利用Yabuki & Matsu'ura反演方法计算 2011年日本东北地区太平洋海域Mw9.0级地震同震滑动分布

Yabuki & Matsu'ura反演方法是利用ABIC最佳模型参数选取方法和平滑的滑动分布作为约束条件,由形变观测数据计算发震断层滑动分布.本文基于日本列岛同震GPS观测数据和发震断层曲面构造模型,利用Yabuki & Matsu'ura反演方法计算2011年日本东北地区太平洋海域M_w9.0级地震的发震断层同震滑动分布.反演结果表明,断层面上的最大滑动量为35 m,较大滑动分布在浅于30 km的震源中心上部,最大破裂集中在20 km深度的地方.其地震矩约为3.63×10²²N·m,对应的矩震级为M_w9.0.模拟结果显示Yabuki & Matsu'ura反演方法更适用于倾角低于40°的断层模型反演.最后,本文基于上述方法获得的发震断层滑动模型,利用地球体位错理论正演计算该地震在中国及其邻区产生的远场形变,正演计算结果基本可以解释由中国GPS陆态网络观测到的同震形变.     

近地表密度估计的重力贝叶斯分析方法及在云南地区的应用

基于布格重力异常相对于地形起伏光滑分布的约束条件,从一维自由空气重力异常数据出发,采用贝叶斯方法估算近地表岩石密度,同时采用三次B样条函数拟合布格重力异常,获取光滑分布的布格重力异常.数据拟合和光滑约束之间的权重采用Akaike贝叶斯准则(ABIC准则)自动确定.均匀剖分模型和不均匀剖分模型数据试验都验证了该方法的有效性.相关参数评价表明,足够多的样条系数可以提高估计结果的准确性,样条系数的个数接近测点数时可获得较稳定的估计结果.增大异常的噪声水平时,ABIC准则可有效地自动增大先验光滑约束的权重.云南地区两条重力剖面应用结果表明,剖面沿线的近地表密度值起伏变化明显(达2.45~2.8g·cm^-3),前寒武纪和古生代地层密度相对较高(主要为2.53~2.75g·cm^-3),而中生代密度较低(2.45~2.73g·cm^-3);本文估计的近地表密度结果与区域物性资料及地表地质特征较吻合;估计的剖面布格重力异常具有光滑性;红河断裂两侧近地表密度差异较大,可达0.4g·cm^-3.本文获得的两条剖面近地表密度结构和布格重力异常为该区深部结构与构造研究提供更可靠的重力基础数据.     

Present-day Upper-crustal Strain Rate Field in Southeastern Tibet and its Geodynamic Implications: Constraints from GPS Measurements with ABIC Method

The Earth’s surface kinematics and deformation are fundamental to understanding crustal evolution. An effective research approach is to estimate regional motion field and deformation fields based on modern geodetic networks. If the discrete observed velocity field is obtained, the velocity related fields, such as dilatation rate and maximum shear strain rate, can be estimated by applying varied mathematical approaches. This study applied Akaike''s Bayesian Information Criterion (ABIC) method to calculate strain rate fields constrained by GPS observations in the southeast Tibetan Plateau. Comparison with results derived from other three methods revealed that our ABIC-derived strain rate fields were more precise. The maximum shear strain rate highlighted the Xianshuihe–Xiaojiang fault system as the main boundary for the outward migration of material in southeastern Tibet, indicating rotation of eastern Tibet material around the eastern Himalaya rather than whole extrusion along a fixed channel. Additionally, distinct dilatation rate patterns in the northeast and southwest regions of the fault system were observed. The northeast region, represented by the Longmenshan area, exhibited negative dilatational anomalies; while the southwest region, represented by the Jinsha River area north of 29°N, displayed positive dilatational anomalies. This indicates compression in the former and extension in the latter. Combined with deep geophysical observations, we believe that the upper and lower crusts of the Jinsha River area north of 29°N are in an entire expanding state, probably caused by the escape-drag effect of material. The presence of a large, low-viscosity region south of 29°N may not enable the entire escape of the crust, but instead result in a differential escape of the lower crust faster than the upper crust.     

利用1-HzGPS波形数据反演2011年日本北大地震震源破裂过程

利用1-Hz GPS数据反演2011年3月日本东北大地震的时空破裂过程,通过理论波形图与观测波形图的拟合,以及ABIC准则的判定,反演得到滑移分布的稳定估计.结果表明:破裂集中在震源附近,并在震中以下30 km处达到最大位错量,约72 m,在岩手和福岛靠近海岸线处有两个较小的破裂区,断层的南半段破裂很小,同时也是余震最为密集的地方.整个破裂过程由3个破裂阶段组成,发震后断层从震源向周围缓慢破裂,在50～60 s破裂延伸至地表(海沟);60～90 s在震中下方迅速发生强烈破裂,形成了最大位错区,这一阶段主要是倾向上的双边破裂;90～120 s在断层最北西处和断层南半段发生较小破裂,整个破裂过程持续大约120 s.反演得到的地震矩为3.8×1022 Nm,相应的矩震级为MW 9.0.