An inexpensive instrument for measuring benthic current velocity and direction at sea

An instrument which measures the velocity and direction of benthic water currents at depths of up to 80 m is described. Characteristics of this meter include: (i) readings are not affected by water flow during sinking or retrieval; (ii) it is portable; (iii) it operates unattended; (iv) it is inexpensive; and (v) it requires only simple maintenance. A timing circuit which operates two time periods in succession is used to activate and de-activate a revolution counter and a fluidfilled compass which are mounted on a special frame and vane system. In the field, the instrument accurately measured average current velocities of up to 6 m s⁻¹. Data are presented which illustrate the usefulness of this instrument in describing the velocity and direction of benthic currents along the east coast of Australia and demonstrate a positive correlation between benthic current velocity and catch rates of the commercially-exploited spanner crab Ranina ranina.     

连云港近岸海域物理自净能力研究及水质预测——Ⅲ.西大堤建成后对物质输运的影响

在连云港近岸海域计算潮流场基础上建立拉格朗日余流模型,并对连云港市两大堤建成前后的拉格朗日余流变化进行了分析,且选择有代表性的排污口进行了数值跟踪。     

水槽造流系统水力计算与泵机选择

提供一种完整的用于试验水槽造流系统的水力计算和泵机选择方法 ,可用于其他类似工程设计。     

胶州湾三维变动边界的潮流数值模拟

基于Blumberg等（1986）的河口、陆架和海洋模式，引入变边界处理技术，建立了胶州湾三维变动边界的潮流模型，模型以σ-正交曲线坐标下三维非线性潮波方程为基本方程，引入2.5阶瑞封闭方程组，采用分裂算子法数值求解方程组，利用湍封闭方程求解垂直紊动粘滞系数，采用干湿网格方法模拟潮流漫滩过程，三维变动边界潮流模型计算结果与实测值吻合良好。     

完全非线性波浪破碎模型沿岸流数值模拟

探讨一种基于完全非线性Boussinesq方程的波浪破碎模型在沿岸流计算中的应用问题。针对控制方程中的完全非线性项对沿岸流成长过程的影响进行了深入讨论。数学模型计算结果表明,完全非线性项有使平均流局部化的作用;通过数模实验还发现,垂向高阶涡度项可以有效抑制破波区外回流;运用Visser的实验室沿岸流实测资料从沿岸流速度、波高和平均水位几方面对所提模型进行了验证,并给出了紊动参数的计算结果。     

浪流作用下系泊船舶撞击力和系缆力试验研究

以某25万吨矿石码头工程为例,分别进行了单流、单浪和浪流共同作用下,系泊船舶撞击力和系缆力试验。研究了不同水位、不同船舶载度、不同浪流夹角,单流、单浪和浪流共同作用时对船舶撞击力和系缆力的影响。分析了该码头工程护舷和缆绳的布置情况,为工程设计提供了依据。     

诊断台风异常路径的三层权重控制点方案

本方案采用850、700、500hPa三个层次的环境平均流场作控制点法。综合考虑这些层次上的引导气流在不同时、空域中的相对重要性。试验结果表明,其效果比单一取某层作引导为佳。且对用来预测台风的未来24小时路径是否异常具有一定的参考价值。     

Field measurements and monitoring of wastewater discharge in sea water

This paper reports a study of the field measurements and monitoring of wastewater discharge in sea water at Bari East (Italy). A wastewater sea outfall system is an integral and fundamental part of each wastewater treatment with ultimate sink in the sea water. The design of a water treatment plant and wastewater outfall must take into account the use of the environmental water, the values of physicochemical parameters to be respected in order to safeguard the use itself and the quality of the environmental water where wastewater is issued. In the present study measurements of sea current velocity components were carried out with a VM-ADP (Vessel-Mounted Acoustic Doppler Profiler). Salinity, wind directions and velocities were assessed with, for one survey, the total faecal coliforms and other biochemical parameters. It was emphasized that the measurements necessary for monitoring cannot be concentrated in the wastewater outfall pipe zone only, but should be extended to a neighbouring area of the outfall pipe, with an extension depending on the wastewater discharge, the polluting charge and the magnitude of the sea currents and the winds typical of the zone of interest. The analyses presented in this paper confirm that the sea zones close to the wastewater outfall pipe are particularly sensitive and vulnerable. Such results must be considered in the planning of a wastewater outfall pipe.     

The intertidal erosion rate of cohesive sediment: a case study from Long Island Sound

Over the past decades, many attempts have been made to generate useful bottom erosion models for the study of cohesive sediment movement. This study addresses some of the key questions involved in determining the functional relationship between erosion rate and bottom shear stress. Current, wave, and turbidity data were collected from a bottom mounted instrument array in a moderately energetic estuarine environment. The bottom shear stress was calculated from a wave–current interaction model. The erosion rate was derived from the observed sediment concentration using a vertical mixing model. Examination of the relationship between erosion rate and bottom stress showed that the erosion rate varied at intertidal frequency. When averaged over the tidal fluctuation, the erosion rate remained approximately constant at low stress, but increased sharply when the shear stress rose above a critical value. This suggests two-stage erosion. The bed has a layered structure, in which a thin layer of loose, high water content material overlies a more consolidated bed. The top layer of high water content material (fluff) was easily disturbed and re-suspended by tidal currents, but the consolidated bottom layer was eroded only under conditions of high shear stress.