四川稻城雄登寺-日霍脆韧性变形带的含矿性及其找矿意义

雄登寺-日霍脆韧性变形带呈近东西向展布,规模大。变形带内褐铁矿化蚀变强烈,化探异常发育,矿点、矿化点密集分布,成矿条件好,找矿潜力大。     

氧化锰矿物的生物成因及其性质的研究进展

土壤中的氧化锰矿物是原生矿物风化和成土过程的产物,是最具反应活性的一类矿物,决定着环境中许多物质的形态、迁移和转化,在元素生物地球化学循环中起着重要的作用,其形成机制和环境效应备受关注。已有的研究表明,环境中氧化锰的形成与微生物作用紧密相关,微生物作用可使自然环境中的Mn(Ⅱ)氧化速率提高105倍。参与Mn(Ⅱ)氧化的微生物在环境中广泛存在,已知的典型锰氧化细菌分布在变形菌门、放线菌门或厚壁菌门,它们均通过胞外聚合物中的多铜氧化酶来催化氧化Mn(Ⅱ)。细菌氧化Mn(II)成Mn(Ⅳ)是酶催化的两个连续的快速单电子传递过程,Mn(Ⅲ)在溶液中以与酶结合的瞬时中间态出现。生物形成氧化锰的最初形态为层状锰矿物,与δ-MnO2或酸性水钠锰矿很类似,且结晶弱,粒径小,锰氧化度高,结构中的八面体空穴多,因而比化学形成的氧化锰具有更强的吸附、氧化等表面活性。环境中Mn(Ⅱ)微生物氧化及形成的Mn(Ⅲ)中间体与碳、氮、硫等生命元素的地球化学循环的关系令人关注。     

Micromechanics of the velocity and normal stress dependence of rock friction

Among the second-order effects on friction the most important are those of variable normal stress and of slip velocity. Velocity weakening, which is usually considered the source of the stick-slip instability in rock friction, has been observed in velocity stepping experiments with Westerly granite. The friction change, , was –0.01 to –0.008 for a tenfold velocity increase. Using normal closure measurements, we observed dilation upon each increase in sliding rate. We also observed, for the first time, time-dependent closure between surfaces during static loading. The dilation that occurred during the velocity stepping experiment was found to be that expected from the static time-dependent closure phenomenon. This change in closure was used to predict friction change with an elastic contact model. The calculated friction change which results from a change in contact area and asperity interlocking, is in good agreement with the observed velocity dependence of steady-state friction. Variable normal stress during sliding has two effects, first in creating new partial slip contacts and locking some existing fully sliding contacts and second in increasing interlocking, for instance when normal load is suddenly increased. As a result, a transient change in friction occurs upon a sudden change in normal load.     

含煤层地质环境下地震波场的数值模拟

本文对含低速煤层地质环境下弹性波场多波多分量地震资料进行了二维数值模拟研究,对人工边界反射进行了有效处理,频散效应得到了有效的压制,对几种不同激发与观测排列方式下的弹性波资料进行了模型计算与分析。     

三江平原旱田耕作对湿地土壤理化性质的累积影响初探

在中国科学院三江平原湿地生态试验站综合实验场,对不同耕作年限的湿地土壤(0~20 cm)进行环境累积效应分析。结果表明,随着开垦时间的增加,土壤的理化性质发生渐变,物理性质方面,土壤容重和比重逐渐增大,而孔隙度和田间持水量逐年减少;化学性质方面,土壤pH值随开垦时间的增加而增加,有机质和其他养分则随开垦时间的增加而逐年降低。弃耕后土壤性质有所恢复。土壤性质在开垦初期变化较明显,而后逐渐变缓。     

Monte Carlo simulation of mixing in Ca3Fe2Ge3O12–Ca4Ge4O12 garnets and implications for the thermodynamic stability of pyrope–majorite solid solution

Static lattice energy calculations, based on empirical pair potentials, were performed for a large set of structures differing in the arrangement of octahedral cations within the garnet 2 × 2 × 2 supercell. The compositions of these structures varied between Ca₃Fe₂Ge₃O₁₂ and Ca₄Ge₄O₁₂. The energies were cluster expanded using pair and quaternary terms. The derived ordering constants were used to constrain Monte Carlo simulations of temperature-dependent mixing properties in the ranges of 1,073–3,673 K and 0–10 GPa. The free energies of mixing were calculated using the method of thermodynamic integration. The calculations predict a wide miscibility gap between Fe-rich (cubic) and Fe-pure (tetragonal) garnets consistent with recent experimental observations of Iezzi et al. (Phys Chem Miner 32:197–207, 2005). It is shown that the miscibility gap arises due to a very strong cation ordering at the Fe-pure composition, driven by the charge difference between Ca²⁺ and Ge⁴⁺ cations. The structural and thermodynamic analogies between Ca–Ge and Mg–Si systems suggest that a similar miscibility gap should exist between pyrope and Mg–Si-majorite.     

科尔沁沙地土地利用与耕作方式对土壤风蚀的影响

土壤风蚀造成的直接生态后果是土地资源的退化。在春播前两次沙尘暴事件中,对科尔沁沙地几种具有代表性的土地类型的土壤风蚀量及土壤特性进行了野外测定、分析,结果表明:(1)在同一沙尘暴天气下,由于土地利用和耕作方式的不同,土壤风蚀量存在着差异,新垦农地和翻耕农地的风蚀量显著高于未垦草地、免耕农地和麻黄地;免耕农地则与未垦草地的风蚀量相差不大,风蚀危害较轻;麻黄地几乎不受风蚀侵害。新垦农地、翻耕农地、免耕农地、未垦草地、麻黄地两次观测的土壤风蚀量平均值依次为24.59、15.60、2.26、1.46和0.22 g/h.cm2。(2)基于土壤特性计算的土壤退化指数结果表明,新垦农地和翻耕农地发生了较为严重的退化。     

Initiation and development of pull-apart basins with Riedel shear mechanism: insights from scaled clay experiments

Typical pull-apart structures were created in scaled clay experiments with a pure strike-slip geometry (Riedel type experiments). A clay slab represents the sedimentary cover above a strike-slip fault in the rigid basement. At an early stage of the development of the deformation zone, synthetic shear fractures (Riedel shears) within the clay slab display dilatational behaviour. With increasing basal displacement the Riedel shears rotate and open further, developing into long, narrow and deep troughs. The shear displacement and the low angle with the prescribed principal basal fault set them apart from tension gashes. At a more evolved stage, synthetic segments (Y-shears) parallel to the basal principal fault develop and accommodate progressive strike-slip deformation. The Y-shears connect the tips of adjacent troughs developed from the earlier Riedel shears, resulting in the typical rhomb-shaped structures characteristic for pull-apart basins. The Strait of Sicily rift zone, with major strike-slip systems being active from the Miocene to the Present, comprises pull-apart basins at different length scales, for which the structural record suggests development by a mechanism similar to that observed in our experiments.     

不同岩性火山岩力学性质实验研究

黄沙坨地区位于辽河断陷盆地东部凹陷中段,古近纪沙河街组第三段沉积时期发育了巨厚的火山岩,为该区形成火山岩油气藏奠定了成藏条件。由于油层岩石的力学性质,影响着油田生产,因此,经过实验室对不同岩性的火山岩力学性质的试验测试,得到油田生产所需的相关的力学参数及相关的地质信息,为油田勘探、开发及相关的工程设计发挥重要作用。试验结果表明,粗面岩以张性破裂为主,玄武岩以剪切破裂为主。这对油田研究水力压裂裂缝形态及储层天然裂缝形态提供了重要的地质依据。软化系数的较大波动,表现出地下流体对油层岩石的环境作用。     

Evaluation of three waterborne polymers as stabilizers for sandy soil

This study reports on waterborne polymer emulsion systems that were used for structural modification of sandy soils. The first emulsion used was a styrene-acrylic, copolymer emulsion; the second and third were vinyl-acrylic, copolymer-based emulsions. Specimens were prepared by adding different polymer emulsions to the sand and water in prescribed amounts. The performance of the different emulsion systems as sand stabilizers was estimated through measurement of the hydraulic conductivity and compressive strength. Measurements of hydraulic conductivity were conducted in a flexible membrane test apparatus. The hydraulic conductivity for the three emulsions decreased at different rates, with an increase in polymer content up to 3 wt. (i.e., % by weight). Additional increase of polymer content did not introduce significant decrease in hydraulic conductivity, and, at 5 wt.%, the three emulsions had essentially the same effect. Measurements made on dry cylindrical specimens disclosed remarkable enhancement in the mechanical behavior of the system. The compressive strength and modulus of elasticity of the examined emulsions increased with a higher concentration of polymer. Scanning electron microscope (SEM) revealed that the reduction in the permeability and the improved mechanical properties can be attributed to three dominant structural changes: the development of interconnecting ties between the sand particles, the development of adhesion between neighboring sand particles in contact, and the covering of the sand particles with a thin polymer film.