Holocene and late-Pleistocene sedimentation in the Adriatic Sea |
| |
Authors: | Prof. Dr. L. M. J. U. van Straaten |
| |
Affiliation: | (1) Present address: Geologisch Instituut, Melkweg 1, Groningen, Netherlands |
| |
Abstract: | The following paper is a summary of sedimentological data on the Adriatic Sea (with the exception of the areas along the Jugoslavian and Albanian coasts). Because it is difficult to summarize a summary, only a few of the main conclusions will be mentioned here.Geophysical investigations indicate that the top of the limestone series, underlying the clayey and sandy deposits of the Pliocene and the Quaternary in the Adriatic area has a very uneven topography. Its greatest depths (4–6 km) are found a) between Ravenna and Rimini, b) between San Benedetto and Pescara, and c) below the Albanian shelf.Recent sands are mainly limited to the littoral zone; pleistocene sand, originally supplied by rivers, covers the greater part of the deeper shelf. Between these zones a terrace-shaped pro-littoral mud belt is present, where the bulk of the recent terrigenous mud is deposited. The maximum rate of accumulation in this belt is probably about 4 1/2 mm per year.The remaining part of the recent mud is transported in the sea water as floccules of such small size that they remain suspended over the deeper zones of the shelf. Most of it is deposited in the basins of the Central Adriatic (maximum accumulation rate for the Holocene on the average circa 1/2 mm per year) and in the bathyal basin in the southeast. The deepest area of the latter basin is formed by an almost horizontal plain (circa 1218 m deep). The longest core from this plain (240 cm of Holocene and 400 cm of late Pleistocene) is composed for roughly 61% of turbidite material, 5% of volcanic ash (coarser than fine silt), 0,2% of organic carbonate remains (coarser than silt) and 34% of normal terrigenous mud. The ash falls were limited to the central and southeastern parts of the Adriatic.
Zusammenfassung Eine kurze Übersicht wird gegeben über die sedimentologische Kenntnis der Adria (mit Ausnahme der jugoslawischen und albanischen Küstengewässer).Geophysikalische Untersuchungen zeigen, daß die Kalkstein-Oberfläche unter den tonig-sandigen Ablagerungen des Pliozäns und des Quartärs, ein starkes Relief besitzt. Sie hat ihre größten Tiefen (4–6 km) a) zwischen Ravenna und Rimini; b) zwischen San Benedetto und Pescara und c) im Untergrund des Albanischen Schelfes.Rezente Sande sind in der Hauptsache auf eine schmale Küstenzone beschränkt. Dagegen haben pleistozäne Residual-Sande, ursprünglich von Flüssen herbeigebracht, eine große Ausdehnung auf dem Schelf. Zwischen diesen beiden sandigen Zonen findet man einen pro-littoralen Schlicksaum, wo die Hauptmasse des rezent ins Meer gebrachten terrigenen Schlickes abgelagert wird. Die maximale Akkumulationsgeschwindigkeit in dieser Zone beträgt wahrscheinlich ungefähr 4 1/2 mm pro Jahr.Der Anteil des terrigenen Schlickes, der nicht in diesem prolittoralen Schlicksaum zur Ablagerung kommt, besteht aus Flocken von so kleinen Abmessungen, daß sie während ihres Transportes über den äußeren Schelf-Regionen suspendiert bleiben. Sie sedimentieren größtenteils in den Becken der Zentral-Adria (mittlere Ablagerungsrate während des Holozäns maximal etwa 1/2 mm pro Jahr) und im bathyalen Becken der Südost-Adria.Der tiefste Teil dieses südöstlichen Beckens wird von einer fast horizontalen Ebene (auf etwa 1218 m Tiefe) eingenommen. Der längste Kern, der in dieser Ebene entnommen wurde (640 cm, wovon 240 cm Holozän), hat ungefähr die folgende Zusammensetzung: 61% Turbidit-Material, 5% vulkanische Asche (Sand- und grobe Schluff-Fraktionen), 0,2% organische Kalkreste (gröber als Schluff) und 34% normaler terrigener Schlick. Die Aschenfälle waren auf die mittleren und südöstlichen Teile der Adria beschränkt.
Résumé L'auteur donne un bref résumé de la connaissance sédimentologique de la Mer Adriatique (à l'exception des parties le long des côtes Jugoslaves et Albanaises).Des recherches géophysiques indiquent que la surface du calcaire couvert par les dépôts argileux-sableux du Pliocène et du Quaternaire a un relief prononcé. Cette surface atteint des profondeurs maximales (4–6 km) a) entre Ravenna et Rimini, b) entre San Benedetto et Pescara et c) au-dessous du plateau continental Albanais.Les dépôts sableux d'âge Holocène sont limités pratiquement à l'étroite zone du littoral. Par contre, des sables pléistocènes résiduels, d'origine fluviale, couvrent de vastes étendues du plateau continental sous-marin. Entre ces deux zones sableuses, on trouve la bande vaseuse «pro-littorale», où se dépose la plus grande partie de la matière vaseuse terrigène, apportée à la mer sous les conditions actuelles. L'accumulation maximale dans cette zone est probablement de l'ordre de 4 1/2 mm par an.La partie de la vase terrigène qui dépasse cette bande pro-littorale est transportée dans la mer à l'état de flocons d'une taille si petite qu'ils restent en suspension au-dessus des parties extérieures du plateau continental. Ils sont déposés surtout dans les bassins de l'Adriatique Centrale (vitesse moyenne d'accumulation pendant l'Holocène au maximum environ 1/2 mm par an), et dans le bassin bathyal du Sud-Est.La partie la plus profonde dans ce dernier bassin est formée par une plaine presqu' horizontale (à environ 1218 m). La carotte la plus longue, tirée de cette plaine (640 cm, dont 240 cm d'Holocène) est constituée approximativement de 61% de matériel turbiditique, de 5% de matière volcanique (fractions de sable et de silt grossier), 0,2% de restes calcaires organiques (plus grossier que du silt) et 34% de vase terrigène normale. Les chutes de matière volcanique étaient limitées aux parties centrales et sud-orientales de l'Adriatique.
— . , . (4–6 ) : a) Ravenna Rimini; ) San Benedetto Pescara ) . , , - , , pro-litto-ralen , . 4,5 . , ( 1/2 ) - . 1218 . , 640 , 240 . : 61% , 5% , 0,2% 34% . - . |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|