Deep structure of the Nojima Fault, southwest Japan, estimated from borehole observations of fault-zone trapped waves

To estimate the deep structure of the southern part of the Nojima Fault, southwest Japan without the influence of near-surface structures, we analyzed the Love-wave-type fault-zone trapped waves (LTWs) recorded by a borehole seismometer at 1800 m depth. We examined the polarization, dispersion, and dominant frequency of the wavetrain following the direct S-wave in each seismogram to identify the LTW. We selected eight candidates for typical LTWs from 462 records. Because the duration of the LTW increases with hypocentral distance, we infer that the low velocity fault-zone of the Nojima Fault continues towards the seismogenic depth. In addition, since the duration of the LTW increases nonlinearly with hypocentral distance, we infer that the S-wave velocity of the fault-zone increases with depth. The location of events showing the LTW indicates that the fault-zone dips to the southeast at 75° and continues to a depth of approximately 10 km. We assumed a uniform low-velocity waveguide to estimate the average structure of the fault-zone. We estimated the average width, S-wave velocity, and Q_s of the fault-zone by comparing an analytical solution of the LTW with measured data. The average width, S-wave velocity, and Q_s of the fault-zone are 150 to 290 m, 2.5 to 3.2 km/s, and 40 to 90, respectively. Hence the fault-zone structure with a larger width and smaller velocity reduction than the fault-zone model estimated by previous surface observation is more suitable to represent the average fault-zone structure of the Nojima fault. The present study also indicated that the shallow layers and/or a shallow fault-zone structure drastically changes the characteristics of the LTW recorded at the surface, and therefore cause a discrepancy in the fault-zone model between the borehole observation and surface observation.     

Microseismicity Induced by Heavy Rainfall Around Flooded Vertical Ore Veins

—?Microseismicity (M?M?M?M??6 were also monitored at a crustal movement monitoring station located several hundred meters from the veins. It was found that the opening of the vertical ore veins primary led to significant strain and tilt, but not to seismicity, because the delay and the longer duration of the seismicity were significant. Most seismic events involve thrusting mechanisms that are consistent with the present stress state of E-W-oriented tectonic compression, but are not consistent with the opening of the deepest ore vein. Interstingly, all the events within a few months of the heavy rainfall occurred near the faults that offset the deepest ore veins, wheareas all those events located away from the deepest ore veins occurred many months after the heavy rainfall. Consequently, the delayed diffusion of water appears to have played a dominant role in reducing rock strength, which led to seismicity in the Ikuno mine.     

Monitoring of fault healing after the 1999 Kocaeli, Turkey, earthquake

The North Anatolian fault zone that ruptured during the mainshock of theM 7.4 Kocaeli (Izmit) earthquake of 17 August 1999 has beenmonitored using S wave splitting, in order to test a hypothesisproposed by Tadokoro et al. (1999). This idea is based on the observationof the M 7.2 1995 Hyogo-ken Nanbu (Kobe) earthquake, Japan.After the Hyogo-ken Nanbu earthquake, a temporal change was detectedin the direction of faster shear wave polarization in 2–3 years after the mainshock (Tadokoro, 1999). Four seismic stations were installed within andnear the fault zone at Kizanlik where the fault offset was 1.5 m, about80 km to the east of the epicenter of the Kocaeli earthquake. Theobservation period was from August 30 to October 27, 1999. Preliminaryresult shows that the average directions of faster shear wave polarization attwo stations were roughly parallel to the fault strike. We expect that thedirection of faster shear wave polarization will change to the same directionas the regional tectonic stress reflecting fault healing process. We havealready carried out a repeated aftershock observation at the same site in2000 for monitoring the fault healing process.     

Initial rupture process of microearthquakes recorded by high sampling borehole seismographs at the Nojima fault, central Japan

We analyze high sampling waveforms of the initial part of P-wave recorded at the 1800-m-deep borehole seismographs at the Nojima fault from December 1999 to May 2000 to clarify the initial rupture process of microearthquakes. We select 12 events with high S/N, whose magnitudes range from −0.3 to 2.2 and hypocentral distances from 1 to 11 km. We adopt the two different source models by Sato and Hirasawa (1973) and by Sato and Kanamori (1999). The former (model by Sato and Hirasawa (SH model)) generates only a ramp-like onset of velocity pulse. The later (model by Sato and Kanamori (SK model)) is able to generate a weak initial phase that is controlled by a trigger factor and the length of pre-existing crack. We perform the waveform inversion to estimate the optimum source parameters of each model. Waveforms of 5 of the 12 events are clearly reproduced by both SH model and SK model with a large trigger factor and a small length of pre-existing crack. The others are explained by not SH model but only SK model with a small trigger factor and a large length of the pre-existing crack, indicating that the weak initial phase is a nucleation phase and reflects the source process. These seven events satisfy roughly a relation that a large event has a large length of the pre-existing crack; the final crack length is proportional to the length of the pre-existing crack.     

Seismic observations in the DPRI 1800 m borehole drilled into the Nojima Fault zone, south-west Japan

Abstract Seismometers were installed at three depths in the Disaster Prevention Research Institute, Kyoto University (DPRI) 1800 m borehole drilled into the Nojima Fault zone, southwest Japan. The waveforms recorded by these seismometers are rather simple compared with those recorded at the DPRI 800 m borehole or on the ground surface. These data should be well suited for detecting fault zone-trapped waves and estimating the fault zone structure and its temporal variation related to the healing process of the ruptured fault. Typical waveforms trapped in the fault zone were observed by a surface seismographic array across the Nojima Fault just after the 1995 Hyogo-ken Nanbu earthquake (Kobe earthquake). Among the wave data recorded in the DPRI 1800 m borehole, however, clear evidences of fault zone-trapped waves have not yet been found, and further studies are continuing. The present study outlines the observation system in the DPRI 1800 m borehole, which will make it easier to access and analyze the borehole data.     

Crustal Heterogeneity in the Source Region of the 2004 Mid Niigata Prefecture Earthquake: Inversion Analysis of Coda Envelopes

The 2004 Mid Niigata Prefecture earthquake (M_JMA 6.8) and its aftershock sequences generated complicated, i.e., several conjugate fault planes in their source region. In order to understand the generating process of these earthquakes, we estimated a 3-D distribution of relative scattering coefficients in the source region. The large slip area during the main shock rupture seems to be bounded by strong heterogeneous zones with larger scattering coefficients. Hypocenters of the main shock and major large aftershocks with M 5-6 classes tend to be located close to stronger scattering areas. We found that one of these strong heterogeneities already existed before the occurrence of the M 5.9 aftershock on November 8. We suppose that heterogeneous structures in the source region of this earthquake sequence affected the initiation and growth of ruptures of the main shock and major large aftershocks.     

Seismicity changes related to a water injection experiment in the Nojima Fault Zone

Abstract A water injection experiment was carried out by the scientific drilling program named the 'Nojima Fault Zone Probe' during the two periods 9–13 February and 16–25 March 1997. The pumping pressure at the surface was approximately 4 MPa. The total amount of injected water was 258 m³. The injection was made between depths of 1480 m and 1670 m in the Disaster Prevention Research Institute, Kyoto University (DPRI) 1800 m borehole drilled into the Nojima Fault zone. A seismic observation network was deployed to monitor seismic activity related to the water injections. Seismicity suddenly increased in the region not far from the injection hole 4 or 5 days after the beginning of each water injection. These earthquakes were likely to be induced by the water injections. Most of the earthquakes had magnitudes ranging from −2 to +1. Numerous earthquakes occurred during the first injection, but only one could be reliably located and it was approximately 2 km north of the injection site. Between the two injection periods, earthquakes concentrated in the region approximately 1 km northwest of the injection site. During and after the second injection experiment, earthquakes were located approximately 1.5 km west of the injection site. Those earthquakes were located approximately 3 km or 4 km from the injection point and between 2 km and 4 km in depth. Values of intrinsic permeability of 10⁻¹⁴–10⁻¹⁵ m² were estimated from the time lapse of the induced seismic activity. The coefficient of friction in the area where the induced earthquakes occurred was estimated to be less than 0.3.