Experimental simulation of martian gully forms

Gullies are widespread on slopes on the surface of Mars and have been investigated by numerous authors, yet their formation processes remain elusive. In an attempt to understand the possibility of a water-based origin for these forms, we undertook a series of flume experiments at Earth surface temperatures and pressures. Our objectives were to produce forms that resemble those most commonly observed on Mars, documenting their morphometric characteristics and identifying any statistically significant relationships between form and controlling factors of slope and flow rate. Experiments were conducted in a 1×1.5 m² flume filled with medium grain size sand. The experiments were run over a slope angle range of 10–30°, corresponding to the range for gullies on Mars. Water from a constant-head tank fed through 5 mm silicone hose to a rotameter and then released just below the surface at the top of the slope. Gullies were produced at slope angle values of 10°, 20°, and 30° and flow rate values of 445, 705, 965, and 1260 mL min^?1 at each angle. Eighteen parameters were identified and subsequently measured on each gully produced in the flume. Gully forms were successfully reproduced and displayed development of the fundamental morphological components observed on Mars: alcove, channel, and apron. Slope–gully form relationships for each component revealed the following results: higher slope angles formed shorter gullies with thicker apron deposits. Moreover, longer gullies were seen at higher flow rates. We concluded that forms visually similar to those observed on Mars can be created by water in the laboratory flume under terrestrial conditions. Morphometric parameters can be measured and permit identification of controlling factors. Experimental simulation of gullies appears possible with proper scaling of experimental parameters. Although not directly scalable to Mars, flume gully parameters may be used to develop numerical models in the future.