A simple lumped mass model to describe velocity of granular flows in a large flume |
| |
Authors: | Qingqing Yang Fei Cai Keizo Ugai Zhiman Su Runqiu Huang Qiang Xu |
| |
Affiliation: | 1. Department of Civil and Environmental Engineering, Gunma University, Kiryu, 3768515, Japan 2. Institute of Mountain Hazards and Environment, Chinese Academy of Sciences, Chengdu, 610041, China 3. State Key Laboratory of Geo-Hazard Prevention and Geo-Environment Protection, Chengdu University of Technology, Chengdu, 610059, China
|
| |
Abstract: | This paper presents a lumped mass model to describe the run-out and velocity of a series of large flume tests, which was carried out to investigate some propagation mechanisms involved in rapid, dry, dense granular flows and energy transformation when the flows encountered obstacles and reoriented their movement directions. Comparisons between predicted and measured results show that the trend of predicted velocities was basically matched with that of measured ones. Careful scrutiny of test videos reveals that subsequent particles with a higher velocity collided with slowed fronts to make them accelerate. However, this simple model cannot reflect collisions between particles because it treated released materials as a rigid block. Thus, the predicted velocity was somewhat lower than the measured velocity in most cases. When the flow changed its direction due to the variation in slope inclination, the model predicted a decrease in velocity. The predicted decrease in velocity was less than the measured one within a reasonable range of 10% or less. For some cases in which a convexity was introduced, the model also predicted the same trend of velocities as measured in the tests. The velocity increased greatly after the materials took a ballistic trajectory from the vertex of the convexity, and reduced dramatically when they finally made contact with the base of the lower slope. The difference between prediced and measured decrease in velocity was estimated to be about 5% due to the landing. Therefore, the simple lumped mass model based on the energy approach could roughly predict the run-out and velocity of granular flows, although it neglected internal deformation, intergranular collision and friction. |
| |
Keywords: | Granular flow Large-scale flume test Mass-front velocity Deposit characteristic |
本文献已被 CNKI SpringerLink 等数据库收录! |
|