The most primitive mesosiderite Northwest Africa 1878, subgroup 0

All mesosiderites previously reported were subjected to thermal metamorphism and/or partial melting on the parent body. Therefore, their primordial features have been mostly lost. Here, we report detailed petrological and mineralogical features on a mesosiderite, Northwest Africa (NWA) 1878. This meteorite comprises silicate lithology and aggregates of small spheroidal Fe‐Ni metal grains. Silicate lithology typically shows igneous texture without recrystallization features, and mainly consists of low‐Ca pyroxene and plagioclase. Pyroxenes often show normal zoning. Exsolution lamella of augite is rarely noticed and very thin in width, compared with other mesosiderites. A few magnesian olivine grains are encountered without typical corona texture around them. They are not equilibrated with pyroxene on a large scale. Plagioclase shows a wide compositional range. These results show that NWA 1878 hardly experienced thermal metamorphism, distinguished from mesosiderites of subgroups 1–4. Therefore, we propose that this is classified as subgroup 0 mesosiderite. Nevertheless, NWA 1878 was locally subjected to secondary reactions, such as weak reduction of pyroxene and Fe‐Mg diffusion between olivine and pyroxene, on the parent body.     

Microboudin structures of piemontite along the Sambagawa metamorphic belt, Japan: implications for lateral variation of differential stress during regional metamorphism

Evidence is presented of a lateral variation in differential stress during metamorphism along a regional metamorphic belt on the basis of the proportion of microboudinaged piemontite grains (p) in a quartz matrix in metacherts. It is proposed that p is a practical indicator of relative differential stress. Analysis of 123 metacherts from the 800 km long Sambagawa metamorphic belt, Japan, reveals that p‐values range from < 0.01 to 0.7 in this region. Most samples from Wakayama in the mid‐belt area have p‐values of 0.4–0.6, whereas those from western Shikoku have p‐values of < 0.1. This difference cannot be explained by variations in metamorphic temperature, and is instead attributed to a regional, lateral variation in differential stress during metamorphism.     

Sulfate reduction and sulfide deposition in deep-sea sediments from the southwestern Japan Sea

Vertical profiles of total sulfur and organic carbon have been measured in two deep-sea piston cores from the southwestern Japan Sea where sulfate reduction is proceeding within the sediments. The content of total sulfur, most of which is present as pyrite, increases gradually with increasing depth, showing several peaks. The amount of diagenetically deposited sulfide-sulfur is estimated using a steady-state model that considers vertical change in the diffusion coefficient. It is suggested that two-thirds to three-fourths of the observed total sulfur content has been deposited diagenetically.     

The effects of the reed,Phragmites australis (Trin.), on substratum grain-size distribution in a salt marsh

The effects of the reed,Phragmites australis (Trin.), growing in a brackish water lagoon, were studied in relation to the grain-size distribution of the substratum. At the salt marshes near the lagoon, the upper soils from the surface to a depth of 20 cm contained much silt-clay. These fine particles were found to be transferred from the river and fish ponds near the lagoon, and to be deposited when the tidal rhythm changed, that is, when the water current stopped. In addition, the fine particles, which were deposited on the bottom of the lagoon adjacent to the marshes, became resuspended as a result of wind-caused wave action, and then were transported and redeposited in the salt marshes at the flood tide. Since the reeds further reduced the water current caused by the waves and tide, the reeds were thought to promote redeposition of the resuspended matter. In other words, the reeds were considered to protect deposited and redeposited particles such as silt and clay from resuspension as a result of wave action by reducing the effects of waves and wind. These processes suggested that silt-clay will become abundant in the substratum of the salt marsh adjacent to the lagoon.     

Photo-inhibition of phytoplankton photosynthesis as a function of exposure time

The photo-inhibition of phytoplankton photosynthesis at higher intensities was examined with a cultured marine diatom,Phaeodactylum tricornutum, and natural samples. The question was to determine whether photo-inhibition results from excretion of photosynthetic products from cell or from an actual decrease in photosynthetic rate. P. tricornutum cultured at 15 klux showed very little photo-inhibition up to 70 klux, and, in the sample cultured at 1 klux, most marked photo-inhibition was observed in 3 hours experiment. Extracellular release was less than 30% of particulate fixation, and did not show any extreme increase to supplement photosynthesis depression at higher light intensities. When the photosynthesis was measured during 10 minutes, both samples showed no photo-inhibition. The photosynthesis by low light sample lost the linearity of time-course with prolonged exposure at high light intensity. Observed photo-inhibition, therefore, we explained with the actual decrease in photosynthetic rate. Similar photo-inhibition could be seen in marine phytoplankton samples concentrated by filtration.     

Degradation of lubricating oils by marine bacteria observed by quantitative mass spectrometry

Bacterial degradation of the hydrocarbons of lubricating oils was investigated by mass spectrometric analysis which gives both total amount and the composition of hydrocarbon types of residual oil. An unused lubricating oil, which mainly consisted of hydrocarbon types with only a small percentage ofn-alkanes, was degraded by marineBacillus sp. andPseudomonas sp. with 55 % and 25 % decreases in 10 days, respectively. Susceptibility of respective hydrocarbon types to biodegradation was in the following order: alkanes > non-condensed cycloalkanes, mono-aromatics > condensed cycloalkanes. A used lubricating oil of different brand showed a larger decrease than the unused oil. Both species of bacteria degraded large portions of alkane fraction of Arabian light crude oil.     

Bacteria on petroleum globules in the Philippine sea in January, 1973

About 10⁶ of total bacteria (direct microscopic count) or heterotrophic bacteria (colony count with Medium 2216E) and about 10⁴ of petroleumlytic bacteria (oil-oxidizing bacteria) were enumerated per square centimeter of the surface of petroleum globules suspended in the topmost 10 meters of water from a station (22°00.2N, 125°51.9E) in the western North Pacific central water, where about 10⁷ of total bacteria, about 10³ of heterotrophic bacteria and about 10 of petroleumlytic bacteria were enumerated per liter of seawater.     

Changing anthropogenic influence on the Santa Monica Bay watershed

Santa Monica Bay is an open coastal embayment located directly seaward of Los Angeles, California. The Bay provides vital economic value through its water-dependent activities, such as swimming, diving, boating, and fishing. An increase from 100,000 residents in 1900 to 10 million in 2000 has imposed numerous environmental stressors on the Bay, including urbanization of the watershed. Pollutant discharges into the Bay increased throughout the early part of the century, but declined following passage of the Clean Water Act in 1972. Since that time, the predominant source of pollutant inputs has changed from point sources to non-point urban runoff. To assess how present-day and historical pollution interact to affect the environmental quality of Santa Monica Bay, three organizations collaborated on a multi-disciplinary study in 1997, towards which this volume is focused. This paper details the temporal patterns of anthropogenic influence on Santa Monica Bay to provide context for the papers that follow.     

Finite-element Simulation of Seismic Ground Motion with a Voxel Mesh

— Accurate simulation of seismic ground motion for three-dimensionally complex topography and structures is one of the most important goals of strong motion seismology. The finite-element method (FEM) is well suited for this kind of simulation, since traction-free conditions are already included in the formulation, and the Courant condition is less strict than for the finite-difference method (FDM). However, the FEM usually requires both large memory and computation time. These limitations can be overcome by using a mesh consisting of voxels (rectangular prisms) with isotropy built into the explicit formulation of the dynamic matrix equation. Since operators in the voxel FEM are the combinations of ordinary FDM operators and additional terms, the method keeps accuracy of the same order as FDM and the terms relax the Courant condition. The voxel FEM requires a similar amount of memory and only takes 1.2～1.4 times longer computation time. The voxel mesh can be generated considerably faster than the popular tetrahedral mesh. Both ground motions and static displacements due to a point or line source can be calculated using the voxel FEM approach. Comparisons with the reflectivity method and theoretical solutions demonstrate the successful implementation of the method, which is then applied to more complex problems.