首页 | 本学科首页   官方微博 | 高级检索  
     

均质边坡离心试验锚杆的应力响应及布设探究
引用本文:晏长根, 孙巍锋, 袁通, 顾良军, 郭志奇, 石玉玲. 均质边坡离心试验锚杆的应力响应及布设探究[J]. 煤田地质与勘探, 2017, 45(6): 96-101,110. DOI: 10.3969/j.issn.1001-1986.2017.06.016
作者姓名:晏长根  孙巍锋  袁通  顾良军  郭志奇  石玉玲
基金项目:国家自然科学基金项目(41272285);宁波交通运输科技项目(201605)
摘    要:以低碳钢片模拟全长黏结锚杆,开展均质岩质边坡离心模型试验,研究了锚杆的应力响应规律。基于试验模型锚杆应力响应规律启发及实际均质边坡变形破坏演变规律,提出仅针对边坡松弛区进行局部强度折减,数值模拟探讨了均质岩质边坡单锚应力监测的较佳位置。结果表明:均质岩质边坡变形破坏起始于坡脚的剪切破坏,且随着边坡变形破坏的开展,靠近坡脚的全长黏结锚杆会较早产生明显的应力响应,锚杆应力增长速率会不断增加;锚杆应力监测点距离边坡潜在滑动面(塑性变形区)越近,锚杆应力响应时间越早,且量值越大;建议在距离坡脚0.25~0.35 HH为边坡高度)的坡面处布设监测锚杆,但对于具体监测边坡对象,应具体问题具体分析。研究成果可为均质岩质边坡的锚杆监测工作提供一定的参考借鉴。

关 键 词:应力响应  离心试验  均质岩质边坡  松弛区  强度折减  锚杆  监测  布设
收稿时间:2017-04-04

Exploration of stress responses and arrangement of fully grouted bolts based on centrifugal model test of homogeneous rock slope
YAN Changgen, SUN Weifeng, YUAN Tong, GU Liangjun, GUO Zhiqi, SHI Yuling. Exploration of stress responses and arrangement of fully grouted bolts based on centrifugal model test of homogeneous rock slope[J]. COAL GEOLOGY & EXPLORATION, 2017, 45(6): 96-101,110. DOI: 10.3969/j.issn.1001-1986.2017.06.016
Authors:YAN Changgen  SUN Weifeng  YUAN Tong  GU Liangjun  GUO Zhiqi  SHI Yuling
Abstract:Using low-carbon steel sheets as fully grouted bolts, centrifugal model test of homogeneous rock slope was carried out and stress responses of fully grouted bolts were studied. Based on the stress responses of fully grouted bolts from the test and practical deformation and failure law of homogeneous rock slope, the preferred position for single bolt stress monitoring of one homogeneous rock slope was also explored by using finite-difference numerical simulation technology and a suggested local strength reduction method on relaxation region. The results are as follows:deformation and failure of the homogeneous rock slope started at the shear failure at the toe of the slope, earlier and obvious stress response of the bolt close to the toe of the slope will be triggered and the stress growth rate of the bolt will also continue to increase with the deformation and failure development of the slope; the closer the distance between stress monitoring point installed in one bolt and potential sliding surface (plastic deformation zone) of the slope, the earlier the time of the bolt stress response and the larger the bolt stress is. It is suggested that the monitoring bolt be put on the slope with 0.25~0.35 H(H is slope height) from the toe of homogeneous rock slope, and concrete analysis must be done for a concrete problem. Results from this paper can provide some references to some extent for the bolts monitoring work of homogeneous rock slope. 
Keywords:stress responses  centrifugal model test  homogeneous rock slope  relaxation region  strength reduction  fully grouted bolts  monitoring  arrangement
本文献已被 CNKI 等数据库收录!
点击此处可从《煤田地质与勘探》浏览原始摘要信息
点击此处可从《煤田地质与勘探》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号