首页 | 本学科首页   官方微博 | 高级检索  
     检索      


Rock fall dynamics and deposition: an integrated analysis of the 2009 Ahwiyah Point rock fall,Yosemite National Park,USA
Authors:Valerie L Zimmer  Brian D Collins  Greg M Stock  Nicholas Sitar
Institution:1. Department of Civil and Environmental Engineering, University of California, , Berkeley, CA, USA;2. US Geological Survey, , Menlo Park, CA, USA;3. National Park Service, , Yosemite National Park, El Portal, CA, USA
Abstract:We analyzed a combination of airborne and terrestrial LiDAR, high‐resolution photography, seismic, and acoustic data in order to gain insights into the initiation, dynamics, and talus deposition of a complex rock fall. A large (46 700 m3) rock fall originated from near Ahwiyah Point in eastern Yosemite Valley and fell a total of 730 m to the valley floor on 28 March 2009. Analyses of remote sensing, seismic, and acoustic data were integrated to reconstruct the rock fall, which consisted of (1) the triggering of a 25 400 m3 rock block in an area of intersecting and sometimes highly weathered joint planes, (2) the sliding and subsequent ballistic trajectory of the block from a steeply dipping ledge, (3) dislodging of additional rock from the cliff surface from beneath the rock fall source area, (4) a mid‐cliff ledge impact that detached a volume of rock nearly equivalent in volume to the initial block, (5) sliding of the deteriorating rock mass down the remainder of the cliff, and (6) final impact at the base of the cliff that remobilized the existing talus downward and outward and produced an airblast that knocked down hundreds of trees. The depositional geomorphology indicates that the porosity of the fresh talus is significantly lower than that expected for typical blocky talus slopes, likely because the rock debris from this event was pulverized into smaller, more poorly sorted fragments and densified via dynamic compaction when compared to less energetic, fragmental‐type rock falls. These results suggest that accumulation of individual rock‐fall boulders tends to steepen talus slopes, whereas large, energetic rock falls tend to flatten them. Detachment and impact signals were recorded by seismic and acoustic instruments and highlight the potential use of this type of instrumentation for generalized rock fall monitoring, while LiDAR and photography data were able to quantify the cliff geometry, rock fall volume, source and impact locations, and geomorphological changes to the cliff and talus. Published in 2012. This article is a US Government work and is in the public domain in the USA.
Keywords:rockfall  LiDAR  seismic  Yosemite Valley  talus
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号