Seismicity changes associated with reservoir loading

Changes in seismic activity have been related to the filling of large reservoirs in over thirty cases. These changes range from variations in the level of micro-earthquake activity detectable only with instruments of high sensitivity to destructive earthquakes with magnitudes greater than 6. On the other hand, the filling of many other large reservoirs has not been accompanied by increased seismicity.

A number of factors may contribute to the generation or absence of post-impounding seismicity. Increased vertical stress due to the load of the reservoir and decreased effective stress due to increased pore pressure can modify the stress regime in the reservoir region. Whether or not these stress changes are sufficient to generate earthquake activity will depend on a complex interaction of the induced stress with the state of pre-existing stress near the reservoir, and on the geologic and hydrologic conditions at the site. The combined effect of increased vertical load and increased pore pressure will have the greatest tendency to increase activity in regions where the maximum compressive stress is vertical (normal faulting). In regions where the minimum compressive stress is vertical (thrust faulting) increased stress due to a vertical load should have a minimum effect. For all of the larger reservoir-induced earthquakes the stress system determined from fault plane solutions is in agreement with the pre-existing stress field in the region of the reservoir. These earthquakes are all of strike-slip or normal type, there being no reported cases of large induced earthquakes with thrusting mechanisms.

The potential for major changes in seismicity may be highest in regions of moderate strain accumulation (low to moderate natural seismicity). In areas of high strain accumulation and high levels of natural seismicity, the stress changes induced by the reservoir will be small compared to natural variations. In aseismic areas, with low strain accumulation, the reservoir-induced stresses may be insufficient to raise the stress level to a state of failure.