The deformation evaluation of Kızlaç T3A Tunnel (Osmaniye, Turkey) |
| |
Authors: | Ahmet
zbek, Sedat Tü rkmen,Murat Gü l |
| |
Affiliation: | a Department of Geological Engineering, Çukurova University, 01330, Adana, Turkey b Department of Geological Engineering, Mersin University, 33343 Icel, Turkey c Department of Geological Engineering, Çukurova University, 01330, Adana, Turkey |
| |
Abstract: | This study covers the graphical analysis of deformation values measured in the Kızlaç T3A tunnel (Osmaniye, Turkey), which was built as a part of the Tarsus–Adana–Gaziantep Motorway Project. Excavation was performed through a sequence which was composed of sandstone–shale alternation, sandstone and dolerite dyke. Horizontal, longitudinal and settlement deformation values were optically read and recorded daily on a computer. These data were evaluated according to New Austrian Tunneling Method. Total deformation measurement, risky area determination and forecast of transitions between weak and stiff rock, stiff and weak rock were assessed as a result of deformation evaluation for tunnel stability, safety and economy. The largest resultant deformation value (13 mm) was measured in the sandstone–shale alternation between chainage 500 and 550 m, which was highly weathered by groundwater and affected by local tectonic disturbance. The smallest deformation value was observed in a stiff dolerite dyke between 370 and 430 m, where at times the deformation values decreased to zero. In the sandstone, small resultant deformation values (2–4 mm) were also recorded. The 500–550-m interval of tunnel alignment had the highest risk for tunnel instability in the studied section but the deformation values (maximum 13 mm) were within the tolerable deformation range (10 cm). Small negative longitudinal deformation values decreasing between chainage 320 and 370 m and small positive longitudinal deformation values decreasing between 420 and 480 m indicate the sandstone–shale alternation (weak rock) and the dyke (stiff rock) and sandstone (stiff rock), and the sandstone–shale alternation with a fault gauge zone (weak rock), respectively. These longitudinal deformations needed probable to predict the lithological transitions ahead of the face, which in timely were used to determination of the tunnel support system. |
| |
Keywords: | Evaluation monitoring Tunnel Kızlaç Deformation |
本文献已被 ScienceDirect 等数据库收录! |
|