A consideration of the dune:antidune transition in fine gravel

Hydraulic data defining the dune:antidune transition in fine gravel are compared with potential flow theory, and information is drawn from published experiments and field‐based studies. Attention is given to both transitional bedforms and the development of downstream‐migrating antidunes. In the latter case, most data pertain to sand beds and not to gravel. Empirical data provide some weak support for the theoretical notion that the transition occurs at progressively lower Froude numbers at greater relative depths. Although a critical Froude number of 0·84 may reasonably be applied for the beginning of the dune to antidune transformation, lag effects (and a possible depth limitation) ensure that transitional bedforms may persist across a broad range of Froude numbers from 0·5 to 1·8. This latter observation has great relevance for palaeohydraulic estimates derived from outcrop data. Whereas the application of theoretical bedform existence fields, based upon potential flow theory, to fine gravel was previously purely speculative, the addition of experimental and field data to these plots provides a degree of confidence in applying stability theory to practical geological problems. For the first time, laboratory data pertaining to downstream‐migrating gravel antidunes are compared with theory. These bedforms have been reported from certain experimental near‐critical flows above sand or gravel beds, but have been observed infrequently in natural streams. However, there are no detailed studies from natural rivers and only a few contentious identifications from outcrops. Nevertheless, the limited hydraulic data conform to theoretical expectations.     

Dynamic processes of a simple linear dune—a study in the Taklimakan Sand Sea, China

Samples of dune sands, surveys of the morphology and field measurements of wind velocity and direction of a simple linear dune in Taklimakan Sand Sea show that the airflow and sand flux vary with the change of wind direction on the dune surface. Decrease of the airflow stress on the lee flank does not result in much decrease of the sand flux because of the low threshold shear velocities and the airflow conditions. There are no significant relations between the sand flux on the lee flank and the angle of incidence of the airflow. The low threshold shear velocities and the maintenance of the sand flux at the lee flank are the main mechanisms keeping the linear shape of the dunes. Measurements of the sand flux shows that it reaches a maximum on the crest of the dune. The grain size of the transported sands has some differences compared to that of the dune surface. The sands transported are finer than that on the dune surface, but better sorted under the influence of the medium to low wind activity. The field experiment results exhibit that it is possible for the dunes to be shaped as linear dunes during the processes of accumulation and elongation.     

The response of subaqueous dunes to floods in sand and gravel bed reaches of the Dutch Rhine

Abstract The branches of the River Rhine in the Netherlands, characterized by a sand–gravel bed in the upstream part and a sand bed in the downstream part of the river system, show migrating dunes, especially during floods. In the last 20 years, these dunes have been studied extensively. High-resolution echo-sounding measurements of these dunes, made with single and multibeam equipment, were analysed for three different sections of the Rhine river system during several floods. This analysis was done to quantify the growth, decay and migration rates of the dunes during floods. In addition, the migrating dunes were used to calculate bedload transport rates with dune tracking. The results of dune growth and decay and migration rate are shown to be very different for the various sections during the various floods, and these differences are related to differences in grain size of the bed and to differences in the distribution of discharge over the main channel and the floodplain. The relations are used to show that the growth and migration rate of dunes, and the calculated bedload transport rates during the rising stage of a flood wave can be predicted from the mobility of the bed material with simple power relations.     

黄骅坳陷横向变换带的构造特征及成因

讨论了黄骅坳陷横向变换带的构造特征和成因。根据利用地震反射剖面对盆地构造几何学的研究，圈定了不同尺度的横向变换带，确定了伸展构造背景下的横向变换带是为了保持区域伸展应变调节构造变形的一种调节体系。这种伸展应变守恒是靠三维空间上断层位移沿走向的变化实现的。横向变换带的构造样式为横向地垒状凸起和鼻状凸起或鼻状背斜，并具伸展性质的正断层。横向凸起与非叠复的和叠复的分段断层系伴生及发育在断层位移最小处等事实表明，横向凸起或横向鼻状背斜是由于分段断层系位移沿走向变化形成的。     

Modelling transverse dunes

Transverse dunes appear in regions of mainly unidirectional wind and high sand availability. A dune model is extended to two‐dimensional calculation of the shear stress. It is applied to simulate dynamics and morphology of three‐dimensional transverse dunes. In the simulations they seem to reach translational invariance and do not stop growing. Hence, simulations of two‐dimensional dune ?elds have been performed. Characteristic laws were found for the time evolution of transverse dunes. Bagnold's law of the dune velocity is modi?ed and reproduced. The interaction between transverse dunes led to the interesting conclusion that small dunes can travel over bigger ones. Copyright © 2004 John Wiley & Sons, Ltd.     

Geospatial analysis of a coastal sand dune field evolution: Jockey's Ridge, North Carolina

Preservation and effective management of highly dynamic coastal features located in areas under development pressures requires in-depth understanding of their evolution. Modern geospatial technologies such as lidar, real time kinematic GPS, and three-dimensional GIS provide tools for efficient acquisition of high resolution data, geospatial analysis, feature extraction, and quantification of change. These techniques were applied to the Jockey's Ridge, North Carolina, the largest active dune field on the east coast of the United States, with the goal to quantify its deflation and rapid horizontal migration. Digitized contours, photogrammetric, lidar and GPS point data were used to compute a multitemporal elevation model of the dune field capturing its evolution for the period of 1974– 2004. In addition, peak elevation data were available for 1915 and 1953. Analysis revealed possible rapid growth of the dune complex between 1915–1953, followed by a slower rate of deflation that continues today. The main dune peak grew from 20.1 m in 1915 to 41.8 m in 1953 and has since eroded to 21.9 m in 2004. Two of the smaller peaks within the dune complex have recently gained elevation, approaching the current height of the main dune. Steady annual rate of main peak elevation loss since 1953 suggests that increase in the number of visitors after the park was established in 1974 had little effect on the rate of dune deflation. Horizontal dune migration of 3–6 m/yr in southerly direction has carried the sand out of the park boundaries and threatened several houses. As a result, the south dune section was removed and the sand was placed at the northern end of the park to serve as a potential source. Sand fencing has been an effective management strategy for both slowing the dune migration and forcing growth in dune elevation. Understanding the causes of the current movements can point to potential solutions and suggest new perspectives on management of the dune as a tourist attraction and as a recreation site, while preserving its unique geomorphic character and dynamic behavior.     

唐古拉山侏罗系盖覆区空喀拉-温泉-澜沧江结合带鉴别标志

结合带局部地段被与结合带演化密切伴生的各类盆地盖覆是各造山带中的一种普遍现象 ,因而初步将盖覆结合带的盆地划分为二类 :一是以边缘前陆盆地为代表的盖覆结合带而不破坏结合带的纵向盖覆性盆地 ;二是以横推断层盆地为代表的盖覆且破坏结合带的横向破坏性盆地。区内海相侏罗纪盆地实为与空喀拉温泉澜沧江结合带演化密切相关的盖覆结合带的陆内俯冲型边缘前陆盆地。深部地球物理探测资料证实了结合带在盖覆层之下仍存在 ,更说明结合带两侧板块构造建造对比明显有异 ,分属两类不同性质的大陆边缘 ,进而得出了结合带在研究区内潜伏于盖覆层之下的结论 ,从而建立了结合带存在的三方面的鉴别标志     

2013年初桂北寒潮天气过程分析

运用Micaps资料和地面观测实况资料,对2013年1月3-5日桂北寒潮天气过程进行了诊断分析,结果表明：（1）此次寒潮天气过程的特点是降温快、回温慢,且过程日平均气温低;（2）此次寒潮过程的冷空气堆积过程完成后,是由横槽转竖引导槽后冷空气大举南下入侵广西,造成的桂北寒潮天气;（3）中暖下冷的逆温层结维持时间与降雪冻雨时段对应较好,逆温层结被破坏后,桂北的持续雨雪天气也宣告结束,气温开始逐步回升;（4）中低层水汽辐合及较强的槽前正涡度平流也是产生降雪的必要条件之一。     

Variability in bedform morphology and kinematics with transport stage

Bedform geometry is widely recognized to be a function of transport stage. Bedform aspect ratio (height/length) increases with transport stage, reaches a maximum, then decreases as bedforms washout to a plane bed. Bedform migration rates are also linked to bedform geometry, in so far as smaller bedforms in coarser sediment tend to migrate faster than larger bedforms in finer sediment. However, how bedform morphology (height, length and shape) and kinematics (translation and deformation) change with transport stage and suspension have not been examined. A series of experiments is presented where initial flow depth and grain size were held constant and the transport stage was varied to produce bedload dominated, mixed‐load dominated and suspended‐load dominated conditions. The results show that the commonly observed pattern in bedform aspect ratio occurs because bedform height increases then decreases with transport stage, against a continuously increasing bedform length. Bedform size variability increased with transport stage, leading to less uniform bedform fields at higher transport stage. Total translation‐related and deformation‐related sediment fluxes all increased with transport stage. However, the relative contribution to the total flux changed. At the bedload dominated stage, translation‐related and deformation‐related flux contributed equally to the total flux. As the transport stage increased, the fraction of the total load contributed by translation increased and the fraction contributed by deformation declined because the bedforms got bigger and moved faster. At the suspended‐load dominated transport stage, the deformation flux increased and the translation flux decreased as a fraction of the total load, approaching one and zero, respectively, as bedforms washed out to a plane bed.     

Extensional fault and fold growth: Impact on accommodation evolution and sedimentary infill

Extensional faults and folds exert a fundamental control on the location, thickness and partitioning of sedimentary deposits on rift basins. The connection between the mode of extensional fault reactivation, resulting fault shape and extensional fold growth is well‐established. The impact of folding on accommodation evolution and growth package architecture, however, has received little attention; particularly the role‐played by fault‐perpendicular (transverse) folding. We study a multiphase rift basin with km‐scale fault displacements using a large high‐quality 3D seismic data set from the Fingerdjupet Subbasin in the southwestern Barents Sea. We link growth package architecture to timing and mode of fault reactivation. Dip linkage of deep and shallow fault segments resulted in ramp‐flat‐ramp fault geometry, above which fault‐parallel fault‐bend folds developed. The folds limited the accommodation near their causal faults, leading to deposition within a fault‐bend synclinal growth basin further into the hangingwall. Continued fold growth led to truncation of strata near the crest of the fault‐bend anticline before shortcut faulting bypassed the ramp‐flat‐ramp structure and ended folding. Accommodation along the fault‐parallel axis is controlled by the transverse folds, the location and size of which depends on the degree of linkage in the fault network and the accumulated displacement on causal faults. We construct transverse fold trajectories by tracing transverse fold hinges through space and time to highlight the positions of maximum and minimum accommodation and potential sediment entry points to hangingwall growth basins. The length and shape of the constructed trajectories relate to the displacement on their parent faults, duration of fault activity, timing of transverse basin infill, fault linkage and strain localization. We emphasize that the considerable wavelength, amplitudes and potential periclinal geometry of extensional folds make them viable targets for CO₂ storage or hydrocarbon exploration in rift basins.