首页 | 本学科首页   官方微博 | 高级检索  
     检索      

Did the Ms7.0 Lushan earthquake dynamically trigger earthquakes in the Datong volcanic region (Shanxi Province)?
作者姓名:Meiqin Song  Yong Zheng  Rui Fu  Xiangjun Li-ang  Xia Wang  Li Li  Bin Li
作者单位:[1]National Scientific Field Observatory of Continental Rift Dynamics in Taiyuan, Shanxi Seismic Bureau, Taiyuan 030021, China [2]State Key Laboratory of Geodesy and Dynamics, Institute ofGeodesy and Geophysics, Chinese Academy of Sciences,Wuhan 430077, Hubei, China [3]Graduate School, Chinese Academy of SciencesBeijing 100049, China
基金项目:This study was financially supported by Office of Science and Technology in Shanxi province based on research Projects (2012011029), National Natural Science Foundation (41174086), Scientific and Technological Research Project in Shanxi province (20100311129-2, 20090311084) and the China Earthquake Administration Spark Project (XH1005, XH13004).
摘    要:Immediately following the Ms7.0 Lushan earthquake on April 20, 2013, using high-pass and low- pass filtering on the digital seismic stations in the Shanxi Province, located about 870-1,452 km from the earthquake epicenter, we detected some earthquakes at a time corre- sponding to the first arrival of surface waves in high-pass filtering waveform. The earthquakes were especially noticed at stations in Youyu (YUY), Shanzizao (SZZ), Shanghuangzhuang (SHZ), and Zhenchuan (ZCH), which are located in a volcanic region in the Shanxi Province,but they were not listed in the Shanxi seismic observation report. These earthquakes occurred 4-50 rain after the passage of the maximum amplitude Rayleigh wave, and the periods of the surface waves were mainly between 15 and 20 s following. The Coulomb stresses caused by the Ray- leigh waves that acted on the four stations was about 0.001 MPa, which is a little lower than the threshold value of dynamic triggering, therefore, we may conclude that the Datong volcanic region is more sensitive to the Coulomb stress change. To verify, if the similar phenomena are widespread, we used the same filtering to observecontrastively continuous waveform data before, and 5 h after, the Ms7.0 Lushan earthquake and Ms9.0 Tohoku earthquake in 2011. The results show that the similar phenomena occur before the earthquakes, but the seis- micity rates after the earthquakes are remarkably increased. Since these weak earthquakes are quite small, it is hard to get clear phase arrival time from three or more stations to locate them. In addition, the travel time differences between P waves and S waves (S-P) are all less than 4 s, that means the events should occur in 34 km around the stations in the volcanic region. The stress of initial dynamic triggering of the Ms9.0 Tohoku earthquake was about 0.09 MPa, which is much higher than the threshold value of dynamic triggering stress. The earthquakes after the Ms9.0 Tohoku earthquake are related to dynamic triggering stress, but the events before the earthquake cannot be linked to seismic events, but may be related to the back- ground seismicity or from other kinds of local sources, such as anthropogenic sources (i.e., explosions). Using two teleseismic filtering, the small background earthquakes in the Datong volcanic region occur frequently, thus we postulate that previous catalog does not apply bandpass filter to pick out the weak earthquakes, and some of the observed weak events were not triggered by changes in the dynamic stress field.

关 键 词:触发地震  火山区  山西省  大同  庐山  地震事件  数字地震台站  瑞利面波
本文献已被 维普 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号