层序-岩相古地理图及其编制

在中国岩相古地理研究历史简要回顾基础上,以层序地层学理论为指导,就如何编制层序-岩相古地理图进行了讨论,首先是编图单元的选择,一是以层序内的体系域为成图单元,二是以相关界面为成图单元.具体方法是在对所研究的层位进行精细的层序地层分析的基础上,进行层序对比,建立等时地层格架.在上述基础上系统编制不同层序内的各体系域或有关界面沉积时的古地理图.以此方法所编制的层序-岩相古地理图具有重要的理论和现实意义,主要表现为更具有等时性、成因连续性和实用性,能更好地反映一个地区在统一地质作用场中的各种地质信息和综合效应;可以揭示出一些新的地质现象,对于覆盖区相带展布及变化具更合理的预测性.进而以中国南方二叠纪为例,在层序划分、对比的基础上,系统编制了一个完整的海平面变化旋回条件下的层序-岩相古地理图,并描述了其平面展布特点.     

Virtual Huanghe River System： Framework and Technology

1 Introduction Huanghe (Yellow) River basin is located in 32°–42°N, 96°–119°E. The area of the catchment is more than 752,000km2. The river is 5464km long with a drop in elevation of 4830m. Among the whole area, the moun- tainous and stone area accounts for 29%, loess and hills area 46%, sandy area 11% and plain area 14%, respec- tively. Different natural landscapes exist in this area. The Huanghe River flows through the Loess Plateau, where the soil is eroded seriously (Wang, 2002;…     

图形软件在编辑出版专题地图中的应用研究

计算机制图(CAC)和电子出版系统的普及和推广,从根本上改变了传统的地图生产工艺。本文结合制图实践,讨论了应用Coreldraw图形软件编辑出版专题地图的适应性、系统条件和工艺流程,并总结了一些制图经验和应该注意的若干问题。     

重力插值方法研究

为了根据离散观测数据构制连续空间重力变化图像，分析和讨论了３种数值插值方法，计算结果表明多面函数方法插值精度最高。由于逐步回归分析筛选核函数中心点的计算繁琐，文中提出根据分形理论和Ｓｈａｎｎｏｎ取样定理来确定核函数中心点。对滇西试验场进行模拟试算，插值精度可达到４～５（１０－８ｍｓ－２）。     

APPLICATION OF MAP AND FILE INFORMATIONVISUALIZATION SYSTEM TO COMPREHENSIVEDIVISION OF NATURAL DISASTERS- Takingthe ChangjiangValleg as an Example

In recent years，scholars at home and abroad have method，and that vanous disasters would be analyzed assynthetically studied natural dlsaste‘theoretically and an Integral．SHI Peilun（1991）putforwad a scientificmethodologlcally，as well as its cases analys。s（CND，term—regional disaster system，which Indicates that1987； MA et al，1990； MARBLE，1990； NE et al，the situation of a disaster（calamity loss）results from1999； PATAK et al，1982； SHI，1991；VAN et al，h…     

Optimization of grid-drilling using computer simulation

A computer simulation method has been developed to find efficient drilling grids for mineral deposits. A well-known ore deposit is used as a model to develop an efficient pattern for undiscovered ore bodies in the same area or in other prospects where similar geometry is suspected. The model for this study is the Austinville, Virginia deposit, a Mississippi Valley-type deposit composed of 17 ore bodies totaling 34 million short tons (30 million metric tons). The method employs a computer program that simulates drilling the model deposit with different patterns, including various levels of follow-up drilling. Follow-up holes are drilled in fences at one half the original spacing around holes in the grid that show ore-grade mineralization. Each pattern is drilled 100 times from random starting locations to provide a range of outcomes of drilling, including the best, worst, and most likely. For this study, patterns of 100 drill holes were composed of 10 fences spaced 1000–5000 feet (305–1524 m) apart, each with 10 holes spaced 200–1000 feet (61–305 m) apart. In all, 25 grids were used with zero to three levels of follow-up drilling. The 600/2000 grid, with drill holes spaced 600 feet (183 m) apart in fences spaced 2000 feet (610 m) apart, was compared with the 200/5000 grid because they represented contrasting outcomes. The 600/2000 grid penetrated many ore bodies consistently but with few multiple hits to individual ore bodies; whereas the 200/5000 grid inconsistently penetrated few ore bodies with many multiple hits. The 600/2000 grid was more efficient than the 200/5000 grid at hitting large ore bodies of 1,000,000 short tons or greater (900,000 metric tons or greater) and was made more effective by adding one cycle of follow-up drilling. The 600/2000 grid had a 97% chance of hitting one or more large ore bodies with at least one drill hole per ore body, and the 200/5000 grid had a 64% chance. Once hit, there was an 82% chance that the largest ore body would be penetrated by three or more holes when using the 600/2000 grid and an 88% chance using the 200/5000 grid.     

An operational multiscale system for hazards prediction, mapping, and response

By definition, a crisis is a situation that requires assistance to be managed. Hence, response to a crisis involves the merging of local and non-local emergency response personnel. In this situation, it is critical that each participant: (1) know the roles and responsibilities of each of the other participants; (2) know the capabilities of each of the participants; and (3) have a common basis for action. For many types of natural disasters, this entails having a common operational picture of the unfolding events, including detailed information on the weather, both current and forecasted, that may impact on either the emergency itself or on response activities. The Consequences Assessment Tool Set (CATS) is a comprehensive package of hazard prediction models and casualty and damage assessment tools that provides a linkage between a modeled or observed effect and the attendant consequences for populations, infrastructure, and resources, and, hence, provides the common operational picture for emergency response. The Operational Multiscale Environment model with Grid Adaptivity (OMEGA) is an atmospheric simulation system that links the latest methods in computational fluid dynamics and high-resolution gridding technologies with numerical weather prediction to provide specific weather analysis and forecast capability that can be merged into the geographic information system framework of CATS. This paper documents the problem of emergency response as an end-to-end system and presents the integrated CATS–OMEGA system as a prototype of such a system that has been used successfully in a number of different situations.     

Flood hazard delineation combining geomorphological and hydrological methods: an example in the Northern Iberian Peninsula

Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km² of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph) in the Sarria River basin (155 km², NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number) by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling (one-phase, one-dimensional and steady flow) in a 4 km² urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both methods. Originally presented at the Sixth International Conference on Geomorphology.     

The Amphipod Community as a Bioindicator in Algeciras Bay (Southern Iberian Peninsula) Based on a Spatio-Temporal Distribution

Abstract. The amphipod population associated with Bugula neritina (L.), a verycommon bryozoan species in Algeciras Bay (Strait of Gibraltar), was studied on a spatio-temporal scale, in order to define its role as a bioindicator. Samples were collected in December, March, June and September along a transect running from the external to the internal sampling stations.
Fifty-three species belonging to 22 families were identified; the most abundant species were Jassa marmorata H olmes , Ischyrocerus inexpectatus (R uffo ) and Phtisica marina S labber .
The spatial evolution of the amphipod community reflected the physico-chemical conditions of Algeciras Bay, yielding a clear gradient from the outer to the inner stations. The stations located at the mouth of the bay, characterised by high hydrodynamism and low sedimentation, had a higher diversity and species richness than the inner stations with low water movement and higher sedimentation. Eight species preferred for the outer stations, while another nine species were typical of the inner harbours.
The most notable aspect of the seasonal evolution was the increased dominance of the tube-builder and deposit-suspension feeder Jassa marmorota .
Structural and ordination analyses corroborate the outer-inner gradient in the bay and illustrate the importance of hydrodynamic forces and sedimentation in the amphipod community.     

Bathymetry of the Tonga Trench and Forearc: a map series

Four new bathymetric maps of the Tonga Trench and forearc between 14 °S and 27 °S display the important morphologic and structural features of this dynamic convergent margin. The maps document a number of important geologic features of the margin. Major normal faults and fault lineaments on the Tonga platform can be traced along and across the upper trench slope. Numerous submarine canyons incised in the landward slope of the trench mark the pathways of sediment transport from the platform to mid- and lower-slope basins. Discontinuities in the trench axis and changes in the morphology of the landward slope can be clearly documented and may be associated with the passage and subduction of the Louisville Ridge and other structures on the subducting Pacific Plate. Changes in the morphology of the forearc as convergence changes from normal in the south to highly-oblique in the north are clearly documented. The bathymetric compilations, gridded at 500- and 200-m resolutions and extending along 500 km of the landward trench slope and axis, provide complete coverage of the outer forearc from the latitude of the Louisville Ridge-Tonga Trench collision to the northern terminus of the Tonga Ridge. These maps should serve as a valuable reference for other sea-going programs in the region, particularly the Ocean Drilling Program (ODP) and the National Science Foundation MARGINS initiative.