Some Aspects of Energy Balance and Tsunami Generation by Earthquakes and Landslides

— Tsunamis are generated by displacement or motion of large volumes of water. While there are several documented cases of tsunami generation by volcanic eruptions and landslides, most observed tsunamis are attributed to earthquakes. Kinematic models of tsunami generation by earthquakes — where specified fault size and slip determine seafloor and sea-surface vertical motion — quantitatively explain far-field tsunami wave records. On the other hand, submarine landslides in subduction zones and other tectonic settings can generate large tsunamis that are hazardous along near-source coasts. Furthermore, the ongoing exploration of the oceans has found evidence for large paleo-landslides in many places, not just subduction zones. Thus, we want to know the relative contribution of faulting and landslides to tsunami generation. For earthquakes, only a small fraction of the minimum earthquake energy (less than 1% for typical parameter choices for shallow underthrusting earthquakes) can be converted into tsunami wave energy; yet, this is enough energy to generate terrible tsunamis. For submarine landslides, tsunami wave generation and landslide motion interact in a dynamic coupling. The dynamic problem of a 2-D translational slider block on a constant-angle slope can be solved using a Green's function approach for the wave transients. The key result is that the largest waves are generated when the ratio of initial water depth above the block to downslope vertical drop of the block H ₀ /W sin δ is less than 1. The conversion factor of gravitational energy into tsunami wave energy varies from 0% for a slow-velocity slide in deep water, to about 50% for a fast-velocity slide in shallow water and a motion abruptly truncated. To compare maximum tsunami wave amplitudes in the source region, great earthquakes produce amplitudes of a few meters at a wavelength fixed by the fault width of 100 km or so. For submarine landslides, tsunami wave heights — as measured by b, block height — are small for most of the parameter regime. However, for low initial dynamic friction and values of H ₀ /W sin δ less than 1, tsunami wave heights in the downslope and upslope directions reach b and b/4, respectively.Wavelengths of these large waves scale with block width. For significant submarine slides, the value of b can range from meters up to the kilometer scale. Thus, the extreme case of efficient tsunami generation by landslides produces dramatic hazards scenarios.