First VLTI observations of Mira stars

We present first observations of Mira stars obtained at the Very Large Telescope Interferometer (VLTI) at 2 microns, equipped with the VINCI instrument, using different baselines with both the test siderostats and the 8.2 m unit telescopes. These observations, collected in the course of the VLTI commissining program, have targeted so far about sixty cool giant stars. In this talk, we list and describe the measurements obtained for 14 Mira stars, many of them representing first-time determinations of the visibility. In particular, we devote special attention to a study of Mira itself, for which very accurate determinations of the visibility at several baseline lenghts and orientations could be obtained. We find that a two-component model is more consistent with the data than a single stellar disc. Further observations are needed for a better understanding of this source. The VLTI will constitute an ideal instrument for such studies in the future. In particular it will permit detailed investigations of southern AGB stars, such as accurate measurements of surface structureparameters (diameters, diameter variations, asymmetries, center-to-limbvariations, special features like hot spots) and of circumstellar envelopes. This revised version was published online in July 2006 with corrections to the Cover Date.     

Astronomical Image Co-adding Method based on Wide-field Image Deconvolution

Due to the atmospheric turbulence, the static aberration, tracking and pointing errors of telescopes, the point spread functions (PSFs) in different fields of view are different. Meanwhile, there are different PSFs in the images obtained by different telescopes. The quality of co-adding image is limited by the image with the poorest quality, and finally the resolution and sensitivity of the quad-channel telescope will also be affected. Dividing the image into some regions with the same type of PSF, and deconvolving these regions can improve the quality of the co-adding image. According to this theory, an image restoration algorithm based on the PSF clustering is proposed. Firstly, this paper makes the PSF clustering analysis by using Self-Organizing Maps, and makes the image segmentation based on the result of the PSF clustering analysis, then using the clustered PSFs to make deconvolutions on the sub-images. Then, the restored sub-images after deconvolution are joined together. Finally, by through the image registration and co-adding, the image with a high signal to noise ratio can be obtained. The result shows that the signal to noise ratio of the astronomical images are improved with our method, and the detection capability on faint stars is also improved.     

A new technique for determining the surface level of salt marshes and other uncompacted sedimentary environments

The method described involves the use of an electro-optical distance measurer mounted on a theodolite. Observations are taken onto a series of acrylic reflectors, aligned at right angles to the line of sight, and slope distances and vertical and horizontal angles are recorded. From these data it is possible to obtain surface heights to an accuracy of ±0·5 cm at 200 m and to avoid any direct disturbance of the site under investigation.     

Giant Vibrations in Dip

This work reports the discovery of solar-type oscillations in thegiant star Hydrae.     

1.2米地平式望远镜指向模型的研究 (1.全天指向模型的建立)

介绍了云南天文台1.2米地平式望远镜用于天文观测和图像采集处理的方法,建立了新的、独特的全天指向模型,大大提高了该望远镜的指向精度,达到1″,并在多年的实际应用中得到验证。     

High-resolution bispectrum speckle interferometry and two-dimensional radiative transfer modeling of the Red Rectangle

We present the first diffraction-limited K-band image of the Red Rectangle with 76 mas resolution, an H-band image with 75 mas resolution, and an RG 715 filter image ( 800 nm wavelength) with 78 mas resolution (corresponding to 25 AU for a distance of 330 pc). The H and K images were reconstructed from 6 m telescope speckle data and the RG 715 image from 2.2 m telescope data using the speckle masking bispectrum method. At all wavelengths the images show a compact, highly symmetric bipolar nebula, suggesting a toroidal density distribution of the circumstellar material. No direct light from the central binary can be seen as it is obscured by a dust disk or circumbinary torus. Our first high-resolution H−K color image of the nebula shows a broad red plateau of H−K≈ 2^m in the bright inner regions.The optical and near-infrared images and the available photometric continuum observations in a wide range of ultraviolet to centimeter wavelengths enabled us to model the Red Rectangle in detail using a two-dimensional radiative transfer code. Our model matches both the high-resolution images and the spectral energy distribution of this object very well, making the following picture much more certain. The central close binary system with a total luminosity of 3000 L is embedded in a very dense, compact circumbinary torus which has an average number density n_H ≈5×10¹² cm⁻³, an outer radius of the dense inner region of R≈30 AU (91 mas), and a ρ∝r⁻² density distribution. The full opening angle of the bipolar outflow cavities in our model is 70°. By comparing the observed and theoretical images, we derived an inclination angle of the torus to the line of sight of 7°±1°.The radiative transfer calculations show that the dust properties in the Red Rectangle are spatially inhomogeneous. The modeling confirms that the idea of large grains in the long-lived disk around the Red Rectangle (Jura et al., 1997 [ApJ, 474, 741]) is quantitatively consistent with the observations. In our models, unusually large, approximately millimeter-sized grains dominate the emission of the compact, massive torus. Models with smaller average grain sizes can possibly be found in future studies, for instance, if it turns out that the radio spectrum is not mainly caused by continuum dust emission. Therefore, the large grains suggested by our models require further confirmation by both new observations and radiative transfer calculations. Assuming a dust-to-gas ratio ρ_d/ρ_g of 0.005, the dense torus mass is 0.25 M. The model gives a lower limit of 0.0018 M, for the mass of the large particles, which produce a gray extinction of A≈ 28^m, towards the center. A much smaller mass of submicron-sized dust grains is presumably located in the polar outflow cavities, their conical surface layers, and in the outer low-density parts of the torus (where ρ∝r⁻⁴, in the region of 30 AUr 2000 AU corresponding to 0.^′′09–6^′′).     

Low-cost high performance distributed data storage for multi-channel observations

The New Vacuum Solar Telescope (NVST) is a 1-m solar telescope that aims to observe the fine structures in both the photosphere and the chromosphere of the Sun. The observational data acquired simultaneously from one channel for the chromosphere and two channels for the photosphere bring great challenges to the data storage of NVST. The multi-channel instruments of NVST, including scientific cameras and multi-band spectrometers, generate at least 3 terabytes data per day and require high access performance while storing massive short-exposure images. It is worth studying and implementing a storage system for NVST which would balance the data availability, access performance and the cost of development. In this paper, we build a distributed data storage system (DDSS) for NVST and then deeply evaluate the availability of real-time data storage on a distributed computing environment. The experimental results show that two factors, i.e., the number of concurrent read/write and the file size, are critically important for improving the performance of data access on a distributed environment. Referring to these two factors, three strategies for storing FITS files are presented and implemented to ensure the access performance of the DDSS under conditions of multi-host write and read simultaneously. The real applications of the DDSS proves that the system is capable of meeting the requirements of NVST real-time high performance observational data storage. Our study on the DDSS is the first attempt for modern astronomical telescope systems to store real-time observational data on a low-cost distributed system. The research results and corresponding techniques of the DDSS provide a new option for designing real-time massive astronomical data storage system and will be a reference for future astronomical data storage.     

Scalable desktop visualisation of very large radio astronomy data cubes

Observation data from radio telescopes is typically stored in three (or higher) dimensional data cubes, the resolution, coverage and size of which continues to grow as ever larger radio telescopes come online. The Square Kilometre Array, tabled to be the largest radio telescope in the world, will generate multi-terabyte data cubes – several orders of magnitude larger than the current norm. Despite this imminent data deluge, scalable approaches to file access in Astronomical visualisation software are rare: most current software packages cannot read astronomical data cubes that do not fit into computer system memory, or else provide access only at a serious performance cost. In addition, there is little support for interactive exploration of 3D data.We describe a scalable, hierarchical approach to 3D visualisation of very large spectral data cubes to enable rapid visualisation of large data files on standard desktop hardware. Our hierarchical approach, embodied in the AstroVis prototype, aims to provide a means of viewing large datasets that do not fit into system memory. The focus is on rapid initial response: our system initially rapidly presents a reduced, coarse-grained 3D view of the data cube selected, which is gradually refined. The user may select sub-regions of the cube to be explored in more detail, or extracted for use in applications that do not support large files. We thus shift the focus from data analysis informed by narrow slices of detailed information, to analysis informed by overview information, with details on demand. Our hierarchical solution to the rendering of large data cubes reduces the overall time to complete file reading, provides user feedback during file processing and is memory efficient. This solution does not require high performance computing hardware and can be implemented on any platform supporting the OpenGL rendering library.     

浅谈电影片名翻译技巧

电影不仅是作为一种艺术品,同时也是作为一种商品存在,而电影片名就好比是电影的一件外衣,因此,确切地翻译电影片名非常重要。电影片名的翻译技巧有很多,同时影响电影片名的翻译的因素也有很多。因此,在翻译电影片名时要从各方面因素考虑,从而选择恰当的翻译技巧,使得译名不仅能够从意义上忠实于源名,涵盖电影的内容,同时在形式上做到简练并具有吸引力。     

基于岭估计的快速静态精密单点定位研究

精密单点定位可以实现厘米级的定位精度,但其实时应用受到模糊度收敛时间的限制,模糊度收敛一般需要30分钟甚至更长的时间.基于相位历元间差分技术,可以避免模糊度的求解,但求解的参数为历元间坐标差.在相位历元间差分技术基础之上,推导了无模糊度模型的快速静态单点定位模型,并通过岭估计理论来进行参数的求解,两个以上历元就可以解算得到位置参数,从而实现静态状态下单点的快速定位,克服了模糊度收敛时间的局限,并讨论了不同坐标初值情况下估计值的精度.