A theory of concentric, kink and sinusoidal folding and of monoclinal flexuring of compressible, elastic multilayers: IV. Development of sinusoidal and kink folds in multilayers confined by rigid boundaries

This part concerns folding of elastic multilayers subjected to principal initial stresses parallel or normal to layering and to confinement by stiff or rigid boundaries. Both sinusoidal and reverse-kink folds can be produced in multilayers subjected to these conditions, depending primarily upon the conditions of contacts between layers. The initial fold pattern is always sinusoidal under these ideal conditions, but subsequent growth of the initial folds can change the pattern. For example, if contacts between layers cannot resist shear stress or if soft elastic interbeds provide uniform resistance to shear between stiff layers, sinusoidal folds of the Biot wavelength grow most rapidly with increased shortening. Further, the Biot waves become unstable as the folds grow and are transformed into concentric-like folds and finally into chevron folds. Comparison of results of the elementary and the linearized theories of elastic folding indicates that the elementary theory can accurately predict the Biot wavelength if the multilayers contain at least ten layers and if either the soft interbeds are at most about one-fifth as stiff as the stiff layers, or there is zero contact shear strength between layers.Multilayers subjected to the same conditions of loading and confinement as discussed above, can develop kink folds also. The kink fold can be explained in terms of a theory based on three assumptions: each stiff layer folds into the same form; kinking is a buckling phenomenon, and shear stress is required to overcome contact shear strength between layers and to produce slippage locally. The theory indicates that kink forms will tend to develop in multilayers with low but finite contact shear strength relative to the average shear modulus of the multilayer. Also, the larger the initial slopes and number of layers with contact shear strength, the more is the tendency for kink folds rather than sinusoidal folds to develop. The theoretical displacement form of a layer in a kink band is the superposition of a full sine wave, with a wavelength equal to the width of the kink band, and of a linear displacement profile. The resultant form resembles a one-half sine curve but it is significantly different from this curve. The width of the kink band may be greater or less than the Biot wavelength of sinusoidal folding in the multilayer, depending upon the magnitude of the contact shear strength relative to the average shear modulus. For example, in multilayers of homogeneous layers with contact strength, the Biot wavelength is zero so that the width of the kink band in such materials is always greater than the Biot wavelength. In general, the higher the contact strength, the narrower the kink band; for simple frictional contacts, the widths of kink bands decrease with increasing confinement normal to layers. Widths of kink bands theoretically depend upon a host of parameters — initial amplitude of Biot waves, number of layers, shear strength of contacts between layers, and thickness and modulus ratios of stiff-to-soft layers — therefore, widths of kink bands probably cannot be used readily to estimate properties of rocks containing kink bands. All these theoretical predictions are consistent with observations of natural and experimental kink folds of the reverse variety.Chevron folding and kink folding can be distinctly different phenomena according to the theory. Chevron folds typically form at cores of concentric-like folds; they rarely form at intersections of kink bands. In either case, they are similar folds that develop at a late stage in the folding process. Kink folds are more nearly akin to concentric-like folds than to chevron folds because kink folds form early, commonly before the sinusoidal folds are visible. Whereas concentric-like folds develop in response to higher-order effects near boundaries of a multilayer, kink folds typically initiate in response to higher-order shear, as at inflection points near mid-depth in low-amplitude, sinusoidal fold patterns. Chevron folding and kink folding are similar in elastic multilayers in that elastic “yielding” at hinges can produce rather sharp, angular forms.