rainfall depth decreases when the recurrence interval increases, owing to the increasing degree of their spatial independence. However, for storms of the second category, the influence range of rainfall depth does not change significantly and has an average of approximately 72 km. For very extreme events, such as events of short duration and long recurrence interval, we do not recommend usage of the established design storm contours, because most of the interstation distances exceed the influence ranges. Our study concludes that the influence range of the design storm depth is dependent on the design duration and recurrence interval and is a key factor in developing design storm contours. Copyright © 2003 John Wiley & Sons, Ltd.