| Abstract: | The quality of Vibroseis survey data can be improved by continuously monitoring the vibrator's baseplate and reaction mass accelerations. Equipment failures can be detected as they occur, rather than relying on similarity trials at the beginning and end of the day's production. Equipment faults can then be corrected as they happen and thus would not have a detrimental effect on the quality of the survey data. Source efficiency can be optimized by monitoring the amount of harmonic distortion generated by the vibrator at different drive levels on the different surfaces which may be encountered during a survey. Phase problems introduced by poor coupling of the baseplate to the ground can also be identified and addressed in the field. Rapid analysis of vibrator signals is required if continuous monitoring is to be useful. Frequency-time (f-t) analyses of vibrator signals are often used in processing centres, but are slow and require a large storage capacity which makes the technique unsuitable for a field analysis system. The two methods proposed to analyse vibrator signals entail the use of hodograms and time-varying notch filters. Hodograms provide a qualitative analysis of harmonic distortion and vibrator performance. A fast, time-varying notch filter gives quantitative and qualitative information about the harmonic distortion present in the signal and can be used to identify problems with vibrator behaviour. Both the hodogram and fast, time-varying notch filter methods can analyse the vibrator's reaction mass and baseplate accelerations as it progresses through its sweep and can present automatically interpreted results to the operator before moving to the next vibrator point. |
