计算最小走时和射线路径的界面网全局方法

用慢度分块均匀正方形模型将介质参数化，仅在正方形单元的边界上设置计算结点，这些结点构成界面网．根据Ｈｕｖｓｅｎｓ和Ｆｅｒｍａｔ原理，由不断扩张、收缩的波前点扫描代替波前面搜索，在波前点附近点的局部最小走时计算中对波前点之间的走时使用双曲线近似，通过比较确定最小走时和相应的次级源位置，记录在以界面网点位置为指针的３个一维数组中．借助这些数组通过向源搜索可计算任意点（包括界面网以外的点）上的全局最小走时和射线路径．这一方法不受介质慢度差异大小限制，占内存少，计算速度较快，适于走时反演和以Ｍａｓｌｏｖ射线理论为基础的波场计算．     

Monitoring of fault healing after the 1999 Kocaeli, Turkey, earthquake

The North Anatolian fault zone that ruptured during the mainshock of theM 7.4 Kocaeli (Izmit) earthquake of 17 August 1999 has beenmonitored using S wave splitting, in order to test a hypothesisproposed by Tadokoro et al. (1999). This idea is based on the observationof the M 7.2 1995 Hyogo-ken Nanbu (Kobe) earthquake, Japan.After the Hyogo-ken Nanbu earthquake, a temporal change was detectedin the direction of faster shear wave polarization in 2–3 years after the mainshock (Tadokoro, 1999). Four seismic stations were installed within andnear the fault zone at Kizanlik where the fault offset was 1.5 m, about80 km to the east of the epicenter of the Kocaeli earthquake. Theobservation period was from August 30 to October 27, 1999. Preliminaryresult shows that the average directions of faster shear wave polarization attwo stations were roughly parallel to the fault strike. We expect that thedirection of faster shear wave polarization will change to the same directionas the regional tectonic stress reflecting fault healing process. We havealready carried out a repeated aftershock observation at the same site in2000 for monitoring the fault healing process.     

The shape of the radio wavefront of extensive air showers as measured with LOFAR

Extensive air showers, induced by high energy cosmic rays impinging on the Earth’s atmosphere, produce radio emission that is measured with the LOFAR radio telescope. As the emission comes from a finite distance of a few kilometers, the incident wavefront is non-planar. A spherical, conical or hyperbolic shape of the wavefront has been proposed, but measurements of individual air showers have been inconclusive so far. For a selected high-quality sample of 161 measured extensive air showers, we have reconstructed the wavefront by measuring pulse arrival times to sub-nanosecond precision in 200 to 350 individual antennas. For each measured air shower, we have fitted a conical, spherical, and hyperboloid shape to the arrival times. The fit quality and a likelihood analysis show that a hyperboloid is the best parameterization. Using a non-planar wavefront shape gives an improved angular resolution, when reconstructing the shower arrival direction. Furthermore, a dependence of the wavefront shape on the shower geometry can be seen. This suggests that it will be possible to use a wavefront shape analysis to get an additional handle on the atmospheric depth of the shower maximum, which is sensitive to the mass of the primary particle.     

AN EXPERIMENTAL STUDY ON THE PROCESS OF INTERGRANULAR PRESSURE SOLUTION OF PLAGIOCLASE GOUGE UNDER HIGH TEMPERATURE AND PRESSURE: METHOD AND PRELIMINARY RESULTS

To understand the mechanism of lower-crust earthquake and slow slips, it is necessary to study the frictional properties of mafic rocks and their major rock-forming minerals. Previous studies have performed a series of experimental researches on gabbro, basalt and their major constituents. According to the results of previous experiments, frictional sliding of plagioclase under hydrothermal conditions(100~600℃)shows a property of velocity weakening, and the experimental results show that both the direct rate effect parameter(a)and the healing effect parameter(b)increase with temperature, a typical feature for thermally-activated processes. Velocity weakening means property of a shear band that has a stronger friction healing effect than the direct rate effect in the rate and state friction constitutive framework, and the healing effect(b value)in constitutive relation mainly reflects the increase in contact area with time under hydrothermal conditions, with some minor effect of structural changes. Since the microphysical mechanism of feldspar minerals at the contacts is mainly brittle cataclasis for temperatures below 600℃, the significant frictional healing effect in this case can only be explained by the mechanism of pressure solution. In order to determine if the dissolution process of plagioclase actually occurs on the laboratory time scale, we conducted hydrostatic experiments on plagioclase powder samples under hydrothermal conditions whereby frequent contact switch between particles seen in frictional sliding experiments can be avoided, making the observation on the dissolution sites possible. Experimental temperatures were 400℃ and 500℃, with confining pressure of 90~150MPa, pore pressure of 30MPa, with 2mm initial thickness of fault gouge. The mechanical data show that a creep process occurred in the plagioclase fault gouge in the experimental temperature and pressure range; and the microstructures of the experiment show that precipitation of new grains is prevalent as the product of pressure solution process between plagioclase particles. At the same time, it is observed that the contact points have an appearance similar to fused, fuzzy structure as signatures of dissolution. The results of our experiments provide a definite experimental evidence for the healing mechanism in friction of plagioclase and for the theoretical relation between unstable slip and the pressure solution process. The results of the experiments are summarized as follows: (1)Drainage rate of pore water in plagioclase gouge was high in the first few hours of experiment, but gradually decreases over time for both temperature and pressure series of experiments slowing down to a steady state. This feature indicates that there is a creep process that evolves inside the plagioclase gouge. In the temperature-series experiments, the drainage rate of the pore water in the plagioclase gouge at 400℃ is relatively low than the cases for higher temperatures. Thus, the applied temperature is positively correlated with the creep of plagioclase gouge. (2)Scanning electron microscopy(SEM)observations of the experimentally deformed samples were performed on thin sections cut along the sample axis. Firstly, from the images of microstructure, it was found that the degree of particle fracture became more significant at a higher effective pressure, with smaller pore volume between particles. In the temperature-series experiments it was found that the degree of compaction of plagioclase gouge increased with increasing temperature. Precipitation of plagioclase grains in layered structures was generally observed in high-magnification images, indicating the presence of pressure solution processes. Contact points were also found to be in a state of ambiguity that seems to be a fused morphology, but the details of the structure remain to be determined by further observations. The above results indicate that the pressure solution process of plagioclase particles can occur on a typical laboratory time scale, and the results of this study provide robust experimental evidences for the theory that links between pressure solution and the mechanism of frictional healing and unstable slips for plagioclase.     

CHIMEHERB人工皮在皮肤微粒移植中的临床应用

在皮肤微粒播散移植中应用CHIMEHERB人工皮覆盖6例,8个部位取得了较满意的效果,显示CHIMEHERB人工皮覆盖部位比新鲜猪皮覆盖部位平均提前愈合8.5天,人工皮可作为微粒皮移植后覆盖物.     

韧性剪切带中含金石英脉的就位机制

本文以韧性剪切带中含金石英脉的地质特征分析为基础。重点讨论:a.绿片岩相—低角闪岩相环境中的韧性剪切带内,变形岩石的韧—脆性转变既受温度、压力条件控制,又受高压流体相的广泛介入影响。对于多阶段金矿化过程,流体相的存在对岩石力学性质的转变具有更重要的意义;b.Roberts(1987)论述的含矿Riedal裂隙系(D、P、R、R′和T、P′)中不同类型裂隙内含金石英脉的就位机制有很大的差异;c.Ramsay的破裂—愈合机制可以很好地解释沿R、R′、T和某些沿D、P就位的含金石英脉的形成;d.本文作者提出液压扩容破裂机制是沿D、P方向就位的某些含金石英脉的重要就位过程。     

胶东河西金矿控矿断裂及矿体预测

本文以野外地质观察为基础,运用显微构造、岩组、构造地球化学等多种手段,对河西金矿断裂构造及其控矿作用进行了探讨,并进行了矿体预测,得到了证实,取得了可喜的经济效益。     

缢蛏多巴胺受体基因及其在损伤修复中的作用

多巴胺受体(dopamine receptor)作为生物体中重要的神经递质受体, 在生物体的生长、发育、代谢等多个生理过程中都发挥着重要的功能。本研究从缢蛏Sinonovacula constricta转录组文库中筛选获得多巴胺受体基因的部分片段, 结合RACE(rapid-amplification of cDNA ends)技术和降落 PCR(polymerase chain reaction)技术, 克隆得到缢蛏两个多巴胺受体的选择性多聚腺苷酸化(alternative polyadenylation, APA)的变异体, 命名为ScDopR2a和 ScDopR2b, 长度分别为1824bp和2758bp。两个变异体均包含相同的5′非翻译区(untranslated regions, UTR)(24bp)和开放阅读框(open reading frame, ORF)(1440bp), 共编码479个氨基酸残基。但是两个变异体的3′UTR 长度不同, 分别为360bp和1294bp, 其中ScDopR2b在polyA尾前插入936bp。在同源的ORF区设计引物, 采用实时定量PCR分析多巴胺受体基因在不同组织中的表达特征, 结果表明多巴胺受体基因在水管、鳃、斧足的表达量显著高于其他组织。在该基因序列3′UTR插入片段区域设计特异引物检测ScDopR2b的组织表达情况, 结果表明在水管、鳃、斧足的表达量仍高于其他组织, 表达趋势与ORF区大致相同。进一步设计缢蛏组织损伤实验, 对进水管前端进行损伤处理, 在处理后的第4h、8h、12h、24h、48h、60h和72h取样, 荧光定量检测结果显示, 同源区表达量在12h和48h呈上调, 在8h、24h和72h下调, 且ScDopR2b表达趋势与同源区表达模式大致相同。研究结果表明, 缢蛏多巴胺受体参与了损伤修复过程, 其表达特征可能与多巴胺作为补偿性神经递质的作用有关。     

松辽盆地南部红岗油田青山口组砂岩中片钠铝石的形成温度

主要以松辽盆地南部红岗油田富含片钠铝石砂岩的红143和红146井为研究对象,通过普通薄片鉴定、茜素红-S染色、扫描电镜、能谱分析、显微测温等分析方法,对研究区含片钠铝石砂岩的成岩共生序列,尤其是流体包裹体均一温度进行了详细的研究.红岗油田成岩共生序列为:黏土矿物→石英次生加大边→方解石→片钠铝石→铁白云石→石英愈合微裂...