Review of Microstructural Evidence of Magmatic and Solid-State Flow

Evidence of magmatic flow includes: (a) parallel to sub-parallel alignment of elongate euhedral crystals (e.g., of feldspar or hornblende) that are not internally deformed, (b) imbrication (‘tiling’) of elongate euhedral crystals that are not internally deformed, (c) insufficient solid-state strain in regions between aligned or imbricated crystals to accommodate phenocryst rotation, (d) elongation of microgranitoid enclaves without plastic deformation of the minerals, (e) magmatic flow foliations and elongate microgranitoid enclaves deflected around xenoliths, and (f) schlieren layering (if due to flow sorting) in the absence of plastic deformation of the minerals involved. These features are consistent with rotation of crystals in a much weaker medium, namely a melt phase, at a stage when the magma has become viscous enough to preserve the alignment.Evidence of solid-state flow includes: (a) internal deformation and recrystallization of grains, (b) recrystallized “tails,” (c) elongation of recrystallized aggregates (e.g. of quartz and mica), (d) grainsize reduction, (e) fine-grained folia anastomosing around less deformed relics, (f) microcline twinning, (g) myrmekite, (h) flame perthite, (i) boudinage of strong minerals, typically with recrystallized aggregates of weaker minerals (e.g. quartz and mica) between the boudins, (j) foliation passing through, rather than around enclaves, and (k) heterogeneous strain with local mylonitic zones.Several criteria suggest “submagmatic flow,” including recrystallized feldspar, inferred transitions from magmatic imbrication to solid-state S/C arrangements, evidence of c-slip in quartz, and especially evidence of migration of residual melt into lower-pressure sites.Recent experimental studies indicate that a change from grain-supported flow to suspension flow typically occurs in deforming magmas at melt contents of between 20% to 40%, and that large amounts of strain may accumulate in magmas without being recorded by the final fabric. At lower melt percentages, perhaps as low as a few percent, depending on the minerals and their shapes, strain may be accommodated by: (a) melt-assisted grain-boundary sliding, (b) contact-melting assisted grain-boundary migration, (c) strain partitioning into melt-rich zones, (d) intracrystalline plastic deformation (c-slip in quartz indicating plastic deformation at temperatures near the granite solidus), and (f) transfer of melt to sites of low mean stress. The only indication of strain in the absence of crystal plasticity may be an alignment of crystals. Moreover, magmatic flow microstructures may be destroyed by fracturing, crystal plasticity and recrystallization before the magma reaches its solidus.Many rocks show evidence of solid-state flow superimposed on magmatic flow. Evidence of magmatic flow is commonly preserved in deformed felsic metamorphic rocks: for example the alignment of rectangular K-feldspar megacrysts and of microgranitoid enclaves. However, absence of alignment does not preclude a magmatic origin for K-feldspar megacrysts in felsic gneisses, as magmatic flow may cease before the magma becomes viscous enough to preserve an alignment.