陆坡非旋转重力羽状流的数值模拟

借助MITgcm模式使用二维非静力近似在水平方向采用不等间距网格,模拟了陆坡非旋转重力羽状流的流动。模拟显示陆坡上的重力羽状流的运动比较复杂。通过数值实验,发现改变地形或调整冷源强度都会影响沿陆坡下沉的低温高密度水的羽状流形态,潮汐亦会对重力羽状流有一定的影响。经计算发现在陆坡处,Richardson数小于1/4,宜发生Kelvin-Helmholtz不稳定性,并由卷挟导致环境流体与高密度流体混合,沿着斜坡加速下滑。     

水成沉积与风成沉积及古土壤的磁组构特征

晚第四纪水成沉积、风成沉积、古土壤等的磁组构研究表明,不同成因的沉积物具有明显不同的磁组构特征。一般地,水成沉积的体积磁化率Ｋ受物源和水动力因素控制,Ｐ和Ｆ均＞１．０２,ｑ＜０．５;风成沉积的Ｋ受物源控制,内陆黄土的Ｋ明显高于沿海黄土及海岸风沙Ｋ,Ｐ和Ｆ均＜１．０２,ｑ的平均值＞０．５５;古土壤的Ｋ受母质沉积类型和成土环境的氧化还原条件控制,内陆古土壤的Ｋ偏高,沿海古土壤的Ｋ偏低,内陆古土壤的Ｋ远高于沿海古土壤的Ｋ,Ｐ和Ｆ均＜１．０２,ｑ的平均值在０．５左右。运用典型沉积的磁组构特征对比分析未知沉积物,可以得到未知沉积物的物源、沉积过程和环境信息。     

In-Situ Observation of Fluid Mud in the North Passage of Yangtze Estuary, China

Observations of fluid mud were made in the lower North Passage of the Yangtze Estuary in February 2000, on 10 -11 August 2000, on 30 - 31 August 2000 (after two strong typhoons), on 21 - 24 August 2000 (neap tide) and on 3 -6 September 2000 (mean tide) respectively. In situ data show that the fluid mud in this area consists of fine cohesive sediment (median size 7.23 μm). The formation and movement of fluid mud varied during the neap-spring and flood-ebb tidal cycle. Observations suggest that fluid mud phenomena in this area may be categorised in a three-fold manner as slack water, storm and saltwedge features. The thickness of the fluid mud layer of slack water during the neap tide ranged from 0.2 to 0.96 m, whereas during the mean tide, the thickness ranged from 0.17 to 0.73 m, and the thickness of the fluid mud layer was larger during slack water than at the flood peak. Shoals cover an area of 800 km^2 with a water depth smaller than 5 m. Erosion of these extensive intertidal mudflats due to storm action provides an abundant sediment source. This is particularly significant in this estuary when the tidal level is lower than 5 m. The lower North Passage is a typical zone of saltwater wedging, so the saltwedge fluid mud has the most extensive spatial range in the estuary.     

深水网箱投饵机设计与试验研究

根据网箱养殖的特点,结合网箱养殖的经验,设计了1种深水网箱投饵机,并进行了相应的试验,测定了不同情况下产生的真空度以及在冲饵管和吸饵管不同开度时的下料时间。此投饵机使用水力环流供饵、水力抽负吸饵、水动力投饵,充分利用了丰富的海水资源,用汽油机水泵作动力,利用管道将饵料抛向网箱,可向多个、距离不同的网箱供饵。作为1种新的投饵机具,可用于网箱养鱼和池塘养鱼的投饵。     

渤海南部表层沉积的相特征

通过海上调查及实验室分析,查明渤海南部表层沉积物在结构类型、矿物组合、生物组分及沉积构造等相特征方面具有明显的分区性。渤海南部存在五种沉积相:黄河水下三角洲相、陆架盆地相、海湾相、潮流浅滩相及古滨岸相。黄河水下三角洲相从河口延至水深15—20米处,沉积速率很高,沉积物富含碎屑云母及CaCo_3。陆架盆地相的沉积为粉砂质粘土,具有生物扰动构造。     

A Note on Tsunami Bore Front

A note is presented on tsunami bore front. This tsunami bore front is an old dynamical problem but also a new problem to be understood. The tsunami event on 2004 December 26 has raised this is an urgent problem. The author introduces here a model in order to see a hydrodynamical specific property of the tsunami bore front. This modeling gives us a new understanding about what mechanics is for the interested tsunami bore front, especially, around a coastal zone. This work adds a new understanding about mechanics of water motions as the tsunamis generated by the earthquake undersea at a distant area from the coast. The model in this work points out a specific transitional pattern as a function of time and space of tsunami bore front. This modeling gives what is essential at considering tsunami bore front.     

The Effect of Internal Fluid on the Response of Vortex-Induced Vibration of Marine Risers

Based on Iwan‘s wake oseillator model developed with the classical van der Pol equalion, the differential equation for the response of the vortex-induced vihration (VIV) of the riser considering the effect of the internal flowing fluid and the external marine environmental condition is derived. The effect of the intermal flowing fluid on the response of VIV of the riser is studied by means of the Finite Element Method. The results show that the effect of the internal fluid velocity on the VIV of the riser is strong when the natural frequency of the riser is close to the vortex shedding frequency. In addition, the increase of the top tension can decrease the sensitivity of the riser to the internal fluid velocity.     

Salt Diapirs, Salt Brine Seeps, Pockmarks and Surficial Sediment Creep and Slides in the Canary Channel off NW Africa

Circular to elliptical mounds in the Canary Channel with reliefs of 75 to 375 m and diameters of 4 to 8 km partially surrounded by moats with reliefs of 25 to 75 m, were formed by piercement of the seafloor by Mesozoic evaporites. Several long gullies, < 1km wide, with abrupt terminations and pockmarks associated with these mounds were probably eroded by dense brine and hydrocarbon seeps. The salt brines that eroded the gullies were formed where salt diapirs intersect the seafloor, or in the subsurface by circulating ground water heated by igneous activity along the Canary Ridge. If the brines originated in the subsurface they reached the seafloor along faults. Displacement of the surficial sediments by sliding and creep is probably the result of the expulsion of hydrocarbons and/or vertical motion of the Mesozoic evaporites. Microtopographic features along or near the east flank of the Canary Ridge are the creation of uplift of the ridge, hydrothermal activity, mass wasting processes and turbidity currents.     

Experimental Investigation of Instantaneous Properties of Wave Slamming on the Plate

The purpose of this paper is to investigate the instantaneous properties of wave slamming on the plate structure of an open structure.The advanced instantaneous measuring technique-Particle Image Velocimetry(PIV) is applied to acquire the instantaneous velocity field of wave slamming.From the cross-correlation analysis results of the images captured by the CCD camera,the flow fields of wave impacting on the structure are displayed visually,and the instantaneous whole-field fluid velocity vectors are obtained.The relation between the instantaneous peak impacting pressures and the instantaneous velocities of water particles is studied by probability analysis.     

Theoretical aspects of cap-rock and fault seals for single- and two-phase hydrocarbon columns

Cap-rock seals can be divided genetically into those that fail by capillary leakage (membrane seals) and those whose capillary entry pressures are so high that seal failure preferentially occurs by fracturing and/or wedging open of faults (hydraulic seals). A given membrane seal can trap a larger oil column than gas column at shallow depths, but below a critical depth (interval), gas is more easily sealed than oil. This critical depth increases with lower API gravity, lower oil GOR and overpressured conditions (for the gas phase). These observations arise from a series of modelling studies of membrane sealing and can be conveniently represented using pressure/ depth (P/D) profiles through sealed hydrocarbon columns. P/D diagrams have been applied to the more complex situation of the membrane sealing of a gas cap underlain by an oil rim; at seal capacity, such a two-phase column will be always greater than if only oil or gas occurs below the seal.These conclusions contrast with those for hydraulic seals where the seal capacity to oil always exceeds that for gas. Moreover, a trapped two-phase column, at hydraulic seal capacity will be less than the maximum-allowed oil-only column, but more than the maximum gas-only column. Unlike membrane seals, hydraulic seal capacity should be directly related to cap-rock thickness, in addition to the magnitude of the minimum effective stress in the sealing layer and the degree of overpressure development in the sequence as a whole.Fault-related seals are effectively analogous to membrane cap-rocks which have been tilted to the angle of the fault plane. Consequently, all of the above conclusions derived for membrane cap-rocks apply to both sealing faults sensu stricto (fault plane itself seals) and juxtaposition faults (hydrocarbon trapped laterally against a juxtaposed sealing unit). The maximum-allowed two-phase column trapped by a sealing fault is greater than for equivalent oil-only and gas-only columns, but less than that predicted for a horizontal membrane cap-rock under similar conditions. Where a two-phase column is present on both sides of a sealing fault (which is at two-phase seal capacity), a deeper oil/water contact (OWC) in one fault block is associated with a deeper gas/oil contact (GOC) compared with the adjacent fault block. If the fault seal is discontinuous in the gas leg, however, the deeper OWC is accompanied by a shallower GOC, whereas a break in the fault seal in the oil leg results in a common OWC in both fault blocks, even though separate GOC's exist. Schematic P/D profiles are provided for each of the above situations from which a series of fundamental equations governing single- and two-phase cap-rock and fault seal capacities can be derived. These relationships may have significant implications for exploration prospect appraisal exercises where more meaningful estimates of differential seal capacities can be made.The membrane sealing theory developed herein assumes that all reservoirs and seals are water-wet and no hydrodynamic flow exists. The conclusions on membrane seal capacity place constraints on the migration efficiency of gas along low-permeabiligy paths at depth where fracturing, wedging open of faults and/or diffusion process may be more important. Contrary to previous assertions, it is speculated that leakage of hydrocarbons through membrane seals occurs in distinct pulses such that the seal is at or near the theoretically calculated seal capacity, once this has been initially attained.Finally, the developed seal theory and P/D profile concepts are applied to a series of development geological problems including the effects of differential depletion, and degree of aquifer support, on sealing fault leakage, and the evaluation of barriers to vertical cross-flow using RFT profiles through depleted reservoirs. It is shown that imbibition processes and dynamic effects related to active cross-flow across such barriers often preclude quantitative analysis and solution of these problems for which simulation studies are usually required.