Gas retention in fine-grained pyroclastic flow materials at high temperatures |
| |
Authors: | T H Druitt G Avard G Bruni P Lettieri F Maez |
| |
Institution: | (1) Laboratoire Magmas et Volcans, Université Blaise Pascal CNRS & IRD, Clermont-Ferrand, France;(2) Department of Chemical Engineering, University College London, London, UK |
| |
Abstract: | The ability of a dense pyroclastic flow to maintain high gas pore pressure, and hence low friction, during runout is determined
by (1) the strengths and longevities of gas sources, and (2) the ability of the material to retain residual gas once those
sources become ineffective. The latter is termed the gas retention capacity. Gas retention capacity in a defluidizing granular material is governed by three timescales: one for the evacuation of bubbles
(t
be ; brief and not considered in this paper), one for hindered settling from the expanded state (t
sett), and one for diffusive release of residual pore pressure from the non-expanded state (t
diff). The relative magnitides of t
sett and t
diff depend on bed thickness, t
sett dominating in thin systems and t
diff in thick ones. Three pyroclastic flow materials, two ignimbrites and a block-and-ash flow sample, were studied experimentally
to investigate expansion behaviour under gas flow and to determine gas retention times. Effects of particle size were evaluated
by using two size cuts (<4 mm and <250 μm) from each sample. Careful drying of the materials was necessary to avoid effects
of humidity-related cohesion. Two sets of experiments were carried out: (1) expansion in the non-bubbling regime at 50–200°C,
(2) bed collapse tests from the initially bubbling state at 50–550°C. Provided that gas channelling was avoided by gentle
stirring, all the samples exhibited a regime of uniform expansion prior to the onset of bubbling. Fine particle size (in particular
high fines content), low particle density and high temperature all favoured smoother fluidization by increasing the maximum
expansion possible in the non-bubbling state. An empirical equation describing the uniform expansion of the materials was
determined. High temperature also favoured greater gas partitioning into the dense phase of the bubbling bed, as well (in
finer-grained samples) as higher voidage in the settled bed. Large values of t
sett and t
diff were favoured by fine particle size. Temperature had less influence, suggesting that experimental results at low temperatures
(50–200°C) can be extrapolated to higher temperatures. Gas retention times provide insight into the ability of pyroclastic
flows in expanded (t
sett) or non-expanded (t
diff) flow states to retain gas once air ingestion or gas production have become ineffective. Finer-grained pyroclastic flows
are expected to retain gas longer, and hence to have higher apparent ‘mobilities’, than coarser-grained ones of comparable
volume, as has been observed on Montserrat. |
| |
Keywords: | Pyroclastic flows Fluidization Sedimentation Hindered settling Montserrat |
本文献已被 SpringerLink 等数据库收录! |
|