Inflow and outflow in a rotating circular container—A laboratory model for the Loop Current of the Gulf of Mexico

The Loop Current of the Gulf of Mexico is simulated in the laboratory. A circular tank is filled with water and is placed off-center on a rotating table and the flow field is generated by injecting and withdrawing water at two openings on the wall. The free surface becomes parabolic due to balance of gravitational and centrifugal forces, simulating the latitudinal change of the Coriolis parameter (-effect) in the ocean. The flow characteristics depend on the influx and the rate of rotation and can be classified according to non-dimensional parameters (Rossby, Ekman and Froude numbers denoted byR ₀,E andF, respectively). When the influx is small and the rotation rate is large (smallR ₀,E andF) the flow will be almost linear, and the fluid flows along the side-wall boundary layer under constraint of the -effect. For a very large influx (largeR ₀ andE) inertial forces become very large compared to the Coriolis force and the flow behaves like a potential flow. The flow studied had characteristics between these two extreme cases and hasR ₀ andF similar to the Gulf circulation, though similarity inE is ambiguous. Photographs of the flow indicate that the inflow penetrates further into the interior when the rotation rate is increased while the influx is kept constant. The numerical analysis of the non-linear vorticity equation confirms this for the parameters corresponding to the experiment. In addition, the photographs reveal eddies embedded on both sides of the main stream, particularly near the inflow region. These eddies are intensified and become uniform in size as the influx increases. It is pointed out that such eddies were actually observed near the Loop Current north of the Yucatan Straits.