Development of deflation lag surfaces

A series of wind tunnel tests were carried out to investigate the development of deflation lags in relation to the non-erodible roughness element concentration. Glass spheres (18 mm in diameter) were placed along the complete length of the wind tunnel working section in regular staggered arrays using three different spacings (d=18, 30 and 60 mm) and completely covered with a 0.27-mm erodible sand. A pre-selected free stream velocity above threshold (8m s^?1) was established above the surface and the sediment transport measured at 2-s intervals using a wedge-shaped trap in which an electronic balance is incorporated. Throughout each test, the emerging lag surface was periodically photographed from above at two locations upwind of the trap. The photographs were electronically scanned and analysed to calculate the lag element coverage and location, as well as mean height and frontal area for each time period. Test results indicate that lag development has a profound effect on both the sediment flux and wind profile characteristics. Initially, there is an increase in sediment flux above that for a rippled sand bed because of increased erosion around and reduced kinetic energy loss in highly elastic collisions with the emerging roughness elements. With further emergence, a dynamic threshold is reached whereupon the sediment flux decreases rapidly, tending towards zero. At this point, the supply of grains to the air stream through fluid drag follows a reduction in aerodynamic roughness and, therefore, surface shearing stress. At least as important is the lesser potential for grain ejection at impact because of reduced momentum imparted from the air stream during saltation. Although recent shear stress partitioning models indicate when particle movement may commence on varying surfaces, our experimental results demonstrate that this partitioning has a further direct bearing upon the saltation flux ratio.