Solution mechanisms of silicate in aqueous fluid and H2O in coexisting silicate melts determined in-situ at high pressure and high temperature

The structure of H₂O-saturated silicate melts, coexisting silicate-saturated aqueous solutions, and supercritical silicate liquids in the system Na₂O·4SiO₂–H₂O has been characterized with the sample at high temperature and pressure in a hydrothermal diamond anvil cell (HDAC). Structural information was obtained with confocal microRaman and with FTIR microscopy. Fluids and melts were examined along pressure-temperature trajectories defined by the isochores of H₂O at nominal densities, ρ_fluid, (from EOS of pure H₂O) of 0.90 and 0.78 g/cm³. With ρ_fluid = 0.78 g/cm³, water-saturated melt and silicate-saturated aqueous fluid coexist to the highest temperature (800 °C) and pressure (677 MPa), whereas with ρ_fluid = 0.90 g/cm³, a homogeneous single-phase liquid phase exists through the temperature and pressure range (25–800 °C, 0.1–1033 MPa). Less than 5 vol% quartz precipitates near 650 °C in both experimental series, thus driving Na/Si-ratios of melt + fluid phase assemblages to higher values than that of the Na₂O·4SiO₂ starting material.Molecular H₂O (H₂O°) and structurally bonded OH groups were observed in coexisting melts and fluids as well as in supercritical liquids. Their OH/(H₂O)-ratio is positively correlated with temperature. The OH/(H₂O)° in melts is greater than in coexisting fluids. Structural units of Q³, Q², Q¹, and Q⁰ type are observed in all phases under all conditions. An expression of the form, 12Q³ + 13H₂O2Q² + 6Q¹ + 4Q⁰, describes the equilibrium among those structural units. This equilibrium shifts to the right with increasing pressure and temperature with a ΔH of the reaction near 425 kJ/mol.