Readout Techniques for Drift and Low Frequency Noise Rejection in Infrared Arrays

Three different methods are presented to subtract thermal drifts and low-frequency noise from the signal of infrared array. The first is dead pixels with open Indium bumps, the second is reference output as implemented on the Hawaii2 multiplexer, and the third is dark pixels to emulate reference cells having a capacity connected to the gate of the unit cell field-effect transistor (FET). The third method is the most effective and yields a reduction in readout noise from15.4–9.4 erms. A novel method will be described to extend this readout technique to the Aladdin 1 K × 1 K InSb array. This revised version was published online in July 2006 with corrections to the Cover Date.     

变形分析的Bayes估计与检验

由于观测条件的变化，观测值方差将产生随机波动。本文根据Ｂａｙｅｓ估计理论，推导了线性模型待估参数的分布函数及观测值方差估计公式，并将其用于位移检验。计算结果表明，在同样的置信度下，本方法更符合实际。文中还对参数估值的统计性质进行了讨论。     

塔中4号油藏渗透率分布的非均质性及渗流方向研究

研究油藏内部油水渗流方向时,主要考虑渗透率影响,引入两个水平方向渗透率比、水平与垂向渗透率比参数来分析。前者反映样品所在储层平面上两个水平方向渗流能力的差异,后者反映样品所在储层水平与垂向渗流能力的差异,并经小柱样测试和全岩心测试两种方法确定两个参数。通过对塔中4号油藏CⅠ油组9口井2306个样品两种渗透率比值分布直方图分析,研究了CⅠ油组渗透率的非均质性及其渗流方向:CI油组储层在水平方向的渗流能力有很大差异,具有明显的方向性。储层垂向渗流能力明显小于水平方向的渗流能力。     

Predicting ground-motion variations at the Turkey-flat test site,California

Results of a single group participating in an international experiment are analyzed. The experiment served to verify computational predictions of the ground-motion variations due to near-surface geological effects at a site established for that purpose by the California Department of Conservation. Based on an acceleration record at a rock location, and geotechnical model of medium, records at the other locations of a nearby sedimentary deposit were predicted. A 2-D finite-difference sensitivity analysis suggested that the lateral wave-propagation effects are negligibly small, and locally 1-D computations are sufficient for the present site. Those computations are compared with observations not available to the authors during the blind prediction. Peak accelerations, peak velocities and RMS accelerations were predicted with errors less than 159%, 114% and 62%, respectively. Maxima of the response spectra were fitted within a factor of 2. The predicted and observed Husid's plots (i.e., the normalized cumulative plots of the acceleration squared) have the correlation coefficients 0.98. The detected misfits do not show any simple relation to the instrument location, component, frequency, or time.     

Integrated approach for identification of potential groundwater zones in Seethanagaram Mandal of Vizianagaram District,Andhra Pradesh,India

Identifying a good site for groundwater exploration in hard rock terrain is a challenging task. In hard rocks, groundwater occurs in secondary porosity developed due to weathering, fracturing, faulting, etc., which is highly variable within short distance and contributing to near-surface inhomogeneity. In such situations topographic, hydrogeological and geomorphological features provide useful clues for the selection of suitable sites. Initially, based on satellite imagery, topographical, geomorphological and hydrogeological features, an area of about 149 km² was demarcated as a promising zone for groundwater exploration in the hard rock tract of Seethanagaram Mandal, Vizianagaram District, Andhra Pradesh, India. A total of 50 Vertical Electrical Soundings (VES) were carried out using Wenner electrode configuration. An interactive interpretation of the VES data sharpened the information inferred from geomorphological and hydrogeological reconnaissance. Ten sites were recommended for drilling. Drilling with Down-The-Hole Hammer (DTH) was carried out at the recommended sites down to 50 to 70 m depths. The interpreted VES results matched well with the drilled bore well lithologs. The yields of bore wells vary from 900 to 9000 liters per hour (lph).     

山东省济宁强磁异常区深部铁矿初步验证及其意义

山东省济宁磁异常是一个重、磁同源体,面积大于100 km2,磁异常峰值为3800nT。钻探验证在孔深1041.57～1796.54m位置发现铁矿体,矿体总厚度74.04～220m,磁性铁平均品位15.89～25.19%。矿石类型有条带状方解磁铁石英岩和条带状磁铁石英大理岩,矿石的主要组成矿物为石英、方解石、磁铁矿、磁赤铁矿、菱铁矿。矿体产于济宁岩群浅变质岩系中,矿床特征与条带状铁建造（BIF）铁矿或鞍山式铁矿有明显区别,铁矿成因类型属与千枚岩、变质中酸性火山岩、大理岩有关的沉积变质型铁矿床。该区铁矿资源潜力巨大。     

Shear strength characterization of municipal solid waste at the Suzhou landfill, China

The current practice of slope stability analysis for a municipal solid waste (MSW) landfill usually overlooks the dependence of waste properties on the fill age or embedment depth. Changes in shear strength of MSW as a function of fill age were investigated by performing field and laboratory studies on the Suzhou landfill in China. The field study included sampling from five boreholes advanced to the bottom of the landfill, cone penetration tests and monitoring of pore fluid pressures. Twenty-six borehole samples representative of different fill ages (0 to 13 years) were used to perform drained triaxial compression tests. The field and laboratory study showed that the waste body in the landfill can be sub-divided into several strata corresponding to different ranges of fill age. Each of the waste strata has individual composition and shear strength characteristics. The triaxial test results showed that the MSW samples exhibited a strain-hardening and contractive behavior. As the fill age of the waste increased from 1.7 years to 11 years, the cohesion mobilized at a strain level of 10% was found to decrease from 23.3 kPa to 0 kPa, and the mobilized friction angle at the same strain level increasing from 9.9° to 26°. For a confinement stress level greater than 50 kPa, the shear strength of the recently-placed MSW seemed to be lower than that of the older MSW. This behavior was consistent with the cone penetration test results. The field measurement of pore pressures revealed a perched leachate mound above an intermediate cover of soils and a substantial leachate mound near the bottom of the landfill. The measurements of shear strength properties and pore pressures were utilized to assess the slope stability of the Suzhou landfill.     

Biaxial test simulations using a packing of polygonal particles

The mechanical response of cohesionless granular materials under monotonic loading is studied by performing molecular dynamic simulations. The diversity of shapes of soil grains is modelled by using randomly generated convex polygons as granular particles. Results of the biaxial test obtained for dense and loose media show that samples achieve the same void ratio at large strains independent of their initial density state. This limit state resembles the so‐called critical state of soil mechanics, except for some stress fluctuations, which remain for large deformations. These fluctuations are studied at the micro‐mechanical level, by following the evolution of the co‐ordination number, force chains and the fraction of the sliding contacts of the sample. Copyright © 2007 John Wiley & Sons, Ltd.     

Background concentrations of elements in surface soils and their changes as affected by agriculture use in the desert-oasis ecotone in the middle of Heihe River Basin,North-west China

The concentrations of twenty four chemical elements in the surface layer of natural desert soils and the cultivated farmland soils were measured at a desert-oasis ecotone in the middle of Heihe river basin, north-west China. Background values were estimated for (a) major elements (Si 335.3 g kg^− 1, Al 49.4 g kg^− 1, Fe 19.1 g kg^− 1, Ca 29.4 g kg^− 1, Mg 8.9 g kg^− 1, K 20.1 g kg^− 1, Na 17.5 g kg^− 1 and P 0.338 g kg^− 1), (b) heavy metals and non-metals (Cr 55.8 mg kg^− 1, Mn 404.8 mg kg^− 1, Ni 17.7 mg kg^− 1, Cu 5.1 mg kg^− 1, Zn 33.7 mg kg^− 1, Pb 15.5 mg kg^− 1 and As 5.2 mg kg^− 1) and (c) other trace elements (Ti 2.0 mg kg^− 1, V 55.3 mg kg^− 1, Co 5.7 mg kg^− 1, Rb 82.4 mg kg^− 1, Sr 232.9 mg kg^− 1, Y 14.7 mg kg^− 1, Zr 194.9 mg kg^− 1, Nb 7.8 mg kg^− 1 and Ba 720.6 mg kg^− 1). After natural desert soil was cultivated for agricultural use, significant changes in element concentrations occurred under tillage, irrigation and fertilisation management. Compared to natural soil, the for the levels of Si, K, Na, Sr, Zr and Ba decreased, and no changes were observed for Rb, while the values of the other 17 elements increase in agricultural soil from 1.2 to 3.5 times. However, their absolute concentrations are still low, suggesting that the arable soil in this region remains comparatively a clean soil. The increased silt, clay and organic carbon content, under long-term irrigation, enriched the fine-grained materials, and application of fertilisers and manure contributed to the accumulation of most elements in arable soil. The accumulation of elements in agricultural soil increased with increasing cultivation years and extent of soil development.     

Influence of Structural Non-Stationarity of Surface Roughness on Morphological Characterization and Mechanical Deformation of Rock Joints

Summary Structural non-stationarity of surface roughness affects accurate morphological characterization as well as mechanical behaviour of rock joints at the laboratory scale using samples with a size below the stationarity threshold. In this paper, the effect of structural non-stationarity of surface roughness is investigated by studying the scale dependence of surface roughness and mechanical behaviour of rock joints. The results show that the structural non-stationarity mainly affects the accurate characterization of the surface roughness of the fracture samples. It also controls the amount and location of the contact areas during shear tests, which in turn affects the mechanical properties and asperity degradation of the samples. It is concluded that for accurate determination of the morphological and mechanical properties of rock joints at laboratory and field scales, samples with size equal to or larger than the stationarity threshold are required. Author’s address: Nader Fardin, Rock Mechanics Group, Department of Mining Engineering, Faculty of Engineering, University of Tehran, P.O. Box: 11365/4563, Tehran, Iran