Analysis of three-dimensional, homogeneous, finite strain using ellipsoidal objects

It has been suggested (Oertel, 1971, 1972;Owens, 1974; Shimamoto and Ikeda, 1976) that some methods for analysis of finite homogeneous strain from deformed ellipsoidal objects (Ramsay, 1967; Dunnet, 1969a; Elliott, 1970; Dunnet and Siddans, 1971; Matthews et al., 1974) require sections to be cut in principal planes of the finite strain ellipsoid. A mathematical model is presented which enables the homogeneous deformation of a randomly oriented ellipsoid to be investigated. In particular the elliptical shapes that result on any three mutually perpendicular sections through the ellipsoid, in the deformed state, can be computed, together with the corresponding strain ellipses. The resulting ellipses can be unstrained in the section planes by applying the corresponding reciprocal strain ellipses. It is shown that these restored ellipses are identical with the elliptical shapes that result on planes through the original ellipsoid when the planes are parallel to the unstrained orientation of the section planes.The model is extended to investigate the finite homogeneous deformation of a suite of 100 randomly oriented ellipsoids of constant initial axial ratio. The pattern of elliptical shapes that result on any three mutually perpendicular section planes, in the deformed state, is computed. From this data the two-dimensional strain states in the section planes are estimated by a variety of methods. These are combined to recalculate the three-dimensional finite strain that was imposed on the system. It is thus possible to compare the results of the two- and three-dimensional analyses obtained by the various methods. It is found that providing all six independent combinations of the two-dimensional strain data are used to compute a best finite strain ellipsoid, the methods of Dunnet (1969a), Matthews et al. (1974) and Shimamoto and Ikeda (1976) provide accurate estimates of the three-dimensional finite strain state.It is concluded that measurement of the two-dimensional data on section planes parallel to the principal planes of the finite strain ellipsoid is not necessary and that all six independent combinations of the two-dimensional strain data should always be made and used to compute a best finite strain ellipsoid.