Gold Mineralization and Occurrence of Sinter in the Hoshino Area, Fukuoka Prefecture, Japan

Abstract. Several epithermal gold deposits occur in the Hoshino area, which is located in the western end of the late Cenozoic Hohi volcanic zone, north‐central Kyushu, Japan. The area is characterized by intermediate to felsic extrusive rocks of Pliocene age. In the Hoshino area, the shallow manifestation of the hydrothermal activity is exposed on the surface. Several outcrops of sinter are still preserved on the top of hydro thermally altered volcanic rocks, and high‐grade gold‐bearing quartz veins occur on the surface at lower levels. The hydrothermal alteration resulted into well‐developed alteration zones. The zonal alteration pattern, primarily of near‐neutral pH type, is characterized by the outer smectite zone of a lower temperature, and the inner mixed layer minerals zone of a higher temperature. Quartz vein‐related or fracture‐controlled alteration, is represented by the occurrence of interstratified illite/smectite and K‐feldspar, suggesting a potassium‐enriched alteration. The mineralization in the Hoshino area is recognized on the surface by the occurrence of gold‐bearing quartz veins distributed mainly in the mixed layer minerals zone. The fracture system related to the gold mineralization is mainly characterized by NW‐SE trend. The alteration pattern and the mineralogical composition of the veins suggest that the mineralizing fluids had near‐neutral pH and the mineralization is of low‐sulfidation‐type. Fluid inclusion data and textures observed in quartz veins indicate that gold precipitated during boiling. The chemical composition of quartz veins shows that high‐grade gold‐bearing quartz veins are characterized by higher content of Al₂O₃, K₂O and Rb. Several outcrops of silica‐sinters are distributed on the top of the mixed layer minerals zone. Although their structures are not very well preserved, because of later silicification, the Hoshino sinters still show characteristic textures identical to those observed in modern sinters, such as the presence of plant fossil incorporated into the sinters, the strongly developed depositional laminations and the columnar structures perpendicular to the depositional surfaces. Quartz is the only silica mineral constituting the Hoshino sinters presently. The conversion of amorphous silica into quartz was probably governed by higher temperatures resulting from later hydrothermal activity. This later hydrothermal activity is reflected by the intense silicification affecting mainly the lower parts of the sinters and also by the presence of quartz veins cutting the sinters. The distribution of sinters in the Hoshino area is very significant. The presence beneath the sinters of concealed high‐grade gold‐bearing quartz veins should be highly considered and exploration work is strongly suggested.     

Timing of Fracture Formation and Duration of Mineralization at the Hishikari Deposit, Southern Kyushu, Japan

Abstract. The Hishikari epithermal gold deposit consists of the Honko-Sanjin zone and Yamada zone. On the basis of observed crosscutting relationships of veins, vein system in the Hishikari deposit was classified into the early and late veins. They differ from orientation, width, control by unconformity, the amount of displacement and structural features, but have similarity in gold grade and Au/Ag ratios. K-Ar ages are presented for the classified veins to clarify timing of fracturing and duration of mineralization.
Age determination revealed that the early veins in the Honko-Sanjin zone range from 0.86 to 1.11 Ma and that the late veins range from 0.73 to 0. 84 Ma. The economically most important mineralization in the Hishikari deposit occurred around 0.90 Ma in a very short period (about 0.05 million years).
The distribution of mineralization age in the whole Hishikari deposit, occurrences of slickensides and ground water temperatures imply that mineralization lasted longer in the southern part of the deposit. As compared the early veins with late veins, structural changes including width, strike, dip and vein characteristics occurred at around 0.85 Ma.     

云南兰坪北部铜多金属矿化区成矿流体流动与矿化分带——流体包裹体和稳定同位素依据

滇西兰坪盆地北部发育了一类受逆冲推覆构造控制的浅成热液Cu—Ag—Pb-Zn矿化，形成了白秧坪、富隆厂、吴底厂、麻栗坪及金满、科登涧等大-中型矿床和矿点，并存在矿化分带。文章利用这些矿化脉体的流体包裹体和热液方解石的碳氧同位素组成资料，研究成矿流体与矿化分带的关系。结果表明，成矿流体主要属于NaCl-H2O成分体系，盐度ω(NaCleq)为2％～11％，形成温度为170～300℃，形成于1．8～3．8km深度内，这些相似性说明这类矿化的发生具有相似的流体性质和沉淀机制。热液方解石在δ^13C-δ^18O图解中呈近水平线展布的型式，指示流体源自地壳浅部的地下水系统，与海相灰岩等围岩作用形成了溶解碳以[HCO3^]-为主的成矿流体，流体与岩石的相互作用可能是成矿流体沉淀的主要机理。从西到东，流体包裹体的盐度-温度由高到低变化与矿化分带和逆冲推覆构造的根带→中带→锋带相配套，显示重力驱动流动可能是主要的流体流动机制。成矿流体在不同构造部位流动的通畅及流体．岩石系统的封闭-开放程度等流体流动性质与矿化发生的强度和规模有关，兰坪北部逆冲推覆构造中带的流体通畅地流动及沉淀时处于相对开放状态，有利于该区形成较大规模的浅成热液多金属矿化。     

锡铁山铅锌矿地质特征、矿床成因及找矿标志

通过找矿工作的实践，认为锡铁山铅锌矿床是由火山喷流沉积—后期热液叠加改造富集的块状硫化物多金属矿床。区域上NW—SE向早古生代形成的裂谷带，三级盆地内沉积的晚奥陶世滩间山群的大理岩与绿片岩系是表区找矿的最佳区段。而绢云绿泥斜长片岩、含碳质绢云绿泥片岩、白色大理岩、条带状大理岩是铅锌矿的最重要的找矿标志。     

李坝式金矿床成矿作用及矿床类型探讨

李坝式金矿床成矿作用过程分为成矿元素初始富集期和构造叠加热液改造成矿期，岩浆活动主号是通过改变矿床地质体物化条件而促进矿化体的形成，并有部分岩浆物质参与成矿。该矿床与国内外经典卡林型金矿床具有较大的可比性，但是由于缺乏低温矿物组合以及与岩浆活动的亲密性证据，该矿床应属广义上的卡林型金矿床。     

公婆泉盆地局部排泄源氧化还原属性与铀矿化关系探讨

在系统分析公婆泉盆地地质背景、水文地质条件的基础上，对该区局部排泄源氧化还原属性与铀矿化的关系进行了探讨。研究结果表明，局部排泄源的存在对铀矿化具有重要作用，当局部排泄源属于还原性质时，铀矿体常常分布于该排泄源上游；若属氧化性质，排泄源铀矿体通常位于其下游或附近。公婆泉盆地存在相对氧化和相对还原的二种局部排泄源，北骆驼泉区的沙泉沟与平沙地、麻黄沟、北骆驼泉沟排泄源之间应为有利的铀矿化地段。     

灵山岩体演化特征及其与稀有金属的成矿关系

从岩体时空分布、岩石化学成分、造岩矿物、副矿物、微量元素、稳定同位素、成岩温度、压力等特征，论述了灵山岩体演化与钽铌等稀有金属成矿的关系，简述了区内典型稀有金属矿床主要成矿地质特征及其与岩体的成因联系，进而肯定了区内钽铌等稀有金属找矿的良好前景，并提出了今后找矿的方向和建议。     

陕川丁家林-太阳坪金矿带成矿机理

丁家林-太阳坪金矿带与丁家林-太阳坪脆-韧性剪切带同位分布、同能源作用、同步生成，是脆-韧性剪切变形形成的石英脉型金矿，总体走向NE，主要由丁家林和太阳坪2个金矿床组成，分石英单脉、单脉密集带、复脉带3个亚型。丁家林以含Au石英复脉为主，太阳坪以含Au石英单脉为主；成矿物质来源于富含Si质的志留系黄坪组，成矿流体主要是构造水；内生成矿作用分脆．韧性剪切变形-构造分异热液期和韧-脆性剪切变形-构造分异热液期，与2期脆-韧性剪切变形相对应，第2期为主成矿期。其成矿机理是脆-韧性剪切变形动力成岩成矿。     

骑田岭北部地区锡多金属矿成矿特征及找矿潜力分析

在介绍骑田岭北部地区成矿地质环境的基础上，概述了区内两种主要矿床类型－－矽卡岩型钨钼矿及热液充填交代型锡铅锌矿的成矿地质特征，进而总结了区内矿床的成矿规律和预测标志。认为该区矿质来源丰富，矿体严格受岩体和构造控制，据此提出了进一步找矿方向的建议。     

Isotopic Ages of the Carbonatitic Volcanic Rocks in the Kunyang Rift Zone in Central Yunnan, China

The Mesoproterozoic Kunyang rift, which is located on the western margin of the Yangtze platform and the southern section of the Kangdian axis, is a rare massive Precambrian iron-copper polymetallic mineralization zone in China. The Mesoproterozoic Wulu (Wuding-Lufeng) basin in the middle of the rift is an elliptic basin controlled by a ring fracture system. Moreover, volcanic activities in the basin display zonation of an outer ring, a middle ring and an inner ring with carbonatitic volcanic rocks and sub-volcanic dykes discovered in the outer and middle rings. The Sm-Nd isochron ages have been determined for the outer-ring carbonatitic lavas (1685 Ma) and basaltic porphyrite of the radiating dyke swarm (1645 Ma) and the Rb-Sr isochron ages for the out-ring carbonatitic lavas (893 Ma) and the middle-ring dykes (1048 Ma). In combination of the U-Pb concordant ages of zircon (1743 Ma) in trachy-andesite of the corresponding period and stratum (1569 Ma) of the Etouchang Formation, as well as the Rb-Sr iso