Isotopic geochemistry of acid thermal waters and volcanic gases from Zaō volcano in Japan

The chemical composition and D/H, and ratios have been determined for the acid hot waters and volcanic gases discharging from Zaō volcano in Japan. The thermal springs in Zaō volcano issue acid sulfate-chloride type waters (Zaō) and acid sulfate type waters (Kamoshika). Gases emitted at Kamoshika fumaroles are rich in CO₂, SO₂ and N₂, exclusive of H₂O. Chloride concentrations and oxygen isotope data indicate that the Zaō thermal waters issue a fluid mixture from an acid thermal reservoir and meteoric waters from shallow aquifers. The waters in the Zaō volcanic system have slight isotopic shifts from the respective local meteoric values. The isotopic evidence indicates that most of the water in the system is meteoric in origin. Sulfates in Zaō acid sulfate-chloride waters with δ³⁴S values of around +15‰, are enriched in ³⁴S compared to Zaō H₂S, while the acid sulfate waters at Kamoshika contain supergene light sulfate (δ³⁴S = + 4‰) derived from volcanic sulfur dioxide from the volcanic exhalations. The sulfur species in Zaō acid waters are lighter in δ³⁴S than those of other volcanic areas, reflecting the difference in total pressure.     

Strain and tilt changes measured during a water injection experiment at the Nojima Fault zone, Japan

Abstract In order to make geophysical and geological investigations of the Nojima Fault on Awaji Island, Japan, three boreholes measuring 1800 m, 800 m and 500 m deep were drilled into the fault zone. The fault is one of the seismic source faults of the 1995 Hyogo-ken Nanbu earthquake of M 7.2. A new multicomponent borehole instrument was installed at the bottom of the 800 m borehole and continuous observations of crustal strain and tilt have been made using this instrument since May 1996. A high-pressure water injection experiment within the 1800 m borehole was done in February and March 1997 to study the geophysical response, behavior, permeability, and other aspects of the fault zone. The injection site was located approximately 140 m horizontally and 800 m vertically from the instrument. Associated with the water injection, contraction of approximately 0.7 × 10⁻⁷ str (almost parallel to the fault) and tilt of approximately 1 × 10^-7 rad in the sense of upheaval toward the injection site were observed. In addition to these controlled experiments, the strainmeter and tiltmeter also recorded daily variations. We interpret strain and tilt changes to be related to groundwater discharge and increased ultra-micro seismicity induced by the injected water.     

Zinc-rich Pyrite from the TAG Active Mound, the TAG Hydrotherma Field, Mid-Atlantic Ridge

Abstract: Pyrite rich in Zn, up to 3.1 wt%, was found in the TAG active mound of the TAG hydrothermal field, the slow-spreading Mid-Atlantic Ridge at 26°08'N and 44°49'W. The Zn-rich pyrite is characterized by an optical homogeneity, a homogeneous distribution of Zn in the back-scattered electron images, both at a magnification of about 500, a negative correlation between Fe and Zn contents of the pyrite and a rather small unit cell edge (a₀ = 5.4117 ± 0.0008Å), strongly indicating that the detected Zn is present in the pyrite in solid solution. Such Zn concentrations are observed exclusively in dendritic pyrite, suggesting that the Znrich pyrite grew from hydrothermal fluids of a high degree of supersaturation due to quenching on the seafloor.     

Comparison of observed and theoretically calculated seiches of Heda Bay,Japan

We carried out observations of sea-level fluctuations simultaneously at three stations on the coast of Heda Bay, Honshu, Japan, using supersonic-type water level gauges controlled by a personal computer. Analyses of the obtained data showed predominant spectral peaks at periods of 7.6, 2.0 and 1.3 minutes for all three stations. Comparison of the observed data with numerically calculated normal oscillation modes of the bay indicates that these three spectral peaks correspond to the theoretical first, third and seventh normal modes of the basin respectively, judging from the results of cross-spectral analyses. The reason for the absence of the remaining normal modes, especially of the second or the lateral first mode of the basin, is briefly considered.     

Performance of a lithium fluoride bolometer for Tokyo dark matter search experiment

The performance of a 21-g lithium fluoride bolometer is presented. The background spectrum was measured in the surface laboratory. We derive an exclusion plot for the spin-dependent coupled Weakly Interacting Massive Particles (WIMPs) cross section.     

Influence of cluster environments on X-ray cluster morphology

We investigated the influence of environment on cluster morphology by examining the alignment of the cluster position angle with respect to the nearest neighbour cluster. The cluster position angle and ellipticity were measured using high spatial resolution X-ray data taken from the Chandra archive, while the nearest neighbour sample was extracted from the Abell cluster catalogue. We found high confidence for an alignment when neighbour distance (Dn) was less than  70  h ⁻¹  Mpc, while we found no significant variations of the confidence level at various values of Dn less than  70  h ⁻¹  Mpc.     

Re-Os geochronology of the Iimori Besshi-type massive sulfide deposit in the Sanbagawa metamorphic belt, Japan

Besshi-type Cu deposits are strata-bound volcanogenic massive sulfide deposits usually associated with mafic volcanic rocks or their metamorphic equivalents. Although there are numerous Besshi-type deposits in the Sanbagawa metamorphic belt, Japan, their tectonic settings and depositional environments remain controversial because of a lack of depositional age constraints. We report Re-Os data for the Iimori deposit, one of the largest Besshi-type deposits in western Kii Peninsula, in order to examine the robustness of the Re-Os isotope system for dating sulfide minerals in the high-P/T metamorphic belt and to elucidate the primary depositional environment of the Iimori sulfide ores. An 11-point Re-Os isochron plot yields an age of 156.8 ± 3.6 Ma. As this Re-Os isochron age is significantly older than the timing of the Sanbagawa peak metamorphism (110-120 or ∼90 Ma) and a well-defined isochron was obtained, the Re-Os age determined here is most likely the primary depositional age. Despite high-grade metamorphism at up to 520 ± 25 °C and 8-9.5 kbar, the Re-Os isotope system of the Iimori sulfides was not disturbed. Hence, we consider that the whole-rock Re-Os closure temperature for the Iimori sulfide ores was probably higher than 500 °C. As the accretion age of the Sanbagawa metamorphic belt is considered to be 120-130 or 65-90 Ma on the basis of radiolarian and radiometric ages, we estimated the time from the Iimori sulfide deposition on the paleo-seafloor to its accretion at the convergent plate boundary to be greater than 25 Myr. Consequently, the depositional environment of the Iimori sulfide ores was not in the marginal sea, but was truly pelagic.     

Genesis of the Kamioka Skarn Deposits: An Important Role of Clinopyroxene Skarn and Graphite-bearing Limestone in Precipitating Sulfide Ore

Abstract: A genetical relationship between skarn formation and mineralization is investigated for the Kamioka skarn deposits which are the largest Zn-Pb producer in Japan. In the Mozumi deposit, one of main deposits in the Kamioka mining area as well as Tochibora and Maruyama, clinopyroxene skarn was generally subjected to later replacement by garnet or magnetite–calcite–quartz during the Zn-Pb mineralization. The replacement of hedenbergitic clinopyroxene by andraditic garnet resulted in the formation of diopsidic clinopyroxene relicts. With the progress of replacement, the S/So value (So: an estimated area occupied by an original clinopyroxene grain in a thin section, S: a total area of relict clinopyroxene fragments) which is an index of the degree of replacement decreases from 0. 7 to 0. 1, and the hedenbergite mole percent of relict clinopyroxene decreases drastically from about 65 to less than 40. A close association of andraditic garnet and sphalerite suggests that heden-bergitic clinopyroxene skarn played an important role to reduce the relatively oxic ore-forming fluid enriched in Zn²⁺ and SO4^2– and to precipitate sphalerite from the fluid. Ferrous iron in the hedenbergitic clinopyroxene skarn was oxidized to form andraditic garnet. Besides this garnet formation, the mineral assemblage of magnetite–calcite–quartz replaced the clinopyroxene skarn at the time of mineralization. In both cases, the reduction of relatively oxic ore-forming fluid by hedenbergitic clinopy-roxene skarn at the later stage brought about the precipitation of sulfide minerals. In contrast, these types of later replacement are not found in the Tochibora deposit. Instead, graphite-bearing crystalline limestone and relatively fresh clinopyroxene skarn are common. Mineralized clinopyroxene skarn has high graphite carbon contents relative to barren one, suggesting that the amount of graphite in the skarn was an important controlling factor for mineralization. It is very likely that the graphite played a role of reducing agent during the mineralization in the Tochibora deposit.     

Application of common reflection angle migration for imaging deformation structures in an inner accretionary wedge,Nankai Trough,Japan

To better image deformation structures within the inner accretionary wedge of the Nankai Trough, Japan, we apply common reflection angle migration to a legacy two-dimensional seismic data set acquired with a 6 km streamer cable. In this region, many seismic surveys have been conducted to study the seismogenic zone related to plate subduction. However, the details of the accreted sediments beneath the Kumano forearc basin are still unclear due to the poor quality of seismic images caused by multiple reflections, highly attenuated signals, and possibly complex geological structures. Generating common image gathers in the subsurface local angle domain rather than the surface offset domain is more advantageous for imaging geological structures that involve complex wave paths and poor illumination. By applying this method, previously unseen structures are revealed in the thick accreted sediments. The newly imaged geometric features of reflectors, such as the folds in the shallow part of the section and the deep reflectors with stepwise discontinuities, imply deformation structures with multiple thrust faults. The reflections within the deep accreted sediments (approximately 5 km) are mainly mapped to far angles (30°–50°) in the common reflection angles, which correspond to the recorded offset distances greater than 4.5 km. This result indicates that the far offset/angle information is critical to image the deformation structures at depth. The new depth image from the common reflection angle migration provides seismic evidence of multiple thrust faults and their relationship with the megathrust fault that is essential for understanding the structure and evolution of the Nankai Trough seismogenic zone.