Thermobarometric data from a fossil zircon partial annealing zone in high pressure–low temperature rocks of eastern and central Crete, Greece

A fossil partial annealing zone of fission tracks in zircon is described from high pressure–low temperature (HP–LT) rocks of the Phyllite–Quartzite Unit (PQ) on the island of Crete, Greece. Correlation of regional trends in fission track age populations with independent thermobarometric and microstructural data, and with new experimental annealing results, allows a calibration of this low temperature thermochronological method to a degree hitherto not available from other field examples.The zircon fission track (FT) ages of samples from the PQ across Crete range from original detrital signature through reduced to completely reset. The annealing is the result of a single heating period related to the HP–LT metamorphism with near-peak temperatures lasting for only a few million years some time between 24±1 and 20±1 Ma. In eastern Crete, where rocks have experienced temperatures of 300±50 °C and pressures of 0.8±0.3 GPa, zircon FT ages range from 414±24 to 145±10 Ma. Ages above 300 Ma occur mostly near the east coast of the island in rocks which have not been heated to above ca. 280 °C and probably represent a pre-Variscan source. Track lengths are already indicative of a substantial annealing at this temperature. Most of the zircon FT ages from eastern Crete scatter within error around the stratigraphic age. Samples with apparent zircon FT ages significantly younger than the depositional age are only observed in areas where temperatures exceeded ca. 320 °C. Towards the west, a sudden decrease to very young ages ranging from 17±2 to 18±1 Ma reflects a complete resetting at ca. 350 °C. Short tracks, however, are still observed. Throughout the central and western part of the island, ages are consistently below 22 Ma. Thermobarometric data for this area indicate maximum temperatures of 400±50 °C and pressures of 1±0.3 GPa. Only samples from western Crete, which have been exposed to 400±50 °C, show exclusively long tracks. Consequently, the high temperature limit of the zircon partial annealing zone (ZPAZ) appears to be between 350 and 400 °C.A significant influence of elevated confining pressure on the stability of fission tracks in zircon is ruled out by the results of annealing experiments at 0.5 GPa and at different temperatures, which fit the curves previously obtained by other authors at ambient pressure.