首页 | 本学科首页   官方微博 | 高级检索  
     

软岩泡水隧道锚变形破坏模型试验
引用本文:吴相超,刘新荣,李栋梁,李维树. 软岩泡水隧道锚变形破坏模型试验[J]. 岩土力学, 2016, 37(4): 1023-1030. DOI: 10.16285/j.rsm.2016.04.015
作者姓名:吴相超  刘新荣  李栋梁  李维树
作者单位:1. 重庆大学 土木工程学院,重庆 400045;2. 长江科学院重庆分院,重庆 400014; 3. 重庆大学 山地城镇建设与新技术教育部重点实验室,重庆 400045
基金项目:青年科学基金项目(No.51409013);2015重庆市研究生科研创新项目(No.CYB15038);2013自然科学基金项目(No.41372356);中央高校基金项目(No.106112014CDJZR200008)~~
摘    要:为了研究软岩隧道锚锚体及其围岩泡水后变形破坏的特点,以在建的几江长江大桥为依托,开展了泡水状态(M2)和自然状态(M3)两组缩尺比例为1:30的现场模型试验。通过对各关键测点的试验数据分析,获得了不同状态的模型锚锚体和围岩在破坏过程中的变形特点及规律,并对隧道锚的破坏模式进行了分析。研究表明:不论是模型锚表面还是深部,试验过程中,M2各测点(锚体外侧岩体、锚间岩体等)的位移总体大于M3测点的位移,且破坏荷载值要低于M3。隧道锚围岩含水率不同,破坏模式有所差异。对于含水率为7.39%的M2,其裂隙出现顺序为先洞脸后地表,先西锚后东锚;对于含水率为5.36%的M3,其裂隙先出现在锚体上部地表,然后出现在锚洞斜面,最后在锚碇区大量出现。此外,地形条件也会使得同一含水状态的隧道锚的两个锚体的变形有所差异。研究成果可为软岩隧道锚的修建以及类似的工程设计、施工等提供参考和借鉴。

关 键 词:软岩  隧道锚  模型试验  泡水  
收稿时间:2015-08-31

Failure model test on soaked tunnel anchor in soft surrounding rock
WU Xiang-chao;LIU Xin-rong;LI Dong-liang;LI Wei-shu. Failure model test on soaked tunnel anchor in soft surrounding rock[J]. Rock and Soil Mechanics, 2016, 37(4): 1023-1030. DOI: 10.16285/j.rsm.2016.04.015
Authors:WU Xiang-chao  LIU Xin-rong  LI Dong-liang  LI Wei-shu
Affiliation:1. School of Civil Engineering, Chongqing University, Chongqing 400045, China; 2. Chongqing Branch of Yangtze River Scientific Research Institute, Chongqing 400014, China; 3. Key Laboratory of New Technology for Construction of Cities in Mountain Area of Ministry of Education, Chongqing University, Chongqing 400045, China
Abstract:To investigate the deformation and failure characteristics of the anchor and soft surrounding rock in the soaked tunnel, two scale model tests are carried out based on the building Yangtze River bridge project at Jijiang. These two model tests are soaked state tunnel anchor model M2 and natural state tunnel anchor model M3. The reduced scale ratio is 1:30. By analysing the data from key measuring points, the deformation characteristics and rules of the tunnel anchor and its soft surrounding rock at different states are achieved. The results show that either on the surface or in the interior of the tunnel anchor, the measuring displacement of M2 is greater than that of M3, but the failure load value of M2 is lower than that of M3. There are various failure modes caused by different moisture contents. For model M2 with a moisture content of 7.39%, the cracks appear firstly at the surface of tunnel anchor hole and the west tunnel anchor, following at the ground surface and the east tunnel anchor. For model M3 with a moisture content of 5.36%, the cracks are initially observed at the ground surface of the upper part of the tunnel anchor, then at the side face of the tunnel anchorage hole and finally in other parts. Furthermore, the terrain also results in the deformation difference of tunnel anchorage with the same water content.
Keywords:soft surrounding rock  tunnel anchorage  model test  soaked  
本文献已被 CNKI 等数据库收录!
点击此处可从《岩土力学》浏览原始摘要信息
点击此处可从《岩土力学》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号