Trichodesmium erythraeum (Ehrenberg) bloom along the southwest coast of India (Arabian Sea) and its impact on trace metal concentrations in seawater

The incidence of a large scale Trichodesmium erythraeum bloom along the southwest coast of India (Arabian Sea) observed in May 2005 is reported. Around 4802 filaments of T. erythraeum ml⁻¹ seawater was observed and a colony consisted of 3.6 × 10⁵ cells. The bloom was predominant off Suratkal (12° 59′N and 74° 31′E) with a depth of about 47 m, covering an area of 7 km in length and 2 km width. The concentrations of Zinc, Cadmium, Lead, Copper, Nickel and Cobalt were determined in samples collected from the bloom and non-bloom sites using stripping voltammetry. The observed hydrographical and meteorological parameters were found to be favorable for the bloom. The concentrations of Zinc, Cadmium and Nickel were found to be higher at bloom stations, while the concentrations of Lead, Copper and Cobalt were found to be very low at bloom stations. Elevated concentrations of Cadmium and Cobalt were observed at Valappad mainly due to the decomposition of detrital material produced in the bloom. Statistically significant differences (P > 0.01) in metal concentrations between the bloom and non-bloom stations were not observed except for Copper. Metals such as Lead, Copper and Cobalt were removed from the seawater at all places where bloom was observed. Cadmium was found to be slowly released during the decaying process of the bloom.     

黄河三角洲造陆速率对夏季风强度变化和人类活动的响应

以夏季风强度指数和年均气温作为反映气候变化的指数,以人类净引水量和流域水土保持面积作为反映人类活动变化的指标,并以黄河流域为例,研究了三角洲造陆对气候变化和人类活动的响应.研究表明,夏季风强度指数的变化可分为三个阶段:(1)在1951~1963年夏季风强度指数呈持续增强的变化趋势;(2)在1963~1965年夏季风强度指数呈突变式减弱;(3)在1966~2000年夏季风强度指数保持在较低的水平上,且呈缓慢减弱的趋势.年降水量变化与夏季风强度指数有同步关系.从1950到1970年的年均温度在波动中略呈降低趋势,然而从1970年开始年均温度在波动中具有持续上升的趋势.气候变化会导致入海泥沙通量的变化,并可能进一步导致三角洲造陆速率的变化.黄河三角洲造陆速率、入海泥沙通量在1952~1964年均呈增大的趋势,1964年后则呈减小的趋势,在总体上与夏季风强度指数的变化趋势相同.除了气候变化以外,流域水土保持和引水对三角洲造陆也有影响.多元回归分析表明,三角洲造陆速率随夏季风强度指数的减弱而减小,随年气温的升高而减小,随梯田林草面积的增加而减小,随年净引水量的增加而减小,同时还表明,夏季风强度指数、年均气温、水土保持措施面积和人类净引水量对三角洲造陆速率变化的贡献率分别为34.94%,3.80%,53.82%和7.44%.表示气候变化的两个变量的贡献率之和为38.7%,说明气候变化对黄河三角洲造陆过程的影响是不容忽视的.     

利用臭氧氧化发光光谱特征检测水质污染

利用不同的污染物质在被臭氧氧化时发光特性不同的原理检测水质污染。检测出来的发光光谱与不同污染源的特征光谱进行对比,辅助发光时序等特征,检测几种污染物的含量和确定污染源。对涉及的有关技术问题进行了探讨。     

罗氏沼虾育苗用水中Mg2+与Ca2+含量及Mg2+/Ca2+对出苗率的影响

１９９１年３－６月和１９９２年３－６月在南汇县东海水产养殖公司对罗氏沼虾育苗用水调配原则与不同基础水的调配方法进行试验研究。结果表明，育苗用水中Ｍｇ＾２＋与Ｃａ＾２＋含量及Ｍｇ＾２＋／Ｃａ＾２＋必须达到一定的范围，这是调配的基本原则。以鱼塘水作基础水时，需添加６种化学药品，其中Ｍｇ＾２＋与Ｃａ＾２＋含量可适范围分别为３００．０－４４０．０ｍｇ／Ｌ与１７０．０－２４４．０ｍｇ／Ｌ，Ｍｇ＾２＋／Ｃａ＾     

Action of Cnoidal Waves on Vertical Walls

Based on the 2nd order cnoidal wave theory, the characters of shallow water standing waves and their action on vertical walls are studied in this paper. The theoretical expressions of the wave surface elevation in front of and the wave pressure on the vertical wall are obtained. In order to verify the theoretical results, model tests were made in the State Key Laboratory of Coastal and Offshore Engineering at DUT. For the wave surface elevation in front of the wall and the wave forces on the wall at the moment when the wave surface at the wall surface goes down to the bottom of the wave trough, the calculated results coincide quite well with the experimental results. For the wave forces on the wall at the moment when the wave surface at the wall surface goes up to the top of the wave crest, the theoretical expressions are modified by the experimental results. For the convenience of practical use, calculations are made for the wave conditions which usually occur in enginering practice by use of the inves     

压力传感器的自动标定技术

针对压力测量设备生产和维护过程中,对关键部件压力传感器标定处于手工操作状态、效率低、操作人员不易掌控、标定结果处置复杂的现状,开发了针对压力传感器的自动标定技术。该技术将计算机控制、智能化、曲线拟合和误差分析引入到压力传感器的标定过程中,大幅度提高了标定的效率和可靠性。经此技术标定过的压力探头,在使用中具有互换性,减轻了数据后处理工作的难度。     

海洋平台沉垫的波浪载荷试验研究

本文通过对海洋平台沉垫的波浪载荷试验研究分析，着重研究了在规则波中平台沉垫总体波浪载荷和局部水动压力分布的情况，定性地考察了非线性影响、浅水影响的重要性，为今后波浪理论中粘性的引入，进而考虑粘性与波浪运动的非线性相互干扰提供实测依据     

胶州湾海域水质预测

在已建潮流模型的基础上,用ADI法建立了胶州湾扩大域变动边界的平流—扩散输运模型,以COD为指示因子,预测了胶州湾海域1995年、2000年的水质、青岛环海公路海上段、沧口区北半部污水截流、北水南调、集中排放以及胶州湾西部经济开发对海域水质的影响等。为青岛市环保部门制定环保规划提供决策依据。     

Prediction of impact pressure induced by breaking waves on vertical cylinders in random seas

This paper presents a method to statistically predict the magnitude of impact pressure (including extreme values) produced by deep water waves breaking on a circular cylinder representing a column of an ocean structure. Breaking waves defined here are not those whose tops are blown off by the wind but those whose breaking is associated with steepness. The probability density function of wave period associated with breaking waves is derived for a specified wave spectrum, and then converted to the probability density function of impact pressure. Impacts caused by two different breaking conditions are considered; one is the impact associated with waves breaking in close proximity to the column, the other is an impact caused by waves approaching the column after they have broken. As an example of the application of the present method, numerical computations are carried out for a wave spectrum obtained from measured data in the North Atlantic.     

Scattering of Semidiurnal Internal Kelvin Wave at Step Bottom Topography

A three-dimensional, multi-level model was used to study the energy dissipation of semidiurnal internal Kelvin waves due to their interaction with bottom topography. A simplified topography consisting of a channel with an additional shallow bay was used to clarify the wave’s scattering process. When the first mode semidiurnal internal wave given at an open boundary arrives at the bay mouth, higher-mode internal waves are generated at a step bottom of the bay mouth. As a result, the energy of the first mode internal Kelvin wave is effectively decayed. The decay rate of the internal Kelvin wave depends on both the width and length of the additional bay. The maximum decay rate was found when a resonance condition occurs the bay, that is, the bay length is equal to a quarter of wave length of the first mode internal wave on the shallow region. The decay rate in the wide bay cases is higher than that in a narrow case, due to a contribution from the scattering due to the Poincare wave that emanates from the corners of the bay head. The decay rate with the additional bay is 1.1–1.8 times that of the case without the additional bay. The decay rate due to the scattering process is found to be of the same order as that of the internal and bottom friction.