Evaluation of predictors of non‐linear seismic demands using ‘fishbone’ models of SMRF buildings

Predictors (or estimates) of seismic structural demands that are less computationally time‐consuming than non‐linear dynamic analysis can be useful for structural performance assessment and for design. In this paper, we evaluate the bias and precision of predictors that make use of, at most, (i) elastic modal vibration properties of the given structure, (ii) the results of a non‐linear static pushover analysis of the structure, and (iii) elastic and inelastic single‐degree‐of‐freedom time‐history analyses for the specified ground motion record. The main predictor of interest is an extension of first‐mode elastic spectral acceleration that additionally takes into account both the second‐mode contribution to (elastic) structural response and the effects of inelasticity. This predictor is evaluated with respect to non‐linear dynamic analysis results for ‘fishbone’ models of steel moment‐resisting frame (SMRF) buildings. The relatively small number of degrees of freedom for each fishbone model allows us to consider several short‐to‐long period buildings and numerous near‐ and far‐field earthquake ground motions of interest in both Japan and the U.S. Before doing so, though, we verify that estimates of the bias and precision of the predictor obtained using fishbone models are effectively equivalent to those based on typical ‘full‐frame’ models of the same buildings. Copyright © 2003 John Wiley & Sons, Ltd.     

Temperatures and Oxygen Isotopic Compositions of Hydrothermal Fluids for the Takatori Tungsten-copper Deposit, Japan

Abstract. Fluid inclusion and oxygen isotope studies are performed to obtain temperatures and oxygen isotopic compositions of hydrothermal fluids for the vein-type tungsten-copper deposit at Takatori in Ibaraki Prefecture, Japan. Temperatures of the hydrothermal fluids are calculated from fluid inclusion data. The calculation incorporates the effects of the salinity, gas concentration, and fluid pressure. The fluid temperatures range from 370 to 460C. For these calculations, this study obtains a density equation for H₂O-NaCl-CO₂ solution at the vapor-liquid two-phase boundary. Then the present study combines the obtained equation with the equation of state by Bowers and Helgeson (1983).
The fluid temperatures determined in this study are applied to the calculation of oxygen isotopic compositions of the hydrothermal fluids. The calculation of the oxygen isotopic compositions is based on the oxygen isotope analyses of vein quartz. The oxygen isotopic compositions of vein quartz range from +13.5 to +14.4 % relative to SMOW. Then, the oxygen isotopic compositions of the hydrothermal fluids in equilibrium with the vein quartz are calculated to be from +9.7 to +10.5 %. These δ¹⁸O_fluid values agree with those of magmatic fluids derived from the ilmenite-series granitic rock, which is related to the mineralization. Keywords: Takatori tungsten-copper deposit, fluid inclusion, oxygen isotope, vein quartz, H₂O-NaCl-CO₂ solution, density     

Rare Earth, Major and Trace Elements in the Kunimiyama Ferromanganese Deposit in the Northern Chichibu Belt, Central Shikoku, Japan

Abstract. Rare earth, major and trace element geochemistry is reported for the Kunimiyama stratiform ferromanganese deposit in the Northern Chichibu Belt, central Shikoku, Japan. The deposit immediately overlies greenstones of mid-ocean ridge basalt (MORB) origin and underlies red chert. The ferromanganese ores exhibit remarkable enrichments in Fe, Mn, P, V, Co, Ni, Zn, Y and rare earth elements (excepting Ce) relative to continental crustal abundance. These enriched elements/ Fe ratios and Post-Archean Average Australian Shale-normalized REE patterns of the ferromanganese ores are generally analogous to those of modern hydrothermal ferromanganese plume fall-out precipitates deposited on MOR flanks. However in more detail, Mn and Ti enrichments in the ferromanganese ores are more striking than the modern counterpart, suggesting a significant contribution of hydrogenetic component in the Kunimiyama ores. Our results are consistent with the interpretation that the Kunimiyama ores were umber deposits that primarily formed by hydrothermal plume fall-out precipitation in the Panthalassa Ocean during the Early Permian and then accreted onto the proto-Japanese island arc during the Middle Jurassic. The presence of strong negative Ce anomaly in the Kunimiyama ores may indicate that the Early Permian Panthalassa seawater had a more striking negative Ce anomaly due to a more oxidizing oceanic condition than today.     

The effective stress concept and the evaluation of changes in pore air pressure under jacketed isotropic compression tests for dry sand based on the 2‐phase porous theory

The effective stress concept for solid‐fluid 2‐phase media was revisited in this work. In particular, the effects of the compressibility of both the pore fluid and the soil particles were studied under 3 different conditions, i.e., undrained, drained, and unjacketed conditions based on a Biot‐type theory for 2‐phase porous media. It was confirmed that Terzaghi effective stress holds at the moment when soil grains are assumed to be incompressible and when the compressibility of the pore fluid is small enough compared to that of the soil skeleton. Then, isotropic compression tests for dry sand under undrained conditions were conducted within the triaxial apparatus in which the changes in the pore air pressure could be measured. The ratio of the increment in the cell pressure to the increment in the pore air pressure, m, corresponds to the inverse of the B value by Bishop and was obtained during the step loading of the cell pressure. In addition, the m values were evaluated by comparing them with theoretically obtained values based on the solid‐fluid 2‐phase mixture theory. The experimental m values were close to the theoretical values, as they were in the range of approximately 40 to 185, depending on the cell pressure. Finally, it was found that the soil material with a highly compressible pore fluid, such as air, must be analyzed with the multi‐phase porous mixture theory. However, Terzaghi effective stress is practically applicable when the compressibilities of both the soil particles and the pore fluid are small enough compared to that of the soil skeleton.     

A hydrochemical study of the Hammam Righa geothermal waters in north-central Algeria

This study focuses on the hydrochemical characteristics of 47 water samples collected from thermal and cold springs that emerge from the Hammam Righa geothermal field, located in north-central Algeria. The aquifer that feeds these springs is mainly situated in the deeply fractured Jurassic limestone and dolomite of the Zaccar Mount. Measured discharge temperatures of the cold waters range from 16.0 to 26.5 °C and the hot waters from 32.1 to 68.2 °C. All waters exhibited a near-neutral pH of 6.0–7.6. The thermal waters had a high total dissolved solids (TDS) content of up to 2527 mg/l, while the TDS for cold waters was 659.0–852.0 mg/l. Chemical analyses suggest that two main types of water exist: hot waters in the upflow area of the Ca–Na–SO₄ type (Hammam Righa) and cold waters in the recharge zone of the Ca–Na–HCO₃ type (Zaccar Mount). Reservoir temperatures were estimated using silica geothermometers and fluid/mineral equilibria at 78, 92, and 95 °C for HR4, HR2, and HR1, respectively. Stable isotopic analyses of the δ¹⁸O and δD composition of the waters suggest that the thermal waters of Hammam Righa are of meteoric origin. We conclude that meteoric recharge infiltrates through the fractured dolomitic limestones of the Zaccar Mount and is conductively heated at a depth of 2.1–2.2 km. The hot waters then interact at depth with Triassic evaporites located in the hydrothermal conduit (fault), giving rise to the Ca–Na–SO₄ water type. As they ascend to the surface, the thermal waters mix with shallower Mg-rich groundwater, resulting in waters that plot in the immature water field in the Na–K–Mg diagram. The mixing trend between cold groundwaters from the recharge zone area (Zaccar Mount) and hot waters in the upflow area (Hammam Righa) is apparent via a chloride-enthalpy diagram that shows a mixing ratio of 22.6 < R < 29.2 %. We summarize these results with a geothermal conceptual model of the Hammam Righa geothermal field.     

Multiple-tracers-aided surface-subsurface hydrological modeling for detailed characterization of regional catchment water dynamics in Kumamoto area,southern Japan

Hydrogeology Journal - Integrated watershed modeling techniques have been applied in recent years to examine surface and subsurface interactions. Model performance is often evaluated by best fit of...     

Cause and countermeasure of long-period oscillations of moored ships and the quantification of surge and heave amplitudes

Long-period oscillations of moored ships whose periods are about 1 or 2 min cause many troubles in many ports and harbours. It is necessary to investigate these phenomena and verify their causes and countermeasures in each case because they are strongly dependent on the environment of each port and harbour. From this point of view, long-period oscillations of moored ships in the Port of Shibushi in Japan were investigated by means of wave observations, the image processing of moored ship motions using the video camera and motion-capture software and numerical simulations. From observation results, the relationship between offshore long-period waves and long-period oscillations of moored ships was recognized and surge and heave amplitudes were quantified by using wave data in order to forecast moored ship motions. Furthermore, from observation and numerical results, it was revealed that long-period waves with the peak period of 120 s from the offshore typhoon kept or exaggerated the local harbour oscillation of 60–70 s and it caused long-period oscillations of moored ships. Numerical results in case of reducing the reflection coefficient of the target berth implied that it ceased the local harbour oscillation and it would give an effective countermeasure to reduce long-period oscillations of moored ships in the Port of Shibushi.