Influence of gold mine on groundwater quality (Efemçukuru, Izmir, Turkey)

. Currently, exploration of gold ores is under discussion in Turkey, without considering its adverse affect on the environment. Studying the adverse affect on environment is extremely important because significant civic activities are already taking place on the geological units that contain gold ore bodies in Turkey. Such an area is located at the southeast of Izmir City (Turkey), and approximately 2-km-long gold-bearing ore veins occur close to the Efemçukuru Village. The objective of this study was to describe the characteristics and seasonal variation of the groundwater chemistry and pollution of the aquifer in the ore deposit site, and to determine the impact of ore deposits on groundwater quality. The gold-bearing formation is highly weathered and fractured. The fractures in the geological units control the permeability and the depth of groundwater in the area. The concentrations of Al, Ag, Cu, Cd, Cr, Fe, Pb, Mn, Zn, Ni, and Sb were determined for four well samples and two stream waters for wet and dry seasons. The results showed that the concentrations of most of these elements were below the USA EPA (Environmental Protection Agency) limits; however, Pb and Cd concentrations are slightly above the limits. The results indicate that minerals in gold bodies do not dissolve although the weathering of formations is high. The low concentration of elements in groundwater and streams may be attributed to the high velocity of ground and surface water.     

Mantle Convection Modeling with Viscoelastic/Brittle Lithosphere: Numerical Methodology and Plate Tectonic Modeling

--The earth's tectonic plates are strong, viscoelastic shells which make up the outermost part of a thermally convecting, predominantly viscous layer. Brittle failure of the lithosphere occurs when stresses are high. In order to build a realistic simulation of the planet's evolution, the complete viscoelastic/brittle convection system needs to be considered. A particle-in-cell finite element method is demonstrated which can simulate very large deformation viscoelasticity with a strain-dependent yield stress. This is applied to a plate-deformation problem. Numerical accuracy is demonstrated relative to analytic benchmarks, and the characteristics of the method are discussed.     

The Role of Organic Matter During Metal Enrichment in Permian Kupferschiefer of the Rudna Mine,Southwest Poland

The bulk composition of organic matter and saturated and aromatic hydrocarbons extracted from 16 samples collected from two Kuperschiefer profiles in the Rudna mine,Southwest Poland has been analyzed to study the role of organic matter during base metal enrichment in the Kupferschiefer shale.The results indicated that the extract yields and saturated hydrocarbon yields decreased with increasing base metal contents.GC and GC/MS analyses indicated that n -alkanes and alkylated aromatic compounds were depleted and may have served as hydrogen donators for thermochemical sulfate reduction.The enrichment of base metal is closely connected with the destruction of hydrocarbons.     

Monitoring volcanic hazard using eddy covariance at Solfatara volcano, Naples, Italy

An eddy covariance (EC) station was deployed at Solfatara crater, Italy, June 8–25, 2001 to assess if EC could reliably monitor CO₂ fluxes continuously at this site. Deployment at six different locations within the crater allowed areas of focused gas venting to be variably included in the measured flux. Turbulent (EC) fluxes calculated in 30-min averages varied between 950 and 4460 g CO₂ m⁻² d⁻¹; the highest measurements were made downwind of degassing pools. Comparing turbulent fluxes with chamber measurements of surface fluxes using footprint models in diffuse degassing regions yielded an average difference of 0% (±4%), indicating that EC measurements are representative of surface fluxes at this volcanic site. Similar comparisons made downwind of degassing pools yielded emission rates from 12 to 27 t CO₂ d⁻¹ for these features. Reliable EC measurements (i.e. measurements with sufficient and stationary turbulence) were obtained primarily during daytime hours (08:00 and 20:00 local time) when the wind speed exceeded 2 m s⁻¹. Daily average EC fluxes varied by ±50% and variations were likely correlated to changes in atmospheric pressure. Variations in CO₂ emissions due to volcanic processes at depth would have to be on the same order of magnitude as the measured diurnal variability in order to be useful in predicting volcanic hazard. First-order models of magma emplacement suggest that emissions could exceed this rate for reasonable assumptions of magma movement. EC therefore provides a useful method of monitoring volcanic hazard at Solfatara. Further, EC can monitor significantly larger areas than can be monitored by previous methods.     

Methodology for construction, calibration and validation of a national hydrological model for Denmark

An integrated groundwater/surface water hydrological model with a 1 km² grid has been constructed for Denmark covering 43,000 km². The model is composed of a relatively simple root zone component for estimating the net precipitation, a comprehensive three-dimensional groundwater component for estimating recharge to and hydraulic heads in different geological layers, and a river component for streamflow routing and calculating stream–aquifer interaction. The model was constructed on the basis of the MIKE SHE code and by utilising comprehensive national databases on geology, soil, topography, river systems, climate and hydrology. The present paper describes the modelling process for the 7330 km² island of Sjælland with emphasis on the problems experienced in combining the classical paradigms of groundwater modelling, such as inverse modelling of steady-state conditions, and catchment modelling, focussing on dynamic conditions and discharge simulation. Three model versions with different assumptions on input data and parameter values were required until the performance of the final, according to pre-defined accuracy criteria, model was evaluated as being satisfactory. The paper highlights the methodological issues related to establishment of performance criteria, parameterisation and assessment of parameter values from field data, calibration and validation test schemes. Most of the parameter values were assessed directly from field data, while about 10 ‘free’ parameters were subject to calibration using a combination of inverse steady-state groundwater modelling and manual trial-and-error dynamic groundwater/surface water modelling. Emphasising the importance of tests against independent data, the validation schemes included combinations of split-sample tests (another period) and proxy-basin tests (another area).     

Enhanced red fluorescence emission in the oxygen minimum zone of the Arabian Sea

 Depth profiles of fluorescence at several excitation and emission wavelengths were measured along with CTD data during the cruise So119 of RV Sonne in the Arabian Sea from 12 May to 10 June 1997. In addition to chlorophyll fluorescence from phytoplankton in the near-surface layer, the profiles in the oxygen minimum region well below the euphotic zone show enhanced red fluorescence. Red fluorescence intensity is inversely related to the oxygen concentration in intermediate and deep waters. A relationship to characteristic water masses of the region cannot be found in the data, and this holds also with chemical data such as DOC. Absorbance spectra of water samples taken in the oxygen minimum zone show an absorption band at 420 nm wavelength with about 50 nm bandwidth, much weaker than gelbstoff absorbance in the same wavelength range. The absorption band remains stable after sample filtration with 0.45 μm glass fibre filters. Hence, the size of the absorbing matter is in the range of dissolved molecules or particles much smaller than 1 μm. Fluorescence spectra of unfiltered samples with 420 nm excitation show a weak emission band at 600 nm and a more pronounced one at 660 nm wavelength. The trailing edge of the 660 nm band falls into the range of chlorophyll emission, thus giving rise to the observed depth profiles of red fluorescence in the oxygen minimum zone. Red fluorescence measured on samples remain stable during a few hours after sampling even in the presence of oxygen. It is not detectable after several weeks of sample storage in the dark and cannot be reproduced even after depletion of dissolved oxygen. Received: 22 May 2002 / Accepted: 18 February 2003 Responsible Editor: Andreas Oschlies Acknowledgements. This work was supported by a grant from the Federal Minister of Education and Technology, Bonn, within the frame work of the JGOFS Arabian Sea program. We are grateful to the captain and the crew of RV Sonne for their support. We are indebted to Mrs. Kirsten Neumann from the Institute of Marine Chemistry and Biogeochemistry of the University of Hamburg for providing the oxygen data, and to Mr. Nikolai Delling from the same institute for making the DOC and chlorophyll data available to us.     

An Mw based earthquake Catalogue for central, northern and northwestern Europe using a hierarchy of magnitude conversions

Data from 25 local catalogues and 30special studies of earthquakes in central,northern and northwestern Europe have beenincorporated into a Databank. The dataprocessing includes discriminating eventtypes, eliminating fake events and dupletsand converting different magnitudes andintensities to M_w if this is not givenby the original source. The magnitudeconversion is a key task of the study andimplies establishment of regressionequations where no local relations exist.The Catalogue contains tectonic events fromthe Databank within the area44°N–72°N,25°W–32°E and the time period1300–1993. The lower magnitude level forthe Catalogue entries is setat M_w == 3.50. The area covered by thedifferent catalogues are associated withpolygons. Within each polygon only datafrom one or a small number of the localcatalogues, supplemented by data fromspecial studies, enter the Catalogue. Ifthere are two or more such catalogues orstudies providing a solution for an event,a priority algorithm selects one entry forthe Catalogue. Then M_w is calculatedfrom one of the magnitude types, or frommacroseismic data, given by the selectedentry according to another priority scheme.The origin time, location, M_w magnitude and reference are specified for eachentry of the Catalogue. So is theepicentral intensity, I₀, if providedby the original source. Following thesecriteria, a total of about 5,000earthquakes constitute the Catalogue.Although originally derived for the purposeof seismic hazard calculation within GSHAP,the Catalogue provides a data base for manytypes of seismicity and seismic hazardstudies.     

Food-web manipulation of drinking water reservoirs with salmonids: vertical distribution of prey and predator

In a novel biomanipulation experiment salmonids were used as a tool to improve water quality. The manipulation was initiated in spring 2000 as a response to non-point sources of phosphorus in a drinking water reservoir in Saxony, Germany. Salmonids (brown trout, Salmo trutta forma lacustris) were chosen as predators as the reservoir has a large hypolimnic water body and surface temperatures rarely exceed 20 °C. The vertical distributions of prey fish and brown trout were analysed with a fleet of vertical gill nets set in the pelagic zone of the reservoir. Consumption of brown trout was estimated by means of a bioenergetic model and the diet analyses of the trout. While the dominant planktivore (roach, Rutilus rutilus) was caught almost exclusively in the epilimnion during the stratification period trout were caught mainly below a depth of 10 m. Diet analysis revealed that the trout performed vertical migrations to consume food in the epilimnic layer, as an important food component were adult terrestrial and aquatic insects. The amount of fish in the food increased strongly with the size of the brown trout. The consumption estimate suggested that the trout had consumed 2-3% of the total roach stock during the study period (May-November 2000) of the first year of biomanipulation. We conclude that in general salmonids are suitable for food-web manipulation in deep reservoirs, but the stocked fish should be as large as possible (> 300 mm) and the proportion of large trout (> 500 mm) should be as high as possible.