电感耦合等离子体发射光谱法测定铀矿石尾渣标准物质中9种痕量元素

样品经ＨＦ－ＨＮＯ３－ＨＣｌＯ４分解，在２ｍｏｌ／ＬＨＮＯ３介质中，采用感耦等离子体光电直读光谱法对铀矿石尾标准物质中的Ａｓ、Ｂａ、Ｂｅ、Ｃｄ、Ｃｒ、Ｎｉ、Ｐｂ等和Ｓｎ进行定值分析。同一样品平行测定６次，其各元素的相对标准偏差在２％－１０％。分析结果均落在标准值的置信区间。     

硅酸盐氧同位素标样研制

本文介绍了硅酸盐氧同位素标准物质(SH和H)的研制。均匀性检验证实该标准物质是均匀的。该标准物质采用直接比较测量法标定,即直接与国际标准V-SMOW和SLAP进行比较。 国际标准水样采用CO_2-H_2O平衡法制备CO_2;石英标样采用BrF_5法制备CO_2。将六个定值实验室提供的数据统一处理后,获得SH和H的δ~(18)Ox/v-s_(MOW)值分别为11.11±0.06(‰)和-1.75+0.08(‰)。该标准物质于89年12月被国家技术监督局批准为国家一级标准物质,山阳石英标样(SH)统一编号为GBW04409,浒坑石英标样(H)为GBW04410。     

广东化州大坡高岭土矿的物质成分和矿物学特性及其对造纸应用的影响

广东化州大坡高岭土矿属花岗岩风化残积型矿床,矿石矿物成分简单,以高岭石和石英为主,两者在粒级分布上差异明显,很易分选。精选后的高岭土中,高岭石含量可达91%,石英为1%以下。高岭石有序度较高,晶形规则,大多以叠片状和蠕虫状产出,但经机械处理后大部分可剥离成细小的高岭石单晶。矿石化学成分中Fe2O3,TiO2含量低,使高岭土具有较高的自然白度。造纸涂布试验表明高岭土的涂布性能良好,涂布纸具较高的平滑度,但涂料粘度偏高,这些性能和高岭石的矿物学特征有关。     

华南花岗岩物源成因特征与陆壳演化

华南不同时代的花岗岩按物质来源及成因可划分为:幔源(分异)系列:幔-壳混源(同熔)系列;壳源改造(重熔)系列和幔-壳混源碱性系列等四个不同的系列,简要阐述了划分四类系列的岩石学、地球化学的依据。侧重根据Sm-Nd、Rb-Sr同位素成分,以二元混合模型计算了花岗岩源区物质组成中,上壳和亏损地幔组份各占的比例。在此基础上探讨了不同物源成因系列花岗岩形成与华南陆壳演化的内在联系:东安、雪峰旋回褶皱系阶段花岗岩物源成因类型比较多样,有幔源(分异)系列、不成熟壳源、成熟壳源改造(重熔)系列等;加里东,海西期以陆壳改造(重熔)系列为主;印支、燕山期活化区(地洼)阶段,在地幔活化激发下,中国东部陆缘形成幔—壳混源(同熔)系列花岗岩和相应的火山岩;但沿内部断裂带,在壳下地幔热传输及构造作用下引起陆壳重熔,形成属于壳源改造(重熔)系列花岗岩。同位素的研究证明了:地洼阶段的构造-岩浆活动主要动力是来自壳下地幔的活化。     

安徽铜陵地区含金硫化物矿床成矿作用

铜陵地区位于华中地洼区,苏鄂地洼系。具工业价值的金矿床多赋存于地洼期次一级构造以及它们的交汇处,这是本区构造控矿的特点。近矿围岩以地台型碳酸盐岩为主,矿体明显受地层层位控制。与矿化有关的侵入岩,主要形成于地洼期(燕山早、中期)。岩体形成后叠加了成矿热液的多次活动。金的成矿作用及金矿床的形成,通常与含金丰度相对较高的地台构造层有密切的成因联系,它们提供了重要的物质来源,可认为是矿源层(Source beds)。本区各主要矿床是以地洼型岩浆期后热液作用为主的多因复成层控含金硫化物矿床。     

Test of Hack's slope to bed material relationship in the Southern Eifel Uplands,Germany

The local reach gradient of small gravel bed rivers (drainage area 0-8-110 km²) in the Eifel, West Germany, is adjusted to transport the river bed sediments. Transport of gravel becomes possible under high flow conditions (Shields entrainment factor ≈-03). Mean bed material size for riffle sections increases with distance downstream. For small drainage areas channel slope is a negative exponential function of drainage area, while for the larger region the additional influence of bedload size has to be considered. Good agreement with Hack's data (1957) for Virginia and Maryland, U.S.A., is achieved (S = 0.0066 (D₅₀/A)^{- 40.}, r = 0.67).     

参考大气在中期天气预报和气候模拟中的应用

本文概述了根据应用参考大气概念提出的参考大气谱模式计算格式（或称静力扣除法）在国内外一些气象机构的中期天气预报、后处理和四维同化、以及气候模拟中的应用。计算表明，这种参考大气谱模式计算格式，能有效的减少截谱误差，明显地改进中期天气预报和气候模拟。     

图像获取条件对SPOT景像的影响

图像获取条件对ＳＰＯＴ景像的构成有极大影响，也直接影响对ＳＰＯＴ图像的处理方法。ＳＰＯＴ图像的辅助数据在解析或数字处理中有重要应用。本文对ＳＰＯＴ卫星与视点间的地心角、节距角ω卫星与视点的纬度差异、景像方位角Ｔ、景像尺寸和ＳＰＯＴ图像格网参考系统ＧＲＳ中（Ｋ，Ｊ）与（λ， Ｂ）换算公式进行了推证和分析，并以ＳＰＯＴ辅助数据验证了（Ｋ，Ｊ）与（λ，Ｂ）换算的精度。     

The New Meteorite Fall of Yanzhuang—A Severely Shocked H6 Chondrite with Black Molten Materials

At 21:45 hr (Beijing time) on Oct. 31, 1990 the Yanzhuang meteorite hit the ground at the Yanzhuang village, Wenyuan County, Guangdong Province. Several fragments, totalling 3.5 kg, were recovered during the field survey. This meteorite is a rare one of its kind due to its heavily shocked features and thick veins made up of black molten materials. Olivine and low-calcium pyroxene are compositionally homogeneous with Fa=18.59, Fs=16.35 and Wo=1.29. The chemical composition (total Fe=28.0%) and recrystallized texture of the chondritic mass show that the Yanzhuang is an H6 chondrite. The black molten materials occur in the form of blocks (up to 2×3×4 cm in size) and veins (0.1–15 mm in width), and contain a lot of rounded and elliptic FeNi-FeS blobs (up to 6–10 mm in length). The metal in these blobs exhibits distinct dendritic structure characteristic of rapid cooling. Unmolten and molten samples are very similar in chemical composition, fitting well with the average H-chondrites. Partial melting and FeNi/FeS-silicate separation have not been observed in the molten materials of the Yanzhuang. This project was financially supported by the Science Foundation of Guangdong Province.     

On the enhanced confining pressure aproach to the mechanics of reinforced soil

Summary A review is presented of conceptual approaches that are currently in use for interpreting the operation of reinforced soil. The concepts of enhanced confining pressure and of reduced normal tensile strains are found to be closely related to current experimental and theoretical investigations as well as to the design methodologies available at present for reinforced soil applications. Focusing on the enhanced confining pressure concept, analytical expressions are developed that allow the estimation of the value of equivalent confining stress increase when the properties of soil and reinforcement and the state of stresses acting on a cylindrical reinforced soil element are known. The derived expressions can also be utilized for estimating the soil-reinforcement friction angle from the results of triaxial tests on cylindrical samples reinforced with horizontal layers of reinforcement.