Effects of changes in canopy interception on stream runoff response and recovery following clear-cutting of a Japanese coniferous forest in Fukuroyamasawa Experimental Watershed in Japan

Understanding changes in evapotranspiration during forest regrowth is essential to predict changes of stream runoff and recovery after forest cutting. Canopy interception (Ic) is an important component of evapotranspiration, however Ic changes and the impact on stream runoff during regrowth after cutting remains unclear due to limited observations. The objective of this study was to examine the effects of Ic changes on long-term stream runoff in a regrowth Japanese cedar and Japanese cypress forest following clear-cutting. This study was conducted in two 1-ha paired headwater catchments at Fukuroyamasawa Experimental Watershed in Japan. The catchments were 100% covered by Japanese coniferous plantation forest, one of which was 100% clear-cut in 1999 when the forest was 70 years old. In the treated catchment, annual runoff increased by 301 mm/year (14% of precipitation) the year following clear-cutting, and remained 185 mm/year (7.9% of precipitation) higher in the young regrowth forest for 12–14 years compared to the estimated runoff assuming no clear-cutting. The Ic change was −358 mm/year (17% of precipitation) after cutting and was −168 mm/year (6.7% of precipitation) in the 12–14 years old regrowth forest compared to the observed Ic during the pre-cutting period. Stream runoff increased in all seasons, and the Ic change was the main fraction of evapotranspiration change in all seasons throughout the observation period. These results suggest that the change in Ic accounted for most of the runoff response following forest cutting and the subsequent runoff recovery in this coniferous forest.     

Diel Patterns in Chlorophyll <Emphasis Type="Italic">a</Emphasis> Specific Absorption Coefficient and Absorption Efficiency Factor of Picoplankton

Diel patterns in the chlorophyll a specific absorption coefficient of surface picoplankton, a*_pico (γ) (m²·[mg chlorophyll a]⁻¹), were studied at 7 stations under daily cycle of in situ light condition in the western subarctic Pacific and Japan Sea. All the data were normalized by dividing the anomaly with daily averaged a*_pico (γ). Opposite diel patterns were observed for the normalized a*_pico (443) and a*_pico (675) with maximum toward dawn or dusk and minimum toward midday at 4 stations under low-irradiance (LI) conditions and vice versa at 3 stations under high-irradiance (HI) conditions. The absorption efficiency factors at red absorption peak, Q _a (675), were determined by reconstruction with intracellular chlorophyll a concentration and cell diameter. The normalized Q _a (675) also showed diel pattern with maximum toward midday and minimum toward dawn or dusk under LI. The diel pattern in a*_pico (675) and Q _a (675) were primarily caused by changes in intracellular chlorophyll a concentration due to photoadaptation under LI. The diel pattern in a*_pico (443) was influenced by pigmentation, as recognized by blue to red ratio [a*_pico (443)/a*_pico (675)] under HI. This study proposed that the opposite diel pattern in a*_pico (γ) might occur for a wide range of algal species. The results presented here have important consequences for the interpretation of diel variations in optical properties observed in the open ocean.     

Growth and gonad production of the sea urchin Hemicentrotus pulcherrimus in the fucoid bed and algal turf in northern Japan

To clarify the differences in the growth and gonad size of the sea urchin Hemicentrotus pulcherrimus among algal sere, the study was conducted in June and July, and September 1998 at three fucoid beds in Oga and at three algal turfs in Hachimori, Akita Prefecture in northern Japan. The most rapid growth was observed in a large perennial fucoid bed at the climax stage. Growth in a small perennial Chondrus ocellatus‐dominated bed in algal turfs in the seral stage was then high. The slowest growth was observed in the small perennial Dictyopteris divaricata‐ and Laurencia spp.‐dominated beds which are known to possess chemicals which act as feeding deterrents against the sea urchins. The gonad index (gonad wet weight × 100/body wet weight) at a fucoid bed was high where standing crops exceeded 3 kg·m^?2. The gonad index in the Laurencia bed was lower than those at fucoid beds. These results suggest that growth and gonad production are affected by algal sere and differ among species of small perennial algae in the seral stage with or without chemical defense.     

Structural evolution of the Bayanhongor region, west-central Mongolia

Most of previous models suggest that the Central Asia Orogenic Belt grew southward in the Phanerozoic. However, in the Bayanhongor region in west-central Mongolia, volcanic arc, accretionary prism, ophiolite, and passive margin complexes accreted northeastward away from the Baydrag micro-continent, and hence the region constitutes the southwestern part of a crustal-scale syntaxis close to the west. The syntaxis should be original, because presumably reorientation due to strike-slip faulting can be ignored. It is reconfirmed that the Baydrag eventually collided with another micro-continent (the Hangai) to the northeast. A thick sedimentary basin developed along the southern passive margin of the Hangai micro-continent. This region is also characterized by an exhumed metamorphosed accretionary complex and a passive margin complex, which are both bounded by detachment faults as well as basal reverse faults which formed simultaneously as extrusion wedges. This part of the Central Asia Orogenic Belt lacks exhumed crystalline rocks as observed in the Himalayas and other major collisional orogenic belts. In addition, we identified two phases of deformation, which occurred at each phase of zonal accretion as D1 through Cambrian and Devonian, and a synchronous phase of final micro-continental collision of Devonian as D2. The pre-collisional ocean was wide enough to be characterized by a mid-ocean ridge and ocean islands. Two different structural trends of D1 and D2 are observed in accretionary complexes formed to the southwest of the late Cambrian mid-ocean ridge. That is, the relative plate motions on both sides of the mid-ocean ridge were different. Accretionary complexes and passive margin sediments to the northeast of the mid-ocean ridge also experienced two periods of deformation but show the same structural trend. Unmetamorphosed cover sediments on the accretionary prism and on the Hangai micro-continent experienced only the D2 event due to micro-continental collision. These unmetamorphosed sediments form the hanging walls of the detachment faults. Moreover, they were at least partly derived from an active volcanic arc formed at the margin of the Baydrag micro-continent.     

Evaluation of Subsurface Structure at Soultz Hot Dry Rock Site by the AE Reflection Method in Time-frequency Domain

—?Because the Soultz Hot Dry Rock (HDR) site, France, is to be expanded to a scientific pilot plant of greater depth, measurement of the deep area below the predeveloped artificial reservoir is gaining importance. In this paper, we present estimates of deep subsurface structure at the Soultz HDR site, obtained by a reflection method using acoustic emission (AE) signals, that is, induced seismicity, as the wave source. First, we briefly describe the AE reflection method in the time-frequency domain with wavelet transform. Then we show estimates of the subsurface structure by using 101 high-energy AE events observed in 1993. We compare and discuss the results obtained, using the AE reflection method in two wells with other independent borehole observations. Furthermore, we present the results of an investigation of the frequency dependence of reflectors identified by hodogram linearity as a possible means of further characterizing detected structures.     

Rock magnetism and paleomagnetic stratigraphy of forearc sediments of the Japan Trench, ODP Sites 1150 and 1151

Abstract Magnetic measurements were carried out to investigate rock magnetic properties and paleomagnetic directions of late and middle Miocene sediments recovered from the land side of the Japan Trench during the Ocean Drilling Program Leg 186. Because the low coercive component in natural remanent magnetization (NRM) normalized by anhysteretic remanent magnetization shows that the drilling‐induced magnetization is severe in the sections obtained by the advanced hydraulic piston coring method, careful analyses of demagnetization of NRM using the ‘demagnetization plane’ were carried out to decompose the direction and intensity. Magnetostratigraphic correlation down to the upper Miocene, supplemented by biostratigraphic data, revealed that the sedimentation rates are characterized by drastic changes, with the early Pliocene having the highest rate. This high sedimentation rate is related to the subsidence of the southern deep‐sea terrace of the Japan Trench.     

Effect of structure-directing agent on AlPO4-n synthesis from aluminum dross

The hydrothermal synthesis of AlPO₄-n which is a functional material of aluminophosphate, was conducted from two kinds of aluminum dross discharged in an aluminum regeneration factory. The effect of structure-directing agent (SDA) on the formation behavior of AlPO₄-n from aluminum dross, the suitable condition to obtain AlPO₄-n efficiently, and the pore structure and gas adsorption property were investigated in this study.AlPO₄-5 and AlPO₄-34 are mainly formed from aluminum dross as a raw material, and it is possible to make AlPO₄-5 successfully as a main product by adjusting the amount of triethylamine (TEA) as SDA. The gas adsorption amount with AlPO₄-5 is the following order; ammonia > dipropylamine > benzene, and it is found that this order mainly corresponds with the polarity of molecule among them.     

Research on thermal shock resistance of mullite-bauxite-silicon carbide castable refractory

Effects of different silicon carbide contents on thermal shock resistance properties of mullite-bauxite castable refractory were analyzed respectively by taking the mullite,bauxite as main raw materials and taking calcium aluminate cement as a binding system.After 24 h curing in mould and another 24 h curing at 110℃ after demoulding,the samples were heated at 1000,1300 and 1500℃for 3 h in air,respectively.The bulk density,thermal expansion coefficient and thermal shock resistance were examined.The results showed that there was a great effect of content of SiC on bulk density,thermal expansion coefficient and thermal shock resistance of mullite-bauxite castable.Under the experimental conditions,the castable performed the best thermal shock resistance when w(SiC)=5%-10%.     

Real-time on-line test for MDOF systems

This paper presents a test system for conducting on-line tests in a real time and a series of real-time on-line tests conducted to verify the effectiveness of the system. The proposed system is characterized by (1) use of a Digital Signal Processor (DSP) now readily available, (2) adoption of the C language to ensure easy programming, and (3) separation of response analysis and displacement signal generation to apply the system for tests with complex structures. To create displacement signals successively without being interrupted by the computation of equations of motion, extrapolation and interpolation procedures using present and past target displacements are developed. Base-isolated building models were chosen for the real-time on-line test. The effectiveness of the extrapolation and interpolation procedures was demonstrated through a series of real-time on-line tests applied to the models treated as SDOF structures. A five-storey base-isolated building model (treated as a six DOF structure) was tested for various ground motions, and it was verified that the system is able to simulate earthquake responses involving large displacements and large velocities. The number of DOFs that can be handled in the proposed system was investigated, and it was found that the system is capable of performing the test with reasonable accuracy for up to 10 DOF structures with a range of response frequency not greater than 3·0 Hz, or 12 DOF structures with a range of response frequency not greater than 2·0 Hz. Copyright © 1999 John Wiley & Sons, Ltd.