吉尼系数的计算及正态分布的吉尼系数

本文给出了吉尼系数的一般计算公式 ,推导出正态分布的吉尼系数渐进无偏估计 ,并以实例对比了传统的吉尼系数的算法——万分法与本文中提出的估计方法。     

海水中液-固界面的台阶型动力学曲线 Ⅰ.动力学曲线之台阶的消长和变化规律

对海水中Zn(Ⅱ),Ca(Ⅱ),Cd(Ⅱ)与高岭石、伊利石和蒙脱石等粘土矿物;无定形水合氧化铁、α-FeOOH等铁的水合氧化物;δ-MaO_2,γ-MnOOH,水锰矿等锰的水合氧化物等30个左右实验体系的液-固界面台阶型动力学曲线进行了系统的实验测定和全面的条件研究。在实验测定上提出两种方法、互为校核。对动力学曲线之台阶的消长和变化规律作了系统研究,确定主要影响因素是:金属离子初始浓度、固体交换剂量、体系的pH值和温度,以及搅拌速度等。     

Sediment movement under unidirectional flows: an assessment of empirical threshold curves

A selection of threshold data sets from previous investigations is used to re-examine, selectively, some of the empirical curves that are most commonly used for the prediction of sediment threshold. Simple analytical formulae are derived describing single line curves for mean threshold values and envelopes for the initial movement of discrete particles and the commencement of mass sediment transport phases of the critical condition.The complexity of factors governing the prevailing conditions at threshold, together with the randomness of events, limits deterministic solutions; however, the curves provide an approach that can be used readily in practical applications. In contrast, the envelope presentation is more of a stochastic approach to the definition of threshold. It recognises that there is no definitive threshold condition under which a particular particle size can be displaced, but rather that a range of threshold values exist.The empirical threshold relationships were derived on the basis of a relatively large amount of data. However, the sources utilised have interpreted the ‘critical condition’ in various ways, implying that the formulae must be treated with caution in applications.     

PLATEAU TYPE E(%)-pH CURVES OF INTERFACIAL EXCHANGE BETWEEN LIQUID AND SOLID IN SEAWATER

A study on the curves of the exchange ratio E(%)-pH on the liquid-solid interface of the systems Zn(II) with clay minerals (Kaolinite , illite and montmorillonite), Zn(II) with hydrous ferric oxides (amorphous ferric oxide, goethite and hematite). Zn(II) with hydrous manganese oxide (y-MnOOH, manganite and 5-MnO2) etc . in seawater resulted in the discovery of new plateau type exchange ratio ?%)-pH curves not yet reported in literature. The two factors that decide the growth , decline and the change of the " plateau type " curve are : (1) the inherent characteristics of systems , which can be explained by the exchange constants i(i=1 ,2 , 3 . etc .) of interfacial stepwise ion / coordination particle exchange between liquid and solid ; and (2)The theory of interfacial stepwise ion/coordination(the amount of solid exchange reagent)particle exchange in seawater was applied to explain the experimental results of the above study and a general formula was derived for the plateau type exchange ratio E(%)-pH c     

基于非等间距模型的建筑物沉降预测方法研究

该文基于实测资料进行建筑物沉降预测。在灰色模型和泊松曲线模型理论的基础上,引入对非等间距数列进行变换处理的方法,从而建立了非等间距预测模型。结合建筑物沉降监测资料进行分析比较,结果表明,两种预测方法均能较好地反映建筑物的沉降趋势。     

水平井含水率上升影响因素

利用塔里木油田塔中4油田(TZ4)底水油藏相关的地质、流体数据建立数值模型。在所建模型的基础上,应用数值模拟计算的累积产油、产水和产液量回归俞启泰水驱特征曲线,以反映水平井见水特征的参数b。以参数b为研究对象,采用正交试验的方法研究不同因素对b值的影响,筛选影响水平井见水特征的主要因素,认为原油粘度、油层厚度、非均质性及水平井水平段在油藏中的位置是影响水平井含水上升趋势的主要指标。最后建立主要因素与b值的关系式,结合俞启泰曲线b值图版,提出预测水平井见水规律的公式——图版法(F-b法)。应用F-b法对塔里木水平井含水率进行预测,并与其他相关方法及实际生产数据对比,认为F-b法可作为预测塔里木油田水平井含水率、估算可采储量的一种有效方法。     

饱和软土压缩曲线的“反常”现象

饱和软土压缩试验时,经常出现压缩曲线“反常”、压缩系数“倒大”的现象。它是土的原始结构发生破坏前后的不同压缩性的客观反映。饱和软土的结构力很微弱,唯质量好的原状土才能见到这种“反常”。应从成孔、取样、测试及资料整理等多个环节保证其工程意义。     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.