Fluid ascent through the solid lithosphere and its relation to earthquakes

The Earth is continuously expelling gases and liquids from great depths—juvenile volatiles from the mantle and recycled metamorphic products. Some of these fluids ascend through liquid rock in volcanic processes, but others utilize fractures and faults as conduits through the solid lithosphere. The latter process may have a major influence on earthquakes, since fluids at near lithostatic pressures appear to be required to activate deep faults that would otherwise remain locked.Fluids can be driven upward through solid rock by buoyancy, but only if present in sufficient concentration to form large-scale domains occupying interconnected fracture porosity. A growing fluid domain becomes so mobilized only when it attains the critical vertical dimension required for hydrostatic instability. This dimension, depending on the ultimate compressive yield strength of the rock, may be as much as several kilometers.Any column of fluid ascending through fractures in the solid lithosphere from a prolific deep source must become organized into a vertical sequence of discrete domains, separated by fluid-pressure discontinuities. This is required because a continuous hydrostatic-fluid-pressure profile extending from an arbitrarily deep source to the surface cannot be permitted by the finite strength of rock. A vertically stacked sequence of domains allows the internal fluid-pressure profile to approximate the external rock-stress profile in a stepwise fashion. The pressure discontinuity below the base of the uppermost hydrostatic domain may be responsible for some occurrences of so-called anomalous geopressures. An ascending stream of fluid that percolates upward from a deep source through a column of domains must encounter a sequence of abrupt pressure decreases at the transitions between successive domains. If supercritical gases act as solvents, the dissolved substances may drop out of solution at such pressure discontinuities, resulting in a local concentration of minerals and other substances.At great depths, brittle fracture would normally be prevented by high pressure and temperature, with all excessive stress discharged by ductile flow. Rock strata invaded by an ascending fluid domain are weakened, however, because cracks generated or reactivated by the high-pressure fluid can support the overburden, greatly reducing internal friction. This reduction of strength may cause a previously stressed rock to fail, resulting in hydraulic shear fracture. Thus, earthquakes may be triggered by the buoyant migration of deep-source fluids.The actual timing of the failure that leads to such an earthquake may be determined by the relatively rapid inflation of a fluid domain and not by any significant increase in the probably much slower rate of regional tectonic strain. Many earthquake precursory phenomena may be secondary symptoms of an increase in pore-fluid pressure, and certain coseismic phenomena may result from the venting of high-pressure fluids when faults break the surface. Instabilities in the migration of such fluid domains may also contribute to or cause the eruption of mud volcanoes, magma volcanoes, and kimberlite pipes.