Channel processes as a factor controlling accumulation of heavy metals in river bottom sediments: consequences for pollution monitoring (Upper Silesia, Poland)

 An evaluation of the influence of channel processes (erosion, accumulation, processing of channel sediments) on the dispersal of heavy metals in bottom sediments was carried out in the channels of the Sztoła and Biała Przemsza rivers in Upper Silesia, Poland. These rivers receive waters from a Zn and Pb mine. Mine waters transport a large amount of fine-grained sediments contaminated with heavy metals. The polluted material is accumulated in these stream courses and mixed with nearly homogeneous sandy sediment derived from erosion of the river banks and bed. Because these alluvia are easily set in motion, the distribution of heavy metal concentration in the channel in fraction <1 mm reflects differences in physical processes of sedimentation in its cross-section. The minimal values in active channel and maximal in the near-bank zone are typical for those channel sections where heavy metals, present in a solid state, are transported as a suspended load (normally the largest part of a polluted river course). In short sections heavy metals associated with the grains of a large mass which has accumulated in the active channel are transported as a bed load and the typical distribution pattern is reversed (in fractions both <1 mm and <0.063 mm). Such regularities can be disturbed in localities where strong, turbulent flow or frequent eddying occur and Mn oxides and hydrooxides and associated elements precipitate. The smallest variation in heavy metal concentration in the homogenous, fine-grained bank sediments which are trapped by plants below water level is a feature which recommends these localities as being the most suitable for monitoring of river pollution. Received: 11 November 1997 · Accepted: 12 March 1998