Silicon isotope fractionation in bamboo and its significance to the biogeochemical cycle of silicon

A systematic investigation on silica contents and silicon isotope compositions of bamboos was undertaken. Seven bamboo plants and related soils were collected from seven locations in China. The roots, stem, branch and leaves for each plant were sampled and their silica contents and silicon isotope compositions were determined. The silica contents and silicon isotope compositions of bulk and water-soluble fraction of soils were also measured. The silica contents of studied bamboo organs vary from 0.30% to 9.95%. Within bamboo plant the silica contents show an increasing trend from stem, through branch, to leaves. In bamboo roots the silica is exclusively in the endodermis cells, but in stem, branch and leaves, the silica is accumulated mainly in epidermal cells. The silicon isotope compositions of bamboos exhibit significant variation, from −2.3‰ to 1.8‰, and large and systematic silicon isotope fractionation was observed within each bamboo. The δ³⁰Si values decrease from roots to stem, but then increase from stem, through branch, to leaves. The ranges of δ³⁰Si values within each bamboo vary from 1.0‰ to 3.3‰. Considering the total range of silicon isotope composition in terrestrial samples is only 7‰, the observed silicon isotope variation in single bamboo is significant and remarkable. This kind of silicon isotope variation might be caused by isotope fractionation in a Rayleigh process when SiO₂ precipitated in stem, branches and leaves gradually from plant fluid. In this process the Si isotope fractionation factor between dissolved Si and precipitated Si in bamboo (α_pre-sol) is estimated to be 0.9981. However, other factors should be considered to explain the decrease of δ³⁰Si value from roots to stem, including larger ratio of dissolved H₄SiO₄ to precipitated SiO₂ in roots than in stem. There is a positive correlation between the δ³⁰Si values of water-soluble fractions in soils and those of bulk bamboos, indicating that the dissolved silicon in pore water and phytoliths in soil is the direct sources of silicon taken up by bamboo roots. A biochemical silicon isotope fractionation exists in process of silicon uptake by bamboo roots. Its silicon isotope fractionation factor (α_bam-wa) is estimated to be 0.9988. Considering the distribution patterns of SiO₂ contents and δ³⁰Si values among different bamboo organs, evapotranspiration may be the driving force for an upward flow of a silicon-bearing fluid and silica precipitation. Passive silicon uptake and transportation may be important for bamboo, although the role of active uptake of silicic acid by roots may not be neglected. The samples with relatively high δ³⁰Si values all grew in soils showing high content of organic materials. In contrast, the samples with relatively low δ³⁰Si values all grew in soil showing low content of organic materials. The silicon isotope composition of bamboo may reflect the local soil type and growth conditions. Our study suggests that bamboos may play an important role in global silicon cycle.     

Origin of Fe-Ti Oxide Ores in Mafic Intrusions: Evidence from the Panzhihua Intrusion, SW China

Economic concentrations of Fe–Ti oxides occur as massive,conformable lenses or layers in the lower part of the Panzhihuaintrusion, Emeishan Large Igneous Province, SW China. Mineralchemistry, textures and QUILF equilibria indicate that oxidesin rocks of the intrusion were subjected to extensive subsolidusre-equilibration and exsolution. The primary oxide, reconstructedfrom compositions of titanomagnetite in the ores and associatedintergrowths, is an aluminous titanomagnetite (Usp₄₀) with 40wt % FeO, 34 wt % Fe₂O₃, 16·5 wt % TiO₂, 5·3 wt% Al₂O₃, 3·5 wt % MgO and 0·5 wt % MnO. This compositionis similar to the bulk composition of the oxide ore, as inferredfrom whole-rock data. This similarity strongly suggests thatthe ores formed from accumulation of titanomagnetite crystals,not from immiscible oxide melt as proposed in earlier studies.The occurrence of oxide ores in the lower parts of the Panzhihuaintrusion is best explained by settling and sorting of densetitanomagnetite in the ferrogabbroic parental magma. This magmamust have crystallized Fe–Ti oxides relatively early andabundantly, and is likely to have been enriched in Fe and Tibut poor in SiO₂. These features are consistent with fractionationof mantle-derived melts under relatively high pressures (10kbar), followed by emplacement of the residual magma at 5 kbar.This study provides definitive field and geochemical evidencethat Fe–Ti oxide ores can form by accumulation in ferrogabbro.We suggest that many other massive Fe–Ti oxide depositsmay have formed in a similar fashion and that high concentrationsof phosphorus or carbon, or periodic fluctuation of fO₂ in themagma, are of secondary importance in ore formation. KEY WORDS: ELIP; Fe–Ti oxide ore; layered intrusion; Panzhihua; QUILF     

The state of land subsidence and prediction approaches due to groundwater withdrawal in China

This article gives a general introduction to land subsidence with the prediction approaches due to withdrawal of groundwater in three subsided/subsiding regions in China: the deltaic plain of Yangtse River (YRDP), North China Plain (NCP), and Fenwei Plain (FP). On YRDP, Shanghai is the typical subsided/subsiding city; on NCP Tianjin is the typical subsided/subsiding city, and on FP Taiyuan is the typical subsided/subsiding city. The subsided area with subsidence over 200 mm on YRDP is about 10,000 km² and the maximum subsided value reached 2.9 m at Shanghai; on NCP the subsided area reached 60,000 km² with the maximum subsidence of 3.9 m at Tianjing; on FP the subsided area is relatively smaller than that on the other two plains and is about 1,135 km² with maximum subsidence of 3.7 m at Taiyuan city. In order to protect the civil and industrial facilities, it is necessary to predict the future development of land subsidence based on present state. Many researchers proposed several approaches to predict the land subsidence due to groundwater withdrawal according to different geological conditions and groundwater withdrawal practice. This article classifies these approaches into five categories: (i) statistical methods; (ii) 1D numerical method; (iii) quasi-3D seepage model; (iv) 3D seepage model; (v) fully coupled 3D model. In China, the former four categories are presently employed in the prediction practice and their merits and demerits are discussed. According to the prediction practice, 3D seepage model is the best method presently.     

华南前寒武系基底变质杂岩和中-新生代地幔岩的稀有气体同位素组成及其大地构造意义

对华南前寒武系变质岩浆杂岩稀有气体He、Ne、Ar和Xe的系统研究表明:扬子克拉通基底为含高³He的下地壳"原始岩石层",(³He/⁴He)×10^-6比值为2.8～4.6;而华夏板块基底变质岩浆杂岩则是在缺乏³He、低(³He/⁴He)×10^-8比值(3.15～17.7)的构造环境下形成的大陆中-上地壳变质岩浆杂岩层,反映出两者基底性质迥然不同。华南中-新生代爆破岩筒He同位素组成相反,相对稳定的扬子克拉通(³He/⁴He)×10^-8比值仅0.18～4.22,而郯庐-四会-吴川断裂以东,中-新生代活动地块(太平洋构造域)(³He/⁴He)×10^-8比值高达3.7～20.5。He同位素表明郯庐-四会-吴川断裂带为切割深至地幔的边界深大断裂,是扬子克拉通与华夏板块间的边界且控制了燕山期火山-侵入岩浆向西扩展。Ar同位素组成表明华南大陆中-新生代地幔形成接近"均一"的地幔组份。¹³⁶Xe/¹³⁰Xe-¹²⁹Xe/¹³⁰Xe相关组份表明它们具有地幔柱岩石同位素组成特征。     

辽东湾凝析气田超压成因及侧向传递机制初探

位于辽东湾西部低凸起北端的JZ20-2超压凝析气田,离供烃中心较远,压力系数却达到1.56~1.7,这在我国东部裂谷盆地比较少见。经过综合分析,作者认为JZ20-2凝析气田异常高压的形成与其所处的特殊地质背景紧密相关,辽中凹陷沙河街组三段超压凝析油气沿不整合面、砂体输导通道向辽东湾西部低凸起的运移、充注和能量的侧向传递是JZ20-2凝析气田异常高压形成的根本原因,而上覆东营组二段下亚段-东营组三段巨厚的强超压泥岩封盖和辽西3号边界断层侧向遮挡共同构成的优越封闭环境是超压保存的必要条件。本文分析了该气田超压特征及其远距离超压侧向传递的成因机制,不仅有助于揭示辽东湾西部低凸起超压流体运移聚集的规律和成藏作用,而且可能提供了一个超压远距离侧向传递的典型实例。     

Loess deposition in Asia： its initiation and development before and during the Quaternary

Dust is important in the Earth environment system. However; the role of dust in climate change remains largely unknown. A better understanding of the temporal and spatial variability of the dust accumulation in Asia forms an important step towards establishing the link between dust deposition and climate change. Here, a summary is given for the timing of the onset and expansion of loess deposition in Asia beginning in the early, Miocene. Recent progress on some aspects of loess chronology and palaeoenvironmental reconstruction is also reviewed.     

乌鲁木齐河流域地下水水质监测网设计

文章运用地下水易污性编图及污染源分布图法进行了乌鲁木齐河流域地下水水质监测网设计。共设计了130监测孔,现有46个监测孔,另需要84个新的监测孔。按监测类型分为面源监测点22个,点源监测点87个,重点水源地与泉水监测点21个。按监测运行分长期监测点55个,流域普查监测点75个。普查监测点监测频率为1次/5年,长期监测点监测频率为1次/年。首期有针对性地在污染严重的柴窝堡新化厂排污区、乌鲁木齐河谷老排污区、米泉污灌区、米泉工业污染区、老龙河污染区取了25个污染水样测试分析,结果显示地下水已经受到严重污染。     

深井旋转轴套流场的CFD模拟

旋转轴套在超深井工作时,其井下流动是三维湍流流动,旋转轴套的旋转和表面曲率效应以及随之而来的哥氏力和离心力,使流场在超深井的流动中极其复杂,同时,由于流体介质泥浆属于液固两相流,更致使内部流场测试困难,而且超深井中的工况在使用常规方法已很难得到较准确的数据。为此,将计算流体力学软件Fluent应用于超深井下流场的模拟,基于Navier-Stokes方程和Reynolds应力方程模型,建立多种仿真模型,在相同条件下,使用CFD仿真软件Fluent模拟仿真的不同结果,优化与旋转轴套叶片设计相关的几何参数,提高     

低温环境下铜同位素分馏的若干重要过程

Cu同位素是一种新的地球化学示踪剂.正确运用这一同位素示踪技术的前提是对其同位素分馏机理和过程有足够的认识.本文报道了室温下CuSO4·5H2O结晶过程产生分馏的实验结果,并系统地总结了低温条件下Cu同位素分馏的一些重要过程,其中包括沉淀过程、还原过程、吸附过程、生物过程等.     

基于分布式水文模拟的三峡区间洪水预报(Ⅰ)——模型构建及验证

长江三峡区间因暴雨形成的洪水峰高量大,对三峡水库的防洪安全和运行调度的影响很大.本论文依据三峡地区的地形地貌特征,采用基于GIS的机理性分布式水文模型,来模拟三峡区间入库洪水,以尽量减少洪水预报中的不确定性.利用近期建成的78个自动雨量站网监测的小时降雨信息作为模型的输入,对模型参数进行了率定和验证,结果表明:大多数洪水过程的模拟精度较好,但也有的模拟结果较差,其中降雨信息缺失是洪水预报不确定性的主要来源.