Measurement of the Sensible Eddy Heat Flux Based on Spatial Averaging of Continuous Ground-Based Observations

Using the standard eddy-covariance (EC) method to quantify mass and energy exchange at a single location usually results in an underestimation of vertical eddy fluxes at the surface. In order to better understand the reasons for this underestimation, an experimental set-up is presented that is based on spatial averaging of air temperature data from a network of ground-based sensors over agricultural land. For eight days during the 34-day observational period in May and June 2007, additional contributions to the sensible heat flux of more than 50Wm⁻² were measured in the lower surface layer by applying the spatial EC method as opposed to the standard temporal EC method. Smaller but still significant additional sensible heat fluxes were detected for four more days. The additional energy is probably transported in organised convective structures resulting in a mean vertical wind velocity unequal to zero at the tower location. The results show that convective transport contributes significantly to the surface energy budget for measurement heights as low as 2–3 m. Since these structures may be quasi-stationary, they can hardly be captured by a single-location measurement. The spatial EC set-up presented here is capable of quantifying contributions to the sensible heat flux from structures up to the scale of our spatial sensor network, which covered an area 3.5 × 3.5 km. For future experiments aiming at closing the energy balance, the spatial EC method should be employed to measure both the sensible and latent heat fluxes. Experimental determination of the horizontal advection of sensible and latent heat should also be considered, since such transport must occur due to convergence and divergence related to convection.